rendered paste bodyehci_platform ehci_platform.16781: EHCI Host Controller
ehci_platform ehci_platform.16781: new USB bus registered, assigned bus number 2
ehci_platform ehci_platform.16781: irq 12, io mem 0x00000000
ehci_platform ehci_platform.16781: park 0
ehci_platform ehci_platform.16781: USB 0.0 initialized, EHCI 1.00, driver 10 Dec 2004
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
USB Universal Host Controller Interface driver v2.2
usbcore: registered new driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
MICON ctrl (C) BUFFALO INC. V.1.00 installed.
Kernel event proc (C) BUFFALO INC. V.1.00 installed.
MICON V2 (C) BUFFALO INC. V.1.00 installed.
NET: Registered protocol family 2
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Compressed image found at block 0
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
---- in Modified linuxrc ---
Mon Feb 11 18:35:21 JST 2008
err: >AnalyzeRecvPacket:This is invalid RespCode.(code=244)
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
linuxrc:choose operation (timeout 4[s])
1:RamRoot other:HddRoot ? -HddRoot-
*** not found /boot/rootfs_ok file in rootfs. ***
chars= 1
KERNEL:2006/12/5 22:22:58
HDD:2007/6/28 9:42:0
Bypassing CopyFromInitrdToHdd
checking local disk....
fsck 1.27 (8-Mar-2002)
e2fsck 1.27 (8-Mar-2002)
/dev/ls_disk1_1: clean, 21/74296 files, 24548/297171 blocks
done
XFS mounting filesystem sda2
Starting XFS recovery on filesystem: sda2 (dev: sda2)
Ending XFS recovery on filesystem: sda2 (dev: sda2)
VFS: Mounted root (xfs filesystem).
Trying to move old root to /initrd ... okay
Freeing init memory: 112K
INIT: version 2.86 booting
* udev requires a kernel >= 2.6.15, not started.
failed!
Setting parameters of disc: (none).
Activating swap:swapon on /dev/sda5
Adding 136512k swap on /dev/sda5. Priority:-1 extents:1
.
Setting the system clock again..
System Clock set. Local time: Mon Feb 11 18:35:31 UTC 2008.
Cleaning up ifupdown....
Loading device-mapper support.
Will now check all file systems.
fsck 1.40-WIP (14-Nov-2006)
Checking all file systems.
[/sbin/fsck.ext3 (1) -- /boot] fsck.ext3 -y -C0 /dev/sda1
e2fsck 1.40-WIP (14-Nov-2006)
/dev/sda1: clean, 21/74296 files, 24548/297171 blocks (check in 4 mounts)
Done checking file systems.
A log is being saved in /var/log/fsck/checkfs if that location is writable.
Setting kernel variables...done.
Will now mount local filesystems:mount: none already mounted or /dev/pts busy
mount: according to mtab, devpts is already mounted on /dev/pts
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
XFS mounting filesystem sda6
failed!
Will now activate swapfile swap:done.
Cleaning /tmp...done.
Setting up resolvconf...done.
Setting up networking....
* /etc/network/options is deprecated (see README.Debian of netbase).
Setting up IP spoofing protection...done (rp_filter).
Configuring network interfaces...There is already a pid file /var/run/dhclient.eth0.pid with pid 1073908416
Internet Systems Consortium DHCP Client V3.0.4
Copyright 2004-2006 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/
Listening on LPF/eth0/00:16:01:bc:62:5c
Sending on LPF/eth0/00:16:01:bc:62:5c
Sending on Socket/fallback
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 4
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 9
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 8
## Booting image at 00100000 ...
Image Name: Linux-2.6.12.6-arm1
Created: 2006-12-06 4:23:49 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1941956 Bytes = 1.9 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
OK
## Loading Ramdisk Image at 00800000 ...
Image Name: initrd
Created: 2006-12-27 21:19:31 UTC
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 4563515 Bytes = 4.4 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Starting kernel ...
arg:console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 BOOTVER=1.10
CONFIG_BUFFALO_PLATFORM CONFIG_BUFFALO_LINKSTATION_LSGL ---
Uncompressing Linux.............................................................................................................................. done, booting the kernel.
