rendered paste body## Booting image at 80000000 ...
Image Name: Angstrom/2.6.24+2.6.25rc8-git200
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1451712 Bytes = 1.4 MB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
OK
Starting kernel ...
Linux version 2.6.25-rc8-omap1 (sakoman@tera) (gcc version 4.1.2) #1 Wed Apr 9 10:45:17 PDT 2008
CPU: ARMv7 Processor [411fc082] revision 2 (ARMv7), cr=00c5387f
Machine: OMAP3 EVM board
Memory policy: ECC disabled, Data cache writeback
OMAP3430 ES2.2
SRAM: Mapped pa 0x40200000 to va 0xd7000000 size: 0x100000
CPU0: D VIPT write-through cache
CPU0: cache: 768 bytes, associativity 1, 8 byte lines, 64 sets
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512
Kernel command line: mem=128M console=ttyS0,115200n8 noinitrd root=/dev/mtdblock4 rw rootfstype=jffs2
Clocking rate (Crystal/DPLL/ARM core): 26.0/332/500 MHz
GPMC revision 5.0
IRQ: Found an INTC at 0xd8200000 (revision 4.0) with 96 interrupts
Total of 96 interrupts on 1 active controller
OMAP34xx GPIO hardware version 2.5
PID hash table entries: 512 (order: 9, 2048 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 128MB = 128MB total
Memory: 126848KB available (2680K code, 207K data, 104K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 236 bytes
NET: Registered protocol family 16
OMAP DMA hardware revision 4.0
Initializing OMAP McBSP system
USB: No board-specific platform config found
i2c_omap i2c_omap.1: bus 1 rev3.12 at 2600 kHz
i2c_omap i2c_omap.2: bus 2 rev3.12 at 100 kHz
i2c_omap i2c_omap.3: bus 3 rev3.12 at 400 kHz
TWL4030: TRY attach Slave TWL4030-ID0 on Adapter OMAP I2C adapter [1]
TWL4030: TRY attach Slave TWL4030-ID1 on Adapter OMAP I2C adapter [1]
TWL4030: TRY attach Slave TWL4030-ID2 on Adapter OMAP I2C adapter [1]
TWL4030: TRY attach Slave TWL4030-ID3 on Adapter OMAP I2C adapter [1]
<6>TWL4030: Driver registration complete.
Initialized TWL4030 USB module<6>usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
serial8250.0: ttyS0 at MMIO 0x4806a000 (irq = 72) is a ST16654
console [ttyS0] enabled
serial8250.0: ttyS1 at MMIO 0x4806c000 (irq = 73) is a ST16654
serial8250.0: ttyS2 at MMIO 0x49020000 (irq = 74) is a ST16654
brd: module loaded
loop: module loaded
i2c /dev entries driver
TWL4030 GPIO Demux: IRQ Range 376 to 386, Initialization Success
OMAP2 OneNAND driver initializing
omap2-onenand omap2-onenand: initializing on CS0, phys base 0x20000000, virtual base c8880000
Muxed OneNAND 128MB 1.8V 16-bit (0x30)
OneNAND version = 0x0221
Scanning device for bad blocks
Creating 5 MTD partitions on "omap2-onenand":
0x00000000-0x00080000 : "xloader"
0x00080000-0x00260000 : "uboot"
0x00260000-0x00280000 : "params"
0x00280000-0x00780000 : "linux"
0x00780000-0x08000000 : "jffs2"
usbmon: debugfs is not available
116x: driver isp116x-hcd, 03 Nov 2005
sl811: driver sl811-hcd, 19 May 2005
drivers/usb/host/r8a66597-hcd.c: driver r8a66597_hcd, 29 May 2007
OMAP Watchdog Timer Rev 0x31: initial timeout 60 sec
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 1
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 104K
******************************************
Starting System Init for OMAP3EVM 1.0
******************************************
Could not open keypad device
evdev open: No such device
JFFS2 notice: (233) check_node_data: wrong data CRC in data node at 0x012913a4: read 0x7d48271c, calculated 0xc3f5874b.
Using /root/evm/g_file_storage.ko
g_file_storage: disagrees about version of symbol struct_module
insmod: cannot insert `/root/evm/g_file_
Please press Enter to activate this console.
Processing /etc/profile... Done
[root@OMAP3EVM /]#