Someone

Sep 26 10:17:49 pbx kernel: wanpipe: Probing for WANPIPE hardware.
Sep 26 10:17:49 pbx kernel: wanpipe: AFT-A200-SH FXO/FXS card found (HDLC rev.8), cpu(s) 1, bus #4, slot #1, irq #9
Sep 26 10:17:49 pbx kernel: wanpipe: Allocating maximum 1 devices: wanpipe1 - wanpipe1.
Sep 26 10:17:49 pbx kernel: wanpipe1: Starting WAN Setup
Sep 26 10:17:49 pbx kernel: Processing WAN device wanpipe1...
Sep 26 10:17:49 pbx kernel: wanpipe1: Locating: A200 card, CPU A, PciSlot=1, PciBus=4
Sep 26 10:17:49 pbx kernel: wanpipe1: Found: A200 card, CPU A, PciSlot=1, PciBus=4, Port=0
Sep 26 10:17:49 pbx kernel: wanpipe1: AFT PCI memory at 0x50000000
Sep 26 10:17:49 pbx kernel: wanpipe1: IRQ 23 allocated to the AFT PCI card
Sep 26 10:17:49 pbx kernel: wanpipe1: Starting AFT Analog Hardware Init.
Sep 26 10:17:49 pbx kernel: wanpipe1: Enabling front end link monitor
Sep 26 10:17:49 pbx kernel: wanpipe1: Global Chip Configuration: used=1
Sep 26 10:17:49 pbx kernel: wanpipe1: Global Front End Configuraton!
Sep 26 10:17:49 pbx kernel: wanpipe1: Configuring FXS/FXO Front End ...
Sep 26 10:17:50 pbx kernel: wanpipe1: Module 0: Installed -- Auto FXO (FCC mode)!
Sep 26 10:17:50 pbx kernel: wanpipe1: Module 1: Installed -- Auto FXO (FCC mode)!
Sep 26 10:17:54 pbx kernel: wanpipe1: Module 2: Installed -- Auto FXS!
Sep 26 10:17:58 pbx kernel: wanpipe1: Module 3: Installed -- Auto FXS!
Sep 26 10:17:58 pbx kernel: wanpipe1: Remora config done!
Sep 26 10:17:58 pbx kernel: wanpipe1: AFT Data Mux Bit Map: 0x01234567
Sep 26 10:17:58 pbx kernel: wanpipe1: Front End Interface Ready 0x00000000
Sep 26 10:17:58 pbx kernel: wanpipe1: Register EC interface wanec1 (usage 1, max ec chans 32)!
Sep 26 10:17:58 pbx kernel: wanpipe1: Configuring Device   :wanpipe1  FrmVr=08
Sep 26 10:17:58 pbx kernel: wanpipe1:    Global MTU     = 1500
Sep 26 10:17:58 pbx kernel: wanpipe1:    Global MRU     = 1500
Sep 26 10:17:58 pbx kernel: wanpipe1:    Data Mux Map   = 0x01234567
Sep 26 10:17:58 pbx kernel: wanpipe1:    Rx CRC Bytes   = 0
Sep 26 10:17:58 pbx kernel: wanpipe1:    Global TDM Int = Disabled
Sep 26 10:17:58 pbx kernel: wanpipe1:    Global TDM Ring= Disabled
Sep 26 10:17:58 pbx kernel: wanpipe1:    TDMV Span      = 1 : Enabled
Sep 26 10:17:58 pbx kernel: wanpipe1: Configuring Interface: w1g1
Sep 26 10:17:58 pbx kernel: wanpipe1:w1g1: Running in TDM Voice Zaptel Mode.
Sep 26 10:17:58 pbx kernel: wanpipe1: Registering TDMV FXO iface to module 1!
