1. Make sure modem is plugged in and turned on.
2. In the Setup menu in Puppy, open "Network Wizard."
3. You should see a list of interfaces in the "interface" box (if you don't see any, don't worry).
4. Click on "Load module."
5. In the window that opens, click on the "More" tab on top.
6. Click on 'Specify" (it's possible "Auto-probe" would work, but not sure).
7. In the small box that comes up, type "cdc-ether" (without the quotes).
8. It should say "module cdc-ether loaded successfully." Click OK.
9. It should pop a box saying a new interface has been found. Say "Save."
10. When you are back in the main window, under Interfaces, a new button should be present (saying something "eth1" - number will vary). Click it.
11. Choose "Auto DHCP."
12. After a pause, you should get the "Network Configuration Successful" window. Click 'Yes" to save the configuration.