XSF v1.53 Usage :
XSF [1|2|3|4] [R|W] binfile [/FULL] [/SAVESKIP] [/OFF] [/CHKSUM:xxxx]
[/SKIPSTART:xxxx] [/SKIPLEN:xxxx] [/LEN:xxxx] [/UP:x] [/NC]
[/9S:filename] [/ARST] [/SLED:x] [/AUTO] [/B] [/EMPTY] [/DELAY:x]
[/BAT:filename]
[1|2|3|4] - 1:PM 2:PS 3:SM 4:SS
[R|W] - R:Read W:Write (Default=W)
/FULL - Update whole FlashROM
/SAVESKIP - Save skipped range data to a file
/OFF - Turn off auto range setting
/CHKSUM - Check the checksum ,xxxx is hex checksum
/SKIPSTART - Set skipped range ,xxxx is hex address
/SKIPLEN - Set skipped length ,xxxx is hex length
/LEN - Flash length ,xxxx is hex length
/UP - Enable WFlash mode(micro-p flash )
x is 1(Update boot code) or 0(Dont update boot code)
/NC - Ignore compare
/9S - Update boot code from specific filename, for 5239S only.
/ARST - Check ATA SRST
/SLED:x - Move Sled x times
/AUTO - Auto flash and quit program
/B - Both port mode for LED
/EMPTY - Specify the FlashROM is empty, for speeding up only!
/DELAY - Delay n seconds after RET is pressed
/BAT - Run batchfile after flashing, nondata ATAPI cmd only.
G:\xsf>