Sep 26 10:17:58 pbx kernel: wanpipe1:    MRU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    MTU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    HDLC Eng      :Off (Transparent)
Sep 26 10:17:58 pbx kernel: wanpipe1:    Data Mux Ctrl :On
Sep 26 10:17:58 pbx kernel: wanpipe1:    Active Ch Map :0x00000001
Sep 26 10:17:58 pbx kernel: wanpipe1:    First TSlot   :0
Sep 26 10:17:58 pbx kernel: wanpipe1:    DMA/Len/Chain :4/896/Off
Sep 26 10:17:58 pbx kernel: wanpipe1: Configuring Interface: w1g1
Sep 26 10:17:58 pbx kernel: wanpipe1:w1g1: Running in TDM Voice Zaptel Mode.
Sep 26 10:17:58 pbx kernel: wanpipe1: Registering TDMV FXO iface to module 2!
Sep 26 10:17:58 pbx kernel: wanpipe1:    MRU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    MTU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    HDLC Eng      :Off (Transparent)
Sep 26 10:17:58 pbx kernel: wanpipe1:    Data Mux Ctrl :On
Sep 26 10:17:58 pbx kernel: wanpipe1:    Active Ch Map :0x00000002
Sep 26 10:17:58 pbx kernel: wanpipe1:    First TSlot   :1
Sep 26 10:17:58 pbx kernel: wanpipe1:    DMA/Len/Chain :4/896/Off
Sep 26 10:17:58 pbx kernel: wanpipe1: Configuring Interface: w1g1
Sep 26 10:17:58 pbx kernel: wanpipe1:w1g1: Running in TDM Voice Zaptel Mode.
Sep 26 10:17:58 pbx kernel: wanpipe1: Registering TDMV FXS iface to module 3!
Sep 26 10:17:58 pbx kernel: wanpipe1:    MRU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    MTU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    HDLC Eng      :Off (Transparent)
Sep 26 10:17:58 pbx kernel: wanpipe1:    Data Mux Ctrl :On
Sep 26 10:17:58 pbx kernel: wanpipe1:    Active Ch Map :0x00000004
Sep 26 10:17:58 pbx kernel: wanpipe1:    First TSlot   :2
Sep 26 10:17:58 pbx kernel: wanpipe1:    DMA/Len/Chain :4/896/Off
Sep 26 10:17:58 pbx kernel: wanpipe1: Configuring Interface: w1g1
Sep 26 10:17:58 pbx kernel: wanpipe1:w1g1: Running in TDM Voice Zaptel Mode.
Sep 26 10:17:58 pbx kernel: wanpipe1: Configuring TDMV Master dev w1g1
Sep 26 10:17:58 pbx kernel: wanpipe1: Registering TDMV FXS iface to module 4!
Sep 26 10:17:58 pbx kernel: wanpipe1:    MRU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    MTU           :8
Sep 26 10:17:58 pbx kernel: wanpipe1:    HDLC Eng      :Off (Transparent)
Sep 26 10:17:58 pbx kernel: wanpipe1:    Data Mux Ctrl :On
Sep 26 10:17:58 pbx kernel: wanpipe1:    Active Ch Map :0x00000008
Sep 26 10:17:58 pbx kernel: wanpipe1:    First TSlot   :3
Sep 26 10:17:58 pbx kernel: wanpipe1:    DMA/Len/Chain :4/896/Off
Sep 26 10:17:58 pbx kernel: wanpipe1: Wanpipe device is registered to Zaptel span # 1!
Sep 26 10:17:58 pbx kernel: wanpipe1: AFT communications enabled!
Sep 26 10:17:58 pbx kernel: wanpipe1: AFT Per Port TDM Intr
Sep 26 10:17:58 pbx kernel: wanpipe1: Clear Echo Canceller chip reset.
Sep 26 10:18:04 pbx kernel: wanpipe1: Open (usecount=1, channo=1, chanpos=1)...
Sep 26 10:18:04 pbx kernel: wanpipe1: Open (usecount=2, channo=4, chanpos=4)...