start_udevd
bin dev etc lib linuxrc my_modules old_root proc root sbin sys tmp usr var Starting kernel event manager...
...done.
bin dev etc lib linuxrc my_modules old_root proc root sbin sys tmp usr var Loading hardware drivers...
...done.
start_hotplug
bin dev etc lib linuxrc my_modules old_root proc root sbin sys tmp usr var Starting hotplug subsystem...
...done.
variableize_kernel_append_parameters
read_kernel_append_parameters
read_local_cfg
skipping local.cfg: option SKIP_LOCAL_CFG=y has been specified
read_kernel_append_parameters
start_network
IP Address not set with pre-boot settings.
sleep 0: This is to give your switch (if you're using one) time to
recognize your ethernet card before we try the network.
Tip: You can use <ctrl>+<c> to pass the time (pun intended).
dhclient
Internet Software Consortium DHCP Client 2.0pl5
Copyright 1995, 1996, 1997, 1998, 1999 The Internet Software Consortium.
All rights reserved.
Please contribute if you find this software useful.
For info, please visit http://www.isc.org/dhcp-contrib.html
Listening on LPF/lo/<null>
Sending on LPF/lo/<null>
Listening on LPF/eth0/00:0c:29:b3:c6:26
Sending on LPF/eth0/00:0c:29:b3:c6:26
Sending on Socket/fallback/fallback-net
DHCPDISCOVER on lo to 255.255.255.255 port 67 interval 6
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 6
DHCPOFFER from 192.168.1.100
DHCPOFFER from 192.168.1.100
DHCPOFFER already seen.
DHCPDISCOVER on lo to 255.255.255.255 port 67 interval 17
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPACK from 192.168.1.100
Using DHCP server (very deprecated) as IMAGESERVER: 192.168.1.100
bound to 192.168.1.1 -- renewal in 21600 seconds.
Overriding any DHCP settings with pre-boot settings from kernel append
parameters.
read_kernel_append_parameters
ping_test
Pinging your SystemImager server to ensure we have network connectivity.
PING ATTEMPT 1:
PING 192.168.1.100 (192.168.1.100): 56 data bytes
84 bytes from 192.168.1.100: icmp_seq=0 ttl=64 time=46.7 ms
--- 192.168.1.100 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
round-trip min/avg/max = 46.7/46.7/46.7 ms
We have connectivity to your SystemImager server!
Monitoring initialized.
start_syslogd
get_boel_binaries_tarball
rsync -av 192.168.1.100::boot/i386/standard/boel_binaries.tar.gz /tmp/boel_binaries
receiving file list ... done
boel_binaries.tar.gz
sent 126 bytes received 5511541 bytes 2204666.80 bytes/sec
total size is 5510736 speedup is 1.00
tmpfs_watcher
get_scripts_directory
rsync -a 192.168.1.100::scripts/ /scripts/
autodetect_hardware_and_load_modules
Detecting hardware:
agpgart agpgart pcnet32 piix BusLogic
Loading sd_mod...
done!
Loading ide-disk...
done!
Loading agpgart...
not needed or already loaded.
Loading agpgart...
not needed or already loaded.
Loading pcnet32...
not needed or already loaded.
Loading piix...
done!
Loading BusLogic...
done!
get_hostname_by_hosts_file
Hosts file exists...
Searching for this machine's hostname in /scripts/hosts by IP: 192.168.1.1
This hosts name is: oscarnode1
run_pre_install_scripts
>>> 99all.harmless_example_script
I live in /var/lib/systemimager/scripts/pre-install.
choose_autoinstall_script
Using autoinstall script: /scripts/oscarnode1.sh
write_variables
run_autoinstall_script
>>> /scripts/oscarnode1.sh
get_arch
enumerate_disks
sda
DISKS=1
Partitioning /dev/sda...
