root@OpenWrt:~$ dmesg
CPU revision is: 00029006
Primary instruction cache 16kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 16kB, 2-way, linesize 16 bytes.
Linux version 2.4.30 (travis@localhost.localdomain) (gcc version 3.4.4 (OpenWrt-1.0)) #1 Wed Aug 8 08:21:33 CDT 2007
Setting the PFC value as 0x15
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
On node 0 totalpages: 8192
zone(0): 8192 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200
CPU: BCM4704 rev 9 at 264 MHz
Using 132.000 MHz high precision timer.
Calibrating delay loop... 263.78 BogoMIPS
Memory: 30436k/32768k available (1455k kernel code, 2332k reserved, 104k data, 80k init, 0k highmem)
Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
Checking for 'wait' instruction... unavailable.
POSIX conformance testing by UNIFIX
PCI: Fixing up bus 0
PCI: Fixing up bridge
PCI: Setting latency timer of device 01:00.0 to 64
PCI: Fixing up bus 1
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Registering mini_fo version $Id$
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB.
Squashfs 2.1-r2 (released 2004/12/15) (C) 2002-2004 Phillip Lougher
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0xb8000300 (irq = 3) is a 16550A
ttyS01 at 0xb8000400 (irq = 0) is a 16550A
b44.c:v0.93 (Mar, 2004)
PCI: Setting latency timer of device 00:01.0 to 64
eth0: Broadcom 47xx 10/100BaseT Ethernet 00:1b:fc:57:bb:7d
PCI: Setting latency timer of device 00:02.0 to 64
eth1: Broadcom 47xx 10/100BaseT Ethernet 40:10:18:00:00:2d
Physically mapped flash: Found an alias at 0x800000 for the chip at 0x0
Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0
Physically mapped flash: Found an alias at 0x1800000 for the chip at 0x0
Amd/Fujitsu Extended Query Table v1.3 at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling fast programming due to code brokenness.
Flash device: 0x800000 at 0x1c000000
bootloader size: 262144
Physically mapped flash: Filesystem type: squashfs, size=0x11e737
Creating 5 MTD partitions on "Physically mapped flash":
0x00000000-0x00040000 : "cfe"
0x00040000-0x007f0000 : "linux"
0x000be400-0x001e0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x007f0000-0x00800000 : "nvram"
0x001e0000-0x007f0000 : "OpenWrt"
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 4096)
ip_conntrack version 2.1 (5953 buckets, 5953 max) - 332 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 80k freed
Algorithmics/MIPS FPU Emulator v1.5
diag: Detected 'ASUS WL-500g Premium'
Probing device eth0: found!
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
jffs2.bbc: SIZE compression mode activated.
PCI: Setting latency timer of device 01:02.0 to 64
PCI: Enabling device 01:02.0 (0004 -> 0006)
eth2: Broadcom BCM4318 802.11 Wireless Controller 3.90.37.0
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.2
loop: loaded (max 8 devices)
BFL_ENETADM not set in boardflags. Use force=1 to ignore.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb.c: registered new driver usblp
printer.c: v0.13: USB Printer Device Class driver
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
PCI: Enabling device 01:03.2 (0000 -> 0002)
ehci_hcd 01:03.2: PCI device 1106:3104
ehci_hcd 01:03.2: irq 2, pci mem c01b8000
usb.c: new USB bus registered, assigned bus number 1
EHCI: Enabling VIA 6212 workarounds
ehci_hcd 01:03.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4
hub.c: USB hub found
hub.c: 4 ports detected
device eth0 entered promiscuous mode
hub.c: new USB device 01:03.2-1, assigned address 2
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: SanDisk Model: Cruzer Micro Rev: 0.1
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 501759 512-byte hdwr sectors (257 MB)
sda: Write Protect is off
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
vlan0: add 01:00:5e:00:00:01 mcast address to master interface
vlan0: dev_set_promiscuity(master, 1)
vlan0: dev_set_allmulti(master, 1)
device eth2 entered promiscuous mode
eth2: attempt to add interface with same source address.
br0: port 2(eth2) entering learning state
br0: port 1(vlan0) entering learning state
br0: port 2(eth2) entering forwarding state
br0: topology change detected, propagating
br0: port 1(vlan0) entering forwarding state
br0: topology change detected, propagating
vlan1: Setting MAC address to 00 1b fc 57 bb 7e.
vlan1: add 01:00:5e:00:00:01 mcast address to master interface
imq driver loaded.
usb.c: USB disconnect on device 01:03.2-1 address 2
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
hub.c: new USB device 01:03.2-2, assigned address 3
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 3
VFS: Disk change detected on device 08:00
SCSI device sda: 501759 512-byte hdwr sectors (257 MB)
sda: Write Protect is off
/dev/scsi/host0/bus0/target0/lun0: p1
root@OpenWrt:~$
INSMOD BELOW
root@OpenWrt:~$ lsmod
Module Size Used by Tainted: P
ipt_IMQ 672 1
ipt_length 336 4
ipt_layer7 10512 1
ipt_CONNMARK 816 2
sch_red 3216 4
sch_sfq 3912 4
sch_hfsc 15960 2
cls_fw 2888 8
imq 2384 1
ehci-hcd 20556 0 (unused)
usb-storage 68624 1
sd_mod 12500 2
scsi_mod 70616 2 [usb-storage sd_mod]
printer 9788 0 (unused)
usbcore 74808 1 [ehci-hcd usb-storage printer]
vfat 11692 1
fat 36840 0 [vfat]
loop 11112 0 (unused)
wlcompat 15824 0 (unused)
ppp_async 8108 0 (unused)
ppp_generic 22868 0 [ppp_async]
slhc 6352 0 [ppp_generic]
ip_nat_irc 2336 0 (unused)
ip_conntrack_irc 3128 1
ip_nat_tftp 1824 0 (unused)
ip_conntrack_tftp 1728 1
ip_nat_ftp 2960 0 (unused)
ip_conntrack_ftp 4320 1
wl 423640 0 (unused)
switch-robo 4460 0 (unused)
switch-core 4912 0 [switch-robo]
diag 19808 0 (unused)