usb 1-1: Product: USB TO IDE
usb 1-1: uevent
usb 1-1: usb_probe_device
usb 1-1: configuration #1 chosen from 1 choice
usb 1-1: adding 1-1:1.0 (config #1, interface 0)
usb 1-1:1.0: uevent
usb-storage 1-1:1.0: usb_probe_interface
usb-storage 1-1:1.0: usb_probe_interface - got id
usb-storage: USB Mass Storage device detected
usb-storage: -- associate_dev
usb-storage: Vendor: 0x05e3, Product: 0x0702, Revision: 0x0033
usb-storage: Interface Subclass: 0x06, Protocol: 0x50
usb-storage: Transport: Bulk
usb-storage: Protocol: Transparent SCSI
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: *** thread sleeping.
drivers/usb/core/inode.c: creating file '002'
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
usb-storage: usb_stor_control_msg: rq=fe rqtype=a1 value=0000 index=00 len=1
usb-storage: GetMaxLUN command result is 1, data is 0
usb-storage: queuecommand called
usb-storage: *** thread awakened.
usb-storage: Command INQUIRY (6 bytes)
usb-storage: 12 00 00 00 24 00
usb-storage: Bulk Command S 0x43425355 T 0x1 L 36 F 128 Trg 0 LUN 0 CL 6
usb-storage: usb_stor_bulk_transfer_buf: xfer 31 bytes
usb-storage: Status code 0; transferred 31/31
usb-storage: -- transfer complete
usb-storage: Bulk command transfer result=0
usb-storage: usb_stor_bulk_transfer_sglist: xfer 36 bytes, 1 entries
usb-storage: command_abort called
usb-storage: usb_stor_stop_transport called
usb-storage: -- cancelling sg request
usb-storage: Status code -104; transferred 0/36
usb-storage: -- transfer cancelled
usb-storage: Bulk data transfer result 0x4
usb-storage: -- command was aborted
usb-storage: storage_pre_reset
ehci_hcd 0000:00:1d.7: port 1 full speed --> companion
ehci_hcd 0000:00:1d.7: GetStatus port 1 status 003001 POWER OWNER sig=se0 CONNECT
ehci_hcd 0000:00:1d.7: port 1 full speed --> companion
ehci_hcd 0000:00:1d.7: GetStatus port 1 status 003001 POWER OWNER sig=se0 CONNECT
ehci_hcd 0000:00:1d.7: port 1 full speed --> companion
ehci_hcd 0000:00:1d.7: GetStatus port 1 status 003001 POWER OWNER sig=se0 CONNECT
ehci_hcd 0000:00:1d.7: port 1 full speed --> companion
ehci_hcd 0000:00:1d.7: GetStatus port 1 status 003001 POWER OWNER sig=se0 CONNECT
hub 1-0:1.0: logical disconnect on port 1
usb-storage: storage_post_reset
usb-storage: usb_reset_composite_device returns -19
usb-storage: usb_stor_Bulk_reset called
usb-storage: usb_stor_control_msg: rq=ff rqtype=21 value=0000 index=00 len=0
usb-storage: Soft reset failed: -19
usb-storage: scsi command aborted
usb-storage: *** thread sleeping.
hub 1-0:1.0: state 7 ports 8 chg 0002 evt 0000
hub 1-0:1.0: port 1, status 0501, change 0000, 480 Mb/s
usb 1-1: USB disconnect, address 2
usb 1-1: unregistering device
usb 1-1: usb_disable_device nuking all URBs
usb 1-1: unregistering interface 1-1:1.0
usbdev1.2_ep81: ep_device_release called for usbdev1.2_ep81
usbdev1.2_ep02: ep_device_release called for usbdev1.2_ep02
usb-storage: storage_disconnect() called
usb-storage: usb_stor_stop_transport called
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: device_reset called
usb-storage: usb_stor_Bulk_reset called
usb-storage: No reset during disconnect
usb-storage: bus_reset called
usb-storage: unable to lock device for reset: -19
scsi 0:0:0:0: scsi: Device offlined - not ready after error recovery
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: queuecommand called
usb-storage: Fail command during disconnect
usb-storage: device scan complete
usb-storage: -- usb_stor_release_resources
usb-storage: -- sending exit command to thread
usb-storage: -- dissociate_dev
usb 1-1:1.0: uevent
usbdev1.2_ep00: ep_device_release called for usbdev1.2_ep00
usb 1-1: uevent
usb-storage: *** thread awakened.
usb-storage: -- exiting
ehci_hcd 0000:00:1d.7: GetStatus port 1 status 001002 POWER sig=se0 CSC