rendered paste bodyroot@carl-desktop:/etc/udev/rules.d# dmesg | tail -20
[ 22.532000] Clocksource tsc unstable (delta = -90917592 ns)
[ 22.764000] agpgart: Found an AGP 3.0 compliant device at 0000:00:00.0.
[ 22.764000] agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode
[ 22.764000] agpgart: Putting AGP V3 device at 0000:01:00.0 into 8x mode
[ 23.020000] [drm] Setting GART location based on new memory map
[ 23.020000] [drm] Loading R300 Microcode
[ 23.020000] [drm] writeback test succeeded in 1 usecs
[ 24.424000] NET: Registered protocol family 17
[ 29.320000] NET: Registered protocol family 10
[ 29.320000] lo: Disabled Privacy Extensions
[ 40.068000] eth0: no IPv6 routers present
[ 47.380000] UDF-fs: No VRS found
[ 47.476000] ISO 9660 Extensions: Microsoft Joliet Level 3
[ 47.524000] ISOFS: changing to secondary root
[ 298.144000] ndiswrapper version 1.45 loaded (smp=yes)
[ 298.308000] usb 5-7: reset high speed USB device using ehci_hcd and address 6
[ 298.488000] ndiswrapper: driver usr5421x (U.S. Robotics Corporation,06/16/2005, 4.01.19.7) loaded
[ 298.700000] wlan0: ethernet device 00:14:c1:3f:b1:db using NDIS driver: usr5421x, version: 0x4011405, NDIS version: 0x501, vendor: 'Broadcom RNDIS Network Adapter', 0BAF:011B.F.conf
[ 298.908000] wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK
[ 298.920000] usbcore: registered new interface driver ndiswrapper
root@carl-desktop:/etc/udev/rules.d# iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wlan0 Scan completed :
Cell 01 - Address: 00:18:39:D2:FF:BB
ESSID:"linksys3"
Protocol:IEEE 802.11g
Mode:Managed
Frequency:2.437 GHz (Channel 6)
Quality:73/100 Signal level:-49 dBm Noise level:-96 dBm
Encryption key:off
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s
24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s
12 Mb/s; 48 Mb/s
Extra:bcn_int=100
Extra:atim=0