rendered paste bodyRouterBOOT booter 2.5
RouterBoard 133C
CPU frequency: 175 MHz
Memory size: 16 MB
Press any key within 2 seconds to enter setup..
trying bootp protocol... OK
Got IP address: 192.168.55.50
resolved mac address 00:A0:D1:B8:5D:D5
Gateway: 192.168.55.1
transfer started ...................... transfer ok, time=1.43s
setting up elf image... OK
jumping to kernel code
Linux version 2.6.23.9 (michael@marmite) (gcc version 4.1.2) #2 Mon Dec 10 17:47
console [early0] enabled
CPU revision is: 0001800b
SoC : ADM5120 revision 8, running at 175MHz
Bootdev : NOR flash
Prom : RouterBOOT
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Built 1 zonelists in Zone order. Total pages: 4064
Kernel command line: console=ttyS0,115200 rootfstype=yaffs2 init=/etc/preinit
Primary instruction cache 8kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
Using 87.500 MHz high precision timer.
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 13284k/16384k available (1918k kernel code, 3100k reserved, 333k data, )
Mount-cache hash table entries: 512
adm5120: registered board 'Generic ADM5120 board'
adm5120: registered board 'Cellvision CAS-630/630W'
adm5120: registered board 'Cellvision CAS-670/670W'
adm5120: registered board 'Cellvision CAS-700/700W'
adm5120: registered board 'Cellvision CAS-771/771W'
adm5120: registered board 'Cellvision CAS-790'
adm5120: registered board 'Cellvision CAS-861/861W'
adm5120: registered board 'Compex WPP54G'
adm5120: registered board 'Compex WPP54AG'
adm5120: registered board 'Compex WP54G-WRT'
adm5120: registered board 'Compex WP54G'
adm5120: registered board 'Compex WP54AG'
adm5120: registered board 'Compex NetPassage 28G'
adm5120: registered board 'Compex NetPassage 27G'
adm5120: registered board 'Edimax BR-6104WG/6114WG'
adm5120: registered board 'Edimax BR-6104K/6104KP'
adm5120: registered board 'Infineon EASY 83000 Reference Board'
adm5120: registered board 'Infineon EASY 5120-WVoIP Reference Board'
adm5120: registered board 'Infineon EASY 5120-RT Reference Board'
adm5120: registered board 'Infineon EASY 5120P-ATA Reference Board'
adm5120: registered board 'Mikrotik RouterBOARD 192'
adm5120: registered board 'Mikrotik RouterBOARD 153'
adm5120: registered board 'Mikrotik RouterBOARD 150'
adm5120: registered board 'Mikrotik RouterBOARD 133C'
adm5120: registered board 'Mikrotik RouterBOARD 133'
adm5120: registered board 'Mikrotik RouterBOARD 112'
adm5120: registered board 'Mikrotik RouterBOARD 111'
adm5120: registered board 'ZyXEL Prestige 335/335WT'
adm5120: registered board 'ZyXEL Prestige 334WT'
NET: Registered protocol family 16
adm5120: setting up board 'Mikrotik RouterBOARD 133C'
adm5120: system has PCI BIOS
registering PCI controller with io_map_base unset
PCI: mapping irq for 0000:00:01.0 pin:1, irq:14
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
yaffs Dec 10 2007 17:37:34 Installing.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: AMBA driver $Revision: 1.41 $
APB:UART0: ttyS0 at MMIO 0x12600000 (irq = 9) is a AMBA
console handover: boot [early0] -> real [ttyS0]
APB:UART1: ttyS1 at MMIO 0x12800000 (irq = 10) is a AMBA
ADM5120 built-in ethernet switch driver version 0.1.0
adm5120-flash.0: probing at 0x1FC00000, size:1024KiB, width:8 bits
Found: PMC Pm39LV010
adm5120-flash.0: Found 1 x8 devices at 0x0 in 8-bit bank
number of JEDEC chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
adm5120-flash.0: reducing map size to 128KiB
adm5120-flash.0: found at 0x1FC00000, size:128KiB, width:8 bits
adm5120-flash.0: adding static partitions
Creating 2 MTD partitions on "adm5120-flash.0":
0x00000000-0x00010000 : "booter"
0x00010000-0x00020000 : "firmware"
NAND device: Manufacturer ID: 0xad, Chip ID: 0x76 (Hynix NAND 64MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 606 at 0x00978000
Bad eraseblock 608 at 0x00980000
Creating 2 MTD partitions on "NAND 64MiB 3,3V 8-bit":
0x00000000-0x00400000 : "kernel"
0x00400000-0x04000000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
split_squashfs: no squashfs found in "NAND 64MiB 3,3V 8-bit"
nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
trxsplit: searching TRX header in 'booter'
trxsplit: searching TRX header in 'firmware'
trxsplit: 'kernel' is not a NOR flash, skipped
trxsplit: 'rootfs' is not a NOR flash, skipped
VFS: Cannot open root device "<NULL>" or unknown-block(31,3)
Please append a correct "root=" boot option; here are the available partitions:
1f00 64 mtdblock0 (driver?)
1f01 64 mtdblock1 (driver?)
1f02 4096 mtdblock2 (driver?)
1f03 61440 mtdblock3 (driver?)
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,3)