rendered paste body[ 7.729505] Zaptel Version: 1.4.3
[ 7.729508] Zaptel Echo Canceller: MG2
[ 7.738320] Linux agpgart interface v0.102 (c) Dave Jones
[ 7.748006] piix4_smbus 0000:00:0f.0: Found 0000:00:0f.0 device
[ 7.792067] pnp: Device 00:0b activated.
[ 7.792076] parport: PnPBIOS parport detected.
[ 7.792135] parport0: PC-style at 0x378, irq 7 [PCSPP]
[ 7.843126] NET: Registered protocol family 10
[ 7.843338] lo: Disabled Privacy Extensions
[ 8.139195] ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 27 (level, low) -> IRQ 18
[ 8.139230] Found TE4XXP at base address fe9fdc00, remapped to f88a4c00
[ 8.139244] TE4XXP version c01a0164, burst OFF, slip debug: OFF
[ 8.139660] FALC version: 00000005, Board ID: 00
[ 8.139666] Reg 0: 0x1fe23400
[ 8.139669] Reg 1: 0x1fe23000
[ 8.139672] Reg 2: 0xffffffff
[ 8.139675] Reg 3: 0x00000000
[ 8.139678] Reg 4: 0x0000ff00
[ 8.139681] Reg 5: 0x00000000
[ 8.139685] Reg 6: 0xc01a0164
[ 8.139688] Reg 7: 0x00001000
[ 8.139691] Reg 8: 0x00000000
[ 8.139694] Reg 9: 0x00ff00ff
[ 8.139698] Reg 10: 0x0000004a
[ 8.139798] TE4XXP: Launching card: 0
[ 8.139802] TE4XXP: Setting up global serial parameters
[ 8.142532] Found a Wildcard: Wildcard TE405P (2nd Gen)
[ 8.283118] About to enter spanconfig!
[ 8.283125] Done with spanconfig!
[ 8.297987] Registered tone zone 0 (United States / North America)
[ 8.297996] About to enter startup!
[ 8.298067] TE4XXP: Span 1 configured for ESF/B8ZS
[ 8.298091] wct4xxp: Setting yellow alarm on span 1
[ 8.298103] timing source auto card 0!
[ 8.298177] SPAN 1: Primary Sync Source
[ 8.311013] timing source auto card 0!
[ 8.311590] VPM400: Span 0 U-law mode
[ 8.331685] VPM: DTMF threshold set to 1000
[ 8.332089] VPM400: Span 1 U-law mode
[ 8.351637] VPM: DTMF threshold set to 1000
[ 8.352036] VPM400: Span 2 U-law mode
[ 8.371593] VPM: DTMF threshold set to 1000
[ 8.371991] VPM400: Span 3 U-law mode
[ 8.391548] VPM: DTMF threshold set to 1000
[ 8.411504] VPM: DTMF threshold set to 1000
[ 8.431460] VPM: DTMF threshold set to 1000
[ 8.451415] VPM: DTMF threshold set to 1000
[ 8.471371] VPM: DTMF threshold set to 1000
[ 8.471636] VPM400: hardware DTMF enabled.
[ 8.471638] VPM400: Present and operational servicing 4 span(s)
[ 8.471641] Completed startup!
[ 8.686022] lp0: using parport0 (interrupt-driven).
[ 8.868269] Adding 2433808k swap on /dev/disk/by-uuid/96a45d0a-72c9-4c7f-9647-54adc96b784b. Priority:-1 extents:1 across:2433808k
[ 9.040016] EXT3 FS on sda1, internal journal
[ 11.016298] About to enter spanconfig!
[ 11.016311] About to enter startup!
[ 11.016394] TE4XXP: Span 1 configured for ESF/B8ZS
[ 11.016482] SPAN 1: Primary Sync Source
[ 11.016486] Completed startup!
[ 11.016790] Registered tone zone 0 (United States / North America)
[ 11.016854] timing source auto card 0!
[ 11.028812] timing source auto card 0!
[ 16.017039] wct4xxp: Clearing yellow alarm on span 1
[ 18.440516] eth1: no IPv6 routers present
[ 206.724934] About to enter spanconfig!
[ 206.724946] About to enter startup!
[ 206.725028] TE4XXP: Span 1 configured for ESF/B8ZS
[ 206.725053] wct4xxp: Setting yellow alarm on span 1
[ 206.725156] SPAN 1: Primary Sync Source
[ 206.725160] Completed startup!
[ 206.725660] timing source auto card 0!
[ 206.726929] Registered tone zone 0 (United States / North America)
[ 206.736574] timing source auto card 0!
[ 211.724803] wct4xxp: Clearing yellow alarm on span 1