Someone

jens@bassegoej:~$ ivtvctl 
Usage:
  -d, --device <dev> use device <dev> instead of /dev/video0
  -h, --help         display this help message
  -K, --passthrough <mode>
                     set passthrough mode: 1 = on, 0 = off [IVTV_IOC_PASSTHROUGH]
  --get-yuv-mode     display the current yuv mode
  --set-yuv-mode [param],[param]
                     set the current yuv mode
     param:
       mode        =<#> yuv_mode 0=interlaced,1=progressive,2=auto
       threshold   =<#> if src_hight <= threshold treat as progressive
  --reset-ir         reset the infrared receiver [VIDIOC_INT_RESET]
  --version          shows the version number of this utility.
                     It should match the driver version.

Expert options:
  -D, --set-debug <level>
                     set the module debug variable
                      1: WARN   2: INFO  4: API   8: DMA
                     16: IOCTL 32: I2C  64: IRQ 128: DEC 256: YUV
  -E, --end-gop      capture last GOP [IVTV_IOC_S_GOP_END]
  -e, --get-debug    query the module debug variable
  -I, --list-gpio
                     show GPIO input/direction/output bits
  -i, --set-gpio [dir=<dir>,]val=<val>
                     set GPIO direction bits to <dir> and set output to <val>
  -k, --sync         test vsync's capabilities [IVTV_IOC_FRAMESYNC]
  -R, --list-registers chip=<chip>,min=<addr>,max=<addr>
                     dump registers from <min> to <max> [VIDIOC_INT_G_REGISTER]
                     <chip> is one of: saa711x, saa7127, saa717x, cx2584x, cx2341x
  -r, --set-register chip=<chip>,reg=<reg>,val=<val>
                     set register [VIDIOC_INT_S_REGISTER]
                     <chip> is one of: saa711x, saa7127, saa717x, cx2584x, cx2341x
  -v, --audio-route=input=<in>,output=<out>
                     set the audio input/output routing [VIDIOC_INT_S_AUDIO_ROUTING]