Marvell>> help
? - alias for 'help'
FSdel - del a file from the Flash MV FS
FSdir - ls the Flash MV FS
FSformat- format the Flash MV FS
FSlef - Load an exe file to the Flash MV FS
FSlf - Load a file to the Flash MV FS
FSrun - Load an exe file from the Flash MV FS and run it
FStftp - tftp a file to the Flash MV FS
FStftpe - tftp an exe file to the Flash MV FS
FStype - cat file from the Flash MV FS
autoscr - run script from memory
base - print or set address offset
bdinfo - print Board Info structure
boot - boot default, i.e., run 'bootcmd'
bootd - boot default, i.e., run 'bootcmd'
bootelf - Boot from an ELF image in memory
bootext2 dev:boot_part1,boot_part2 addr boot_image linux_dev_name
bootm - boot application image from memory
bootp - boot image via network using BootP/TFTP protocol
bootvx - Boot vxWorks from an ELF image
bubt - Burn an image on the Boot Flash.
chpart - change active partition
cmp - memory compare
cmpm - Compare Memory
coninfo - print console devices and informations
cp - memory copy
cpumap - Display CPU memory mapping settings.
crc32 - checksum calculation
date - get/set/reset date & time
dclk - Display the MV device CLKs.
ddimm - Display SPD Dimm Info
dhcp - invoke DHCP client to obtain IP/boot params
diskboot- boot from IDE device
dma - Perform DMA
echo - echo args to console
eeprom - EEPROM sub-system
erase - erase FLASH memory
ext2load- load binary file from a Ext2 filesystem
ext2ls- list files in a directory (default /)
fi - Find value in the memory.
flinfo - print FLASH memory information
fsinfo - print information about filesystems
fsload - load binary file from a filesystem image
g - start application at cached address 'addr'(default addr 0x40000)
go - start application at address 'addr'
help - print online help
icrc32 - checksum calculation
ide - IDE sub-system
iloop - infinite loop on address range
imd - i2c memory display
iminfo - print header information for application image
imm - i2c memory modify (auto-incrementing)
imw - memory write (fill)
inm - memory modify (constant address)
iprobe - probe to discover valid I2C chip addresses
ir - reading and changing MV internal register values.
ln - Load S-Record executable file through the network interface.
loadb - load binary file over serial line (kermit mode)
loads - load S-Record file over serial line
loop - infinite loop on address range
ls - list files in a directory (default /)
map - Diasplay address decode windows
md - memory display
me - PCI master enable
mm - memory modify (auto-incrementing)
mp - map PCI BAR
mtest - simple RAM test
mw - memory write (fill)
nm - memory modify (constant address)
pci - list and access PCI Configuraton Space
phyRead - Read Phy register
phyWrite - Write Phy register
ping - send ICMP ECHO_REQUEST to network host
printenv- print environment variables
protect - enable or disable FLASH write protection
rarpboot- boot image via network using RARP/TFTP protocol
reset - Perform RESET of the CPU
resetenv - Return all environment variable to default.
run - run commands in an environment variable
saveenv - save environment variables to persistent storage
se - PCI Slave enable
setenv - set environment variables
sg - scanning the PHYs status
sleep - delay execution for some time
sp - Scan PCI bus.
tftpboot- boot image via network using TFTP protocol
version - print monitor version