dmesg | grep eth1
eth1: Hardware identity 0005:0001:0001:0002
eth1: Station identity 001f:0001:0008:0046
eth1: Firmware determined as Lucent/Agere 8.70
eth1: Ad-hoc demo mode supported
eth1: IEEE standard IBSS ad-hoc mode supported
eth1: WEP supported, 104-bit key
eth1: MAC address 00:30:65:1D:30:73
eth1: Station name "HERMES I"
eth1: ready
airport: Card registered for interface eth1
eth1: This firmware requires an ESSID in IBSS-Ad-Hoc mode.
eth1: This firmware requires an ESSID in IBSS-Ad-Hoc mode.
eth1: Lucent/Agere firmware doesn't support manual roaming
eth1: New link status: Connected (0001)
eth1: This firmware requires an ESSID in IBSS-Ad-Hoc mode.
eth1: New link status: Disconnected (0002)
eth1: This firmware requires an ESSID in IBSS-Ad-Hoc mode.
eth1: This firmware requires an ESSID in IBSS-Ad-Hoc mode.
eth1: This firmware requires an ESSID in IBSS-Ad-Hoc mode.
eth1: New link status: Connected (0001)
eth1: New link status: Connected (0001)
eth1: New link status: Disconnected (0002)
eth1: New link status: Connected (0001)
eth1: New link status: Disconnected (0002)
eth1: New link status: Connected (0001)
eth1: New link status: Connected (0001)
eth1: New link status: Disconnected (0002)
eth1: New link status: Connected (0001)
eth1: New link status: Disconnected (0002)
eth1: New link status: Connected (0001)
eth1: New link status: AP Out of Range (0004)