Linux version 2.6.22 (root@blues) (gcc version 4.2.0 (Gentoo 4.2.0 p1.4)) #1 Wed Sep 26 07:58:03 CEST 2007
CPU: ARM926EJ-S [41069260] revision 0 (ARMv5TEJ), cr=a0053177
Machine: MV-88fxx81
Using UBoot passing parameters structure
Sys Clk = 200000000, Tclk = 166664740
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 32768
DMA zone: 256 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 32512 pages, LIFO batch:7
Normal zone: 0 pages used for memmap
CPU0: D VIVT write-back cache
CPU0: I cache: 32768 bytes, associativity 1, 32 byte lines, 1024 sets
CPU0: D cache: 32768 bytes, associativity 1, 32 byte lines, 1024 sets
Built 1 zonelists. Total pages: 32512
Kernel command line: console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 BOOTVER=1.01
PID hash table entries: 512 (order: 9, 2048 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 128MB = 128MB total
Memory: 110676KB available (3348K code, 267K data, 108K init)
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
Marvell Development Board (LSP Version 1.7.8_NAS) -- BUFFALO_BOARD_LS_GL
low, high, size e01 0 7fff200
PCI: bus0: Fast back to back transfers enabled
PCI: bus1: Fast back to back transfers enabled
SCSI subsystem initialized
libata version 2.21 loaded.
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
checking if image is initramfs...it isn't (no cpio magic); looks like an initrd
Freeing initrd memory: 15360K
Initialised mv i2c driver
Fast Floating Point Emulator V0.9 (c) Peter Teichmann.
JFS: nTxBlock = 985, nTxLock = 7886
SGI XFS with no debug enabled
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xf1012000 (irq = 3) is a 16550A
serial8250: ttyS1 at MMIO 0xf1012100 (irq = 4) is a 16550A
RAMDISK driver initialized: 3 RAM disks of 16384K size 1024 blocksize
loop: module loaded
Marvell Ethernet Driver 'mv_ethernet':
o Ethernet descriptors in DRAM
o DRAM SW cache-coherency
o TCP segmentation offload enabled
o Checksum offload enabled
o Rx desc: 128
o Tx desc: 256
o Loading network interface ** eth_init_module (0)
'eth0'
Intergrated Sata device found
scsi0 : Marvell SCSI to SATA adapter
scsi1 : Marvell SCSI to SATA adapter
physmap platform flash device: 00400000 at ff800000
CFI: Found no physmap-flash device at location zero
Found: SST 39LF020
physmap-flash: Found 1 x8 devices at 0x0 in 8-bit bank
physmap-flash: Found an alias at 0x40000 for the chip at 0x0
physmap-flash: Found an alias at 0x80000 for the chip at 0x0
physmap-flash: Found an alias at 0xc0000 for the chip at 0x0
physmap-flash: Found an alias at 0x100000 for the chip at 0x0
physmap-flash: Found an alias at 0x140000 for the chip at 0x0
physmap-flash: Found an alias at 0x180000 for the chip at 0x0
physmap-flash: Found an alias at 0x1c0000 for the chip at 0x0
physmap-flash: Found an alias at 0x200000 for the chip at 0x0
physmap-flash: Found an alias at 0x240000 for the chip at 0x0
physmap-flash: Found an alias at 0x280000 for the chip at 0x0
physmap-flash: Found an alias at 0x2c0000 for the chip at 0x0
physmap-flash: Found an alias at 0x300000 for the chip at 0x0
physmap-flash: Found an alias at 0x340000 for the chip at 0x0
physmap-flash: Found an alias at 0x380000 for the chip at 0x0
physmap-flash: Found an alias at 0x3c0000 for the chip at 0x0
number of JEDEC chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
cmdlinepart partition parsing not available
RedBoot partition parsing not available
Using physmap partition information
Creating 1 MTD partitions on "physmap-flash":
0x00000000-0x00040000 : "u-boot"
Starting 88F5182 SOC EHCI USB Controller
mv5182_ehci mv5182_ehci.0: Marvell 5182 SOC EHCI Host Controller
mv5182_ehci mv5182_ehci.0: new USB bus registered, assigned bus number 1
mv5182_ehci mv5182_ehci.0: irq 17, io mem 0xf1050100
mv5182_ehci mv5182_ehci.0: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
Starting 88F5182 SOC EHCI USB Controller
mv5182_ehci mv5182_ehci.1: Marvell 5182 SOC EHCI Host Controller
mv5182_ehci mv5182_ehci.1: new USB bus registered, assigned bus number 2
mv5182_ehci mv5182_ehci.1: irq 12, io mem 0xf10a0100
mv5182_ehci mv5182_ehci.1: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver
USB Universal Host Controller Interface driver v3.0
Initializing USB Mass Storage driver...
scsi 1:0:0:0: Direct-Access C WD2500JS-55NCB1 10.0 PQ: 0 ANSI: 3
sd 1:0:0:0: [sda] 488397168 512-byte hardware sectors (250059 MB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Mode Sense: 23 00 10 00
sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA
sd 1:0:0:0: [sda] 488397168 512-byte hardware sectors (250059 MB)
sd 1:0:0:0: [sda] Write Protect is off
sd 1:0:0:0: [sda] Mode Sense: 23 00 10 00
sd 1:0:0:0: [sda] Write cache: enabled, read cache: enabled, supports DPO and FUA
sda: sda1 sda2 sda4 < sda5 sda6 sda7 sda8 >
sd 1:0:0:0: [sda] Attached SCSI disk
sd 1:0:0:0: Attached scsi generic sg0 type 0
usb 2-1: new full speed USB device using mv5182_ehci and address 2
usb 2-1: configuration #1 chosen from 1 choice
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
Buffalo Platform Linux Driver(Light) 0.16 installed.
MICON ctrl (C) BUFFALO INC. V.1.00 installed.
Kernel event proc (C) BUFFALO INC. V.1.00 installed.
MICON V2 (C) BUFFALO INC. V.1.00 installed.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Compressed image found at block 0
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda2, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem).
Trying to move old root to /initrd ... /initrd does not exist. Ignored.
Unmounting old root
Trying to free ramdisk memory ... okay
Freeing init memory: 108K
udev: renamed network interface eth0 to eth2
EXT3 FS on sda2, internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda7, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Adding 1052216k swap on /dev/sda5. Priority:-1 extents:1 across:1052216k