usb 5-2: new high speed USB device using ehci_hcd and address 2
usb 5-2: configuration #1 chosen from 1 choice
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
Vendor: HL-DT-ST Model: DVDRRW GSA-2166D Rev: 1.01
Type: CD-ROM ANSI SCSI revision: 00
usb-storage: device scan complete
sr0: scsi3-mmc drive: 48x/48x writer dvd-ram cd/rw xa/form2 cdda tray
sr 0:0:0:0: Attached scsi CD-ROM sr0
sr 0:0:0:0: Attached scsi generic sg0 type 5
cdrom: This disc doesn't have any tracks I recognize!
printk: 22 messages suppressed.
TCP: Treason uncloaked! Peer 81.193.210.224:6881/49399 shrinks window 3907403590:3907404294. Repaired.
cdrom: This disc doesn't have any tracks I recognize!
uhci_hcd 0000:07:00.0: host system error, PCI problems?
uhci_hcd 0000:07:00.0: host controller process error, something bad happened!
ehci_hcd 0000:07:00.2: HC died; cleaning up
uhci_hcd 0000:07:00.0: host system error, PCI problems?
uhci_hcd 0000:07:00.0: host controller process error, something bad happened!
uhci_hcd 0000:07:00.0: host controller halted, very bad!
uhci_hcd 0000:07:00.0: HCRESET not completed yet!
uhci_hcd 0000:07:00.0: HC died; cleaning up
pccard: card ejected from slot 1
usb 5-2: USB disconnect, address 2
uhci_hcd 0000:07:00.0: remove, state 0
usb usb4: USB disconnect, address 1
uhci_hcd 0000:07:00.0: USB bus 4 deregistered
ACPI: PCI interrupt for device 0000:07:00.0 disabled
ehci_hcd 0000:07:00.2: remove, state 0
usb usb5: USB disconnect, address 1
ehci_hcd 0000:07:00.2: USB bus 5 deregistered
ACPI: PCI interrupt for device 0000:07:00.2 disabled
ieee1394: Node removed: ID:BUS[0-00:1023] GUID[400401012800c037]
ohci1394: fw-host0: Set PHY Reg timeout [0xffffffff/0x00004000/100]
ohci1394: fw-host0: Set PHY Reg timeout [0xffffffff/0x00004000/100]
ADDRCONF(NETDEV_UP): eth0: link is not ready
eth0: New link status: Connected (0001)
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
eth0: no IPv6 routers present
eth0: New link status: AP Out of Range (0004)
eth0: New link status: AP In Range (0005)
usb 2-1: new full speed USB device using uhci_hcd and address 2
usb 2-1: configuration #1 chosen from 1 choice
scsi1 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
Vendor: ST350063 Model: 0A Rev: 3.AA
Type: Direct-Access ANSI SCSI revision: 00
scsi 1:0:0:0: Attached scsi generic sg0 type 0
usb-storage: device scan complete
SCSI device sda: 976773168 512-byte hdwr sectors (500108 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 976773168 512-byte hdwr sectors (500108 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 1:0:0:0: Attached scsi disk sda
sda: Current: sense key: No Sense
Additional sense: No additional sense information
usb 2-1: reset full speed USB device using uhci_hcd and address 2
sda: Current: sense key: No Sense
Additional sense: No additional sense information
sda: Current: sense key: No Sense
Additional sense: No additional sense information
usb 2-1: reset full speed USB device using uhci_hcd and address 2