System Bootstrap, Version 12.3(8r)T8, RELEASE SOFTWARE (fc1)
Cisco 1841 (revision 5.0) with 114688K/16384K bytes of memory.
Self decompressing the image :
##
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up####################### [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.3(14)T7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Mon 15-May-06 14:54 by pt_team
Image text-base: 0x6007D180, data-base: 0x61400000
Port Statistics for unclassified packets is not turned on.
Cisco 1841 (revision 5.0) with 114688K/16384K bytes of memory.
Processor board ID FTX0947Z18E
M860 processor: part number 0, mask 49
2 FastEthernet/IEEE 802.3 interface(s)
2 Low-speed serial(sync/async) network interface(s)
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)
Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.3(14)T7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Mon 15-May-06 14:54 by pt_team
%LINK-5-CHANGED: Interface Vlan1, changed state to up
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to administratively down
%LINK-5-CHANGED: Interface Vlan1, changed state to administratively down
Press RETURN to get started!
%LINK-5-CHANGED: Interface Serial0/0/1, changed state to up
%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/1, changed state to up
00:00:10: %OSPF-5-ADJCHG: Process 1, Nbr 172.16.7.9 on Serial0/0/0 from LOADING to FULL, Loading Done
Branch2>enable
Branch2#show run-config
^
% Invalid input detected at '^' marker.
Branch2#show runn-config
^
% Invalid input detected at '^' marker.
Branch2#show running-config
Building configuration...
Current configuration : 736 bytes
!
version 12.3
no service password-encryption
!
hostname Branch2
!
!
!
!
interface FastEthernet0/0
ip address 10.10.6.1 255.255.254.0
duplex auto
speed auto
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
shutdown
!
interface Serial0/0/0
ip address 172.16.7.10 255.255.255.252
clock rate 64000
!
interface Serial0/0/1
ip address 172.16.7.6 255.255.255.252
!
interface Vlan1
no ip address
shutdown
!
router ospf 1
log-adjacency-changes
passive-interface Serial0/0/1
network 172.16.7.4 0.0.0.3 area 0
network 172.16.7.8 0.0.0.3 area 0
network 10.10.4.0 0.0.3.255 area 0
network 10.10.0.0 0.0.1.255 area 0
network 172.16.0.0 0.0.0.3 area 0
!
ip classless
!
!
!
!
line con 0
line vty 0 4
login
!
!
end