Old partition table for /dev/sda:
Disk geometry for /dev/sda: 0kB - 4295MB
Disk label type: msdos
Number Start End Size Type File system Flags
1 1kB 100MB 100MB primary ext3 boot
2 100MB 4295MB 4195MB extended
5 100MB 612MB 512MB logical linux-swap
6 612MB 4295MB 3683MB logical ext3
dd if=/dev/zero of=/dev/sda bs=512 count=1 || shellout
1+0 records in
1+0 records out
blockdev --rereadpt /dev/sda
parted -s -- /dev/sda mklabel msdos || shellout
Creating partition /dev/sda1.
parted -s -- /dev/sda mkpart primary 0 100 || shellout
parted -s -- /dev/sda set 1 boot on
Creating partition /dev/sda2.
parted -s -- /dev/sda mkpart extended 100 4295 || shellout
Creating partition /dev/sda5.
parted -s -- /dev/sda mkpart logical linux-swap 100 612 || shellout
Creating partition /dev/sda6.
parted -s -- /dev/sda mkpart logical 612 4295 || shellout
New partition table for /dev/sda:
Disk geometry for /dev/sda: 0kB - 4295MB
Disk label type: msdos
Number Start End Size Type File system Flags
1 1kB 100MB 100MB primary ext3 boot
2 100MB 4295MB 4195MB extended
5 100MB 612MB 512MB logical linux-swap
6 612MB 4295MB 3683MB logical ext3
Load software RAID modules.
insmod: cannot insert `/lib/modules/2.6.18-boel_v3.8.0/kernel/drivers/md/md-mod.ko': File exists (-1): File exists
insmod: cannot insert `/lib/modules/2.6.18-boel_v3.8.0/kernel/drivers/md/md-mod.ko': File exists (-1): File exists
modprobe: module raid5 not found.
modprobe: failed to load module raid5
modprobe: module raid6 not found.
modprobe: failed to load module raid6
insmod: cannot insert `/lib/modules/2.6.18-boel_v3.8.0/kernel/drivers/md/md-mod.ko': File exists (-1): File exists
Load device mapper driver (for LVM).
Load additional filesystem drivers.
modprobe: module fat not found.
modprobe: failed to load module fat
modprobe: module vfat not found.
modprobe: failed to load module vfat
mke2fs -q -j /dev/sda6 || shellout
mkdir -p /a/ || shellout
mount /dev/sda6 /a/ -t ext3 -o defaults || shellout
mkswap -v1 /dev/sda5 || shellout
Setting up swapspace version 1, size = 511991 kB
no label, UUID=c159ff76-7b5c-4aba-a38a-21124a470a0b
swapon /dev/sda5 || shellout
mke2fs -q -j /dev/sda1 || shellout
mkdir -p /a/boot || shellout
mount /dev/sda1 /a/boot -t ext3 -o defaults || shellout
mkdir -p /a/proc || shellout
mount proc /a/proc -t proc -o defaults || shellout
mkdir -p /a/sys || shellout
mount sysfs /a/sys -t sysfs -o defaults || shellout
Evaluating image size.
Report task started.
Quietly installing image...
/rsync -aHS --exclude=lost+found/ --exclude=/proc/* --numeric-ids 192.168.1.100::oscarimage/ /a/
-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/-|/Report task stopped.
-
stop_spinner
rsync -av --numeric-ids 192.168.1.100::overrides/oscarimage/ /a/
Editing files for actual disk configuration...
/dev/sda -> /dev/sda
/etc/fstab
/etc/systemconfig/systemconfig.conf
mount /dev /a/dev -o bind || shellout
chroot: cannot execute systemconfigurator: No such file or directory
Killing off running processes.
write_variables
<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
This is the SystemImager autoinstall system
Your autoinstall has failed. You can use the shell prompt to try and see
what happened. You may be able to use the <Shift>+<Page Up> keys to scroll
back and see the text that has passed off the top of the screen. You can use
<alt>+<f2>, <f3>, or <f4> to work at an alternate shell prompt and preserve
your messages on the main screen, which is on <alt>+<f1>. Then go back and
re-read the documentation to see if your problem is described there.
You have read the documentation, right? :-)
If you absolutely cannot figure it out, visit the SystemImager support page
at http://systemimager.org/support/. There you can search the email list
archives, ask your question on IRC, or even join a mailing list to ask your
question. There's a good chance someone else has experienced this very same
issue and can help answer your question. If you find the answer and it's not
in the documentation, or if you identify a bug, please submit a bug report at
the SystemImager support page.
Have fun! http://systemimager.org/team/
<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Installation failed!! Stopping report task.
/scripts/oscarnode1.sh: kill: 575: (5653) - No such process
Report task stopped.