# $Id: iaxmodem,v 1.5 2006/12/27 03:56:35 faxguy Exp $
#
# prototype config for the IAXmodem softmodem which uses
# the spandsp soft-DSP library
#
#
CountryCode: 1
AreaCode: 512
FAXNumber: +1.512.874.7610
LongDistancePrefix: 1
InternationalPrefix: 011
DialStringRules: etc/dialrules
ServerTracing: 1
SessionTracing: 0xFFF
RecvFileMode: 0600
LogFileMode: 0600
DeviceMode: 0600
RingsBeforeAnswer: 1
SpeakerVolume: off
GettyArgs: "-h %l dx_%s"
LocalIdentifier: CatalisInc
TagLineFont: etc/lutRS18.pcf
TagLineFormat: "From %%l|%c|Page %%P of %%T"
MaxRecvPages: 25
FaxRcvdCmd: bin/faxrcvd.local
#
#
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType: Class1 # use this to supply a hint
#
# *** Caller-ID settings ***
#
# Enabling this will use the hfaxd-protocol to set Caller*ID
#
#ModemSetOriginCmd: AT+VSID="%s","%d"
#
# If "glare" during initialization becomes a problem then take
# the modem off-hook during initialization, and then place it
# back on-hook when done.
#
#ModemResetCmds: "ATH1\nAT+VCID=1" # enables CallID display
#ModemReadyCmds: ATH0
#
# You'll likely want Caller*ID display (also displays DID) enabled.
#
ModemResetCmds: AT+VCID=1 # enables CallID display
#
# If you are "missing" Caller*ID data on some calls (but not all)
# and if you do not have adequate glare protection you may want to
# not answer based on RINGs, but rather enable the CallIDAnswerLength
# for NDID, disable AT+VCID=1 and do this:
#
#RingsBeforeAnswer: 0
#ModemRingResponse: AT+VRID=1
# The pty apparently does not support changing parity.
PagerTTYParity: none
Class1AdaptRecvCmd: AT+FAR=1
Class1TMConnectDelay: 400 # counteract quick CONNECT response
Class1RMQueryCmd: "!24,48,72,96" # V.17 fast-train recv doesn't work well
CallIDPattern: "NMBR="
CallIDPattern: "NAME="
CallIDPattern: "ANID="
CallIDPattern: "NDID="
#CallIDAnswerLength: 4
# Uncomment these if you really want them, but you probably don't.
#CallIDPattern: "DATE="
#CallIDPattern: "TIME="