sysread FILEHANDLE,SCALAR,LENGTH,OFFSET
sysread FILEHANDLE,SCALAR,LENGTH
Attempts to read LENGTH bytes of data into variable SCALAR from the specified FILEHANDLE, using the system call read(2). It bypasses
buffered IO, so mixing this with other kinds of reads, "print", "write", "seek", "tell", or "eof" can cause confusion because the perlio
or stdio layers usually buffers data. Returns the number of bytes actually read, 0 at end of file, or undef if there was an error (in the
latter case $! is also set). SCALAR will be grown or shrunk so that the last byte actually read is the last byte of the scalar after the
read.
An OFFSET may be specified to place the read data at some place in the string other than the beginning. A negative OFFSET specifies
placement at that many characters counting backwards from the end of the string. A positive OFFSET greater than the length of SCALAR
results in the string being padded to the required size with "\0" bytes before the result of the read is appended.
There is no syseof() function, which is ok, since eof() doesn't work very well on device files (like ttys) anyway. Use sysread() and
check for a return value for 0 to decide whether you're done.
Note that if the filehandle has been marked as ":utf8" Unicode characters are read instead of bytes (the LENGTH, OFFSET, and the return
value of sysread() are in Unicode characters). The ":encoding(...)" layer implicitly introduces the ":utf8" layer. See "binmode",
"open", and the "open" pragma, open.
/tmp/POgmF6GFz6 lines 1-18/18 (END)