root@OpenWrt:~/log# logread
512 bytes, disk size 1GB.
Jan 1 00:00:20 (none) user.info kernel: /dev/scsi/host1/bus0/target0/lun3: I/O error: dev 08:40, sector 0
Jan 1 00:00:20 (none) user.warn kernel: I/O error: dev 08:40, sector 0
Jan 1 00:00:20 (none) user.warn kernel: unable to read partition table
Jan 1 00:00:20 (none) user.debug kernel: WARNING: USB Mass Storage data integrity not assured
Jan 1 00:00:20 (none) user.debug kernel: USB Mass Storage device found at 7
Jan 1 00:00:20 (none) user.info kernel: kjournald starting. Commit interval 5 seconds
Jan 1 00:00:20 (none) user.info kernel: EXT3 FS 2.4-0.9.19, 19 August 2002 on sd(8,1), internal journal
Jan 1 00:00:20 (none) user.info kernel: EXT3-fs: recovery complete.
Jan 1 00:00:20 (none) user.info kernel: EXT3-fs: mounted filesystem with ordered data mode.
Jan 1 00:00:20 (none) user.info kernel: uhci.c: USB Universal Host Controller Interface driver v1.1
Jan 1 00:00:20 (none) user.warn kernel: PCI: Enabling device 01:03.0 (0000 -> 0001)
Jan 1 00:00:20 (none) user.info kernel: uhci.c: USB UHCI at I/O 0x100, IRQ 2
Jan 1 00:00:20 (none) user.info kernel: usb.c: new USB bus registered, assigned bus number 2
Jan 1 00:00:20 (none) user.info kernel: hub.c: USB hub found
Jan 1 00:00:20 (none) user.info kernel: hub.c: 2 ports detected
Jan 1 00:00:20 (none) user.warn kernel: PCI: Enabling device 01:03.1 (0000 -> 0001)
Jan 1 00:00:20 (none) user.info kernel: uhci.c: USB UHCI at I/O 0x120, IRQ 2
Jan 1 00:00:20 (none) user.info kernel: usb.c: new USB bus registered, assigned bus number 3
Jan 1 00:00:20 (none) user.info kernel: hub.c: USB hub found
Jan 1 00:00:20 (none) user.info kernel: hub.c: 2 ports detected
Jan 1 00:00:20 (none) user.warn kernel: jffs2.bbc: SIZE compression mode activated.
Jan 1 00:00:20 (none) user.info : syslogd has already been started.
Jan 1 00:00:20 (none) user.info : klogd has already been started.
Jan 1 00:00:21 (none) user.info : /etc/rc.common: eval: 1: /sbin/hotplug2: not found
Jan 1 00:00:22 (none) user.info kernel: b44: eth0: Link is up at 100 Mbps, full duplex.
Jan 1 00:00:22 (none) user.info kernel: b44: eth0: Flow control is off for TX and off for RX.
Jan 1 00:00:23 (none) user.info kernel: device eth0.0 entered promiscuous mode
Jan 1 00:00:23 (none) user.info kernel: eth0.0: dev_set_promiscuity(master, 1)
Jan 1 00:00:23 (none) user.info kernel: device eth0 entered promiscuous mode
Jan 1 00:00:23 (none) user.info kernel: br-lan: port 1(eth0.0) entering learning state
Jan 1 00:00:23 (none) user.info kernel: br-lan: port 1(eth0.0) entering forwarding state
Jan 1 00:00:23 (none) user.info kernel: br-lan: topology change detected, propagating
Jan 1 00:00:23 (none) user.warn kernel: BFL_ENETADM not set in boardflags. Use force=1 to ignore.