Linux version 2.6.12.6-arm1 (root@Desktop) (gcc version 3.4.4 (release) (CodeSourcery ARM 2005q3-2)) #77 Tue Dec 5 22:23:46 CST 2006
CPU: ARM926EJ-Sid(wb) [41069260] revision 0 (ARMv5TEJ)
CPU0: D VIVT write-back cache
CPU0: I cache: 32768 bytes, associativity 1, 32 byte lines, 1024 sets
CPU0: D cache: 32768 bytes, associativity 1, 32 byte lines, 1024 sets
Machine: MV-88fxx81
Using UBoot passing parameters structure
Sys Clk = 200000000, Tclk = 166664740
- Warning - This LSP release was tested only with U-Boot release 1.7.3
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists
Kernel command line: console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 BOOTVER=1.10
PID hash table entries: 1024 (order: 10, 16384 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 128MB 0MB 0MB 0MB = 128MB total
Memory: 110208KB available (3370K code, 570K data, 112K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
checking if image is initramfs...it isn't (no cpio magic); looks like an initrd
Freeing initrd memory: 15360K
NET: Registered protocol family 16
FLASH boardId = 12
Flash bankwidth 1, base ff800000, size 400000
BUFFALO LS_GL FLASH size 4096[KB]
Marvell Development Board (LSP Version 1.7.8_NAS)-- BUFFALO_BOARD_LS_GL
Detected Tclk 166664740 and SysClk 200000000
Marvell USB EHCI Host controller #0: c1702bc0
Marvell USB EHCI Host controller #1: c1702980
pexBarOverlapDetect: winNum 2 overlap current 0
mvPexInit:Warning :Bar 2 size is illigal
it will be disabled
please check Pex and CPU windows configuration
PCI: bus0: Fast back to back transfers enabled
PCI: bus1: Fast back to back transfers enabled
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
use IDMA acceleration in copy to/from user buffers. used channels 2 and 3
Done.
cesadev_init(c0011304)
mvCesaInit: sessions=640, queue=32, pSram=f0000000
Fast Floating Point Emulator V0.9 (c) Peter Teichmann.
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
SGI XFS with no debug enabled
Initializing Cryptographic API
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
No DHCPOFFERS received.
No working leases in persistent database - sleeping.
ttyS0 at MMIO 0x0 (irq = 3) is a 16550A
ttyS1 at MMIO 0x0 (irq = 4) is a 16550A
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
RAMDISK driver initialized: 3 RAM disks of 16384K size 1024 blocksize
loop: loaded (max 8 devices)
Marvell Gigabit Ethernet Driver 'egiga':
o Ethernet descriptors in DRAM
o DRAM SW cache-coherency
o Checksum offload enabled
o Loading network interface ** egiga_init_module (0)
'eth0'
Intergrated Sata device found
scsi0 : Marvell SCSI to SATA adapter
scsi1 : Marvell SCSI to SATA adapter
Vendor: SAMSUNG Model: HD501LJ Rev: CR10
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sda: 976773168 512-byte hdwr sectors (500108 Mdone.
....Bringing up static interface
Start services: micro_evtd
Starting portmap daemon....
Starting kernelmon:Initializing random number generator...done.
INIT: Entering runlevel: 2
Starting system log daemon: syslogd.
Starting kernel log daemon: klogd.
Starting portmap daemon...Already running..
Updating the operating system logo...done.
Exporting directories for NFS kernel daemon....
Starting NFS kernel daemon: nfsd mountd.
* Not starting internet superserver: no services enabled.
Starting Samba daemons: nmbd smbd.
Starting OpenBSD Secure Shell server: sshd.
Starting NFS common utilities: statd idmapd.
Starting periodic command scheduler: crond.
Running local boot scripts (/etc/rc.local).
BUFFALO INC. LinkStation series LS-GL(IESADA)
LS-GL7D6 login: