rendered paste bodyCFE version 1.2.5 for WP54G (32bit,SP,LE,MIPS)
Build Date: Wed Aug 16 09:09:30 SGT 2006 (ttyaw@linux01)
Initializing Arena.
Initializing PCI. [normal]
PCI bus 0 slot 0/0: ADMtek ADM5120 Host Bridge (host bridge)
PCI bus 0 slot 2/0: Atheros AR5212 Wireless MiniPCI (ethernet network, rev 0x01)
Initializing Devices.
CPU type 0x1800B: 175MHz
Total memory: 0x1000000 bytes (16MB)
Total memory used by CFE: 0x80F83000 - 0x80FFFAE0 (510688)
Initialized Data: 0x80FBA824 - 0x80FBCA50 (8748)
BSS Area: 0x80FBCA50 - 0x80FBDAE0 (4240)
Local Heap: 0x80FBDAE0 - 0x80FFDAE0 (262144)
Stack Area: 0x80FFDAE0 - 0x80FFFAE0 (8192)
Text (code) segment: 0x80F83000 - 0x80FBA115 (225557)
Boot area (physical): 0x00F42000 - 0x00F82000
Relocation Factor: I:E1383000 - D:E1383000
Press Ctrl-C to cancel automatic startup
CFE> ifconfig eth0 -addr=192.168.0.10
Device eth0: hwaddr 02-10-18-58-36-10, ipaddr 192.168.0.10, mask not set
gateway not set, nameserver not set
*** command status = 0
CFE> load -tftp -raw -addr=0x80001000 -max=0x400000 192.168.0.50:openwrt-adm5120-wp54
g-wrt-ramfs.bin
Loader:raw Filesys:tftp Dev:eth0 File:192.168.0.50:openwrt-adm5120-wp54g-wrt-ramfs.bi
n Options:(null)
Loading: ....... 2315808 bytes read
Entry at 0x80001000
*** command status = 0
CFE> go
Closing network.
eth0: 4527 sent, 4525 received
Starting program at 0x80001000
LZMA loader for WP54G-WRT, Copyright (C) 2007 OpenWrt.org
decompressing kernel... done!
launching kernel...
Linux version 2.6.24.2 (yuhi@idared) (gcc version 4.1.2) #2 Fri Apr 4 19:26:56 CEST 2
008
console [early0] enabled
CPU revision is: 0001800b (MIPS 4Kc)
SoC : ADM5120 revision 8, running at 175MHz
Bootdev : NOR flash
Prom : Generic
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0 -> 4096
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0 -> 4096
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
Kernel command line: console=ttyS0,115200 rootfstype=squashfs,yaffs2,jffs2 init=/etc/
preinit
Primary instruction cache 8kB, VIPT, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes
Synthesized clear page handler (26 instructions).
Synthesized copy page handler (46 instructions).