Jan 1 00:00:24 (none) user.debug kernel: PCI: Setting latency timer of device 01:02.0 to 64
Jan 1 00:00:24 (none) user.warn kernel: PCI: Enabling device 01:02.0 (0004 -> 0006)
Jan 1 00:00:24 (none) user.warn kernel: wl0: Broadcom BCM4318 802.11 Wireless Controller 4.80.53.0
Jan 1 00:00:24 (none) user.info : Warning: loading wl will taint the kernel: no license
Jan 1 00:00:24 (none) user.info : See http://www.tux.org/lkml/#export-tainted for information about tainted modules
Jan 1 00:00:24 (none) user.debug kernel: eth0.1: add 01:00:5e:00:00:01 mcast address to master interface
Jan 1 00:00:25 (none) user.info kernel: CSLIP: code copyright 1989 Regents of the University of California
Jan 1 00:00:25 (none) user.info kernel: PPP generic driver version 2.4.2
Jan 1 00:00:25 (none) user.debug kernel: PCI: Setting latency timer of device 00:03.0 to 64
Jan 1 00:00:25 (none) user.info kernel: usb-ohci.c: USB OHCI at membase 0xb8003000, IRQ 6
Jan 1 00:00:25 (none) user.info kernel: usb-ohci.c: usb-00:03.0, PCI device 14e4:4715
Jan 1 00:00:26 (none) user.info kernel: usb.c: new USB bus registered, assigned bus number 4
Jan 1 00:00:26 (none) user.info kernel: hub.c: USB hub found
Jan 1 00:00:26 (none) user.info kernel: hub.c: 2 ports detected
Jan 1 00:00:26 (none) user.info kernel: usb.c: registered new driver usblp
Jan 1 00:00:26 (none) user.info kernel: printer.c: usblp0: USB Bidirectional printer dev 4 if 0 alt 0 proto 2 vid 0x04A9 pid 0x10C8
Jan 1 00:00:26 (none) user.info kernel: printer.c: v0.13: USB Printer Device Class driver
Jan 1 00:00:27 (none) user.info kernel: device wl0 entered promiscuous mode
Jan 1 00:00:27 (none) user.info kernel: wl0: attempt to add interface with same source address.
Jan 1 00:00:27 (none) user.info kernel: br-lan: port 2(wl0) entering learning state
Jan 1 00:00:27 (none) user.info kernel: br-lan: port 2(wl0) entering forwarding state
Jan 1 00:00:27 (none) user.info kernel: br-lan: topology change detected, propagating
Jan 1 00:00:30 (none) cron.notice crond[559]: crond 2.3.2 dillon, started, log level 8
Jan 1 00:00:30 (none) authpriv.info dropbear[570]: Running in background
Jan 1 00:00:34 (none) user.info : /etc/rc.common: /etc/rc.d/S90custom-user-startup: 17: /jffs/usr/sbin/p910nd: not found
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: started, version 2.39 cachesize 150
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: compile time options: IPv6 GNU-getopt ISC-leasefile no-DBus no-I18N TFTP
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: DHCP, IP range 192.168.1.100 -- 192.168.1.250, lease time 12h
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: using local addresses only for domain lan
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: reading /tmp/resolv.conf.auto
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: using nameserver 212.27.53.252#53
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: using nameserver 212.27.54.252#53
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: using local addresses only for domain lan
Jan 1 00:00:34 (none) daemon.info dnsmasq[600]: read /etc/hosts - 1 addresses
Jan 1 00:00:34 (none) daemon.err dnsmasq[600]: failed to read /etc/ethers:No such file or directory
Jan 1 00:00:35 (none) user.info : Testing USB Partition: /dev/scsi/host0/bus0/target0/lun0/part1 is mounted. e2fsck: Cannot continue, aborting.
Jan 1 00:00:40 (none) user.info : Mounting USB drive: Done.
Jan 1 00:01:20 (none) lpr.notice p9100d[580]: Connection from 192.168.1.141 port 49564 accepted
Jan 1 00:01:33 (none) authpriv.info dropbear[612]: Child connection from 192.168.1.141:49565
Jan 1 00:01:38 (none) authpriv.notice dropbear[612]: password auth succeeded for 'root' from 192.168.1.141:49565
Jan 1 00:05:32 (none) authpriv.info dropbear[612]: exit after auth (root): Exited normally
Jan 1 00:31:03 (none) authpriv.info dropbear[638]: Child connection from 192.168.1.141:49706
Jan 1 00:31:08 (none) authpriv.notice dropbear[638]: password auth succeeded for 'root' from 192.168.1.141:49706
root@OpenWrt:~/log#