Something

usb 3-3: new high speed USB device using ehci_hcd and address 4
usb 3-3: new device found, idVendor=148f, idProduct=2573
usb 3-3: new device strings: Mfr=1, Product=2, SerialNumber=0
usb 3-3: Product: 802.11 bg WLAN
usb 3-3: Manufacturer: Ralink
usb 3-3: configuration #1 chosen from 1 choice
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - Antenna: 0x0002
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - NIC: 0xfff0
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - BBPtune: 0xff2d
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - BBPtune vgc: 0xff40
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - BBPtune r24: 0x8040
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - BBPtune r25: 0x5040
phy0 -> rt2500usb_validate_eeprom: EEPROM recovery - BBPtune r61: 0x6d60
phy0 -> rt2x00_set_chip: Info - Chipset detected - rt: 1201, rf: 0000, rev: 00000000.
wmaster0: Selected rate control algorithm 'simple'
usbcore: registered new interface driver rt2500usb
usbcore: registered new interface driver rt73usb
phy0 -> rt2500usb_set_state: Notice - Device failed to enter state 3, current device state: bbp 0 and rf 0.
phy0 -> rt2500usb_enable_radio: Error - Register initialization failed.
phy0 -> rt2x00mac_conf_tx: Info - Configured TX ring 0 - CWmin: 4, CWmax: 10, Aifs: 2.
phy0 -> rt2x00mac_conf_tx: Info - Configured TX ring 1 - CWmin: 4, CWmax: 10, Aifs: 2.
phy0 -> rt2x00mac_conf_tx: Info - Configured TX ring 7 - CWmin: 5, CWmax: 10, Aifs: 2.