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 12272k/16384k available (1892k kernel code, 4112k reserved, 343k data, 1620k
init, 0k highmem)
Mount-cache hash table entries: 512
adm5120: registered board 'Generic ADM5120 board'
adm5120: registered board 'Cellvision NFS-101U/101WU'
adm5120: registered board 'Cellvision CAS-861/861W'
adm5120: registered board 'Cellvision CAS-790'
adm5120: registered board 'Cellvision CAS-771/771W'
adm5120: registered board 'Cellvision CAS-700/700W'
adm5120: registered board 'Cellvision CAS-670/670W'
adm5120: registered board 'Cellvision CAS-630/630W'
adm5120: registered board 'Compex WPP54G'
adm5120: registered board 'Compex WPP54AG'
adm5120: registered board 'Compex WP54G-WRT'
adm5120: registered board 'Compex WP54G'
adm5120: registered board 'Compex WP54AG'
adm5120: registered board 'Compex NetPassage 28G'
adm5120: registered board 'Compex NetPassage 27G'
adm5120: registered board 'Edimax BR-6104WG/6114WG'
adm5120: registered board 'Edimax BR-6104K/6104KP'
adm5120: registered board 'Infineon EASY 83000 Reference Board'
adm5120: registered board 'Infineon EASY 5120-WVoIP Reference Board'
adm5120: registered board 'Infineon EASY 5120-RT Reference Board'
adm5120: registered board 'Infineon EASY 5120P-ATA Reference Board'
adm5120: registered board 'Mikrotik RouterBOARD 192'
adm5120: registered board 'Mikrotik RouterBOARD 153'
adm5120: registered board 'Mikrotik RouterBOARD 150'
adm5120: registered board 'Mikrotik RouterBOARD 133C'
adm5120: registered board 'Mikrotik RouterBOARD 133'
adm5120: registered board 'Mikrotik RouterBOARD 112'
adm5120: registered board 'Mikrotik RouterBOARD 111'
adm5120: registered board 'ZyXEL Prestige 335/335WT'
adm5120: registered board 'ZyXEL Prestige 334WT'
net_namespace: 64 bytes
NET: Registered protocol family 16
adm5120: setting up board 'Compex WP54G-WRT'
adm5120: system has PCI BIOS
registering PCI controller with io_map_base unset
PCI: Error while updating region 0000:00:02.0/0 (11400000 != 00000000)
PCI: mapping irq for 0000:00:02.0 pin:1, irq:14
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
yaffs Apr 4 2008 19:08:58 Installing.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: AMBA driver $Revision: 1.41 $
APB:UART0: ttyS0 at MMIO 0x12600000 (irq = 9) is a AMBA
console handover: boot [early0] -> real [ttyS0]
APB:UART1: ttyS1 at MMIO 0x12800000 (irq = 10) is a AMBA
ADM5120 built-in ethernet switch driver version 0.1.1
adm5120-flash.0: probing at 0x1FC00000, size:4096KiB, width:16 bits
adm5120-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
adm5120-flash.0: found at 0x1FC00000, size:4096KiB, width:16 bits
adm5120-flash.0: adding static partitions
Creating 3 MTD partitions on "adm5120-flash.0":
0x00000000-0x00050000 : "cfe"
0x00050000-0x003f0000 : "trx"
0x003f0000-0x00400000 : "nvram"
adm5120_wdt: Watchdog Timer version 0.1
nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
trxsplit: searching TRX header in 'cfe'
trxsplit: searching TRX header in 'trx'
trxsplit: TRX header found at 0x0
trxsplit: creating TRX partitions in 'trx' (31,1)
Creating 3 MTD partitions on "trx":
0x0000001c-0x000010b0 : "loader"
mtd: partition "loader" doesn't start on an erase block boundary -- force read-only
0x000010b0-0x000bf400 : "kernel"
mtd: partition "kernel" doesn't start on an erase block boundary -- force read-only
0x000bf400-0x003a0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=1F0000, len=1B0000
0x001f0000-0x003a0000 : "rootfs_data"
Freeing unused kernel memory: 1620k freed
Please be patient, while OpenWrt loads ...
Algorithmics/MIPS FPU Emulator v1.5
adm5120_wdt: enabling watchdog timer
br-lan: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.
device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0) entering forwarding state
Please press Enter to activate this console. br-lan: port 1(eth0) entering disabled s
tate
device eth0 left promiscuous mode
br-lan: port 1(eth0) entering disabled state
device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0) entering forwarding state
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PPP generic driver version 2.4.2
usbcore: registered new interface driver snd-usb-audio
Linux video capture interface: v2.00
usbcore: registered new interface driver gspca
/openwrt/test/build_dir/linux-adm5120_router_le/gspcav1-20071224/gspca_core.c: gspca
driver 01.00.20 registered
BusyBox v1.8.2 (2008-03-06 16:58:57 CET) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
KAMIKAZE (bleeding edge, r10730) -------------------
* 10 oz Vodka Shake well with ice and strain
* 10 oz Triple sec mixture into 10 shot glasses.
* 10 oz lime juice Salute!
---------------------------------------------------
root@OpenWrt:/#