e100: peth0: e100_watchdog: link up, 100Mbps, full-duplex
ADDRCONF(NETDEV_CHANGE): peth0: link becomes ready
device peth0 entered promiscuous mode
xenbr0: port 2(peth0) entering learning state
xenbr0: topology change detected, propagating
xenbr0: port 2(peth0) entering forwarding state
[drm] Initialized drm 1.0.1 20051102
ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 17
[drm] Initialized i915 1.5.0 20060119 on minor 0
eth0: no IPv6 routers present
eth0: no IPv6 routers present
eth0: no IPv6 routers present
e100: peth0: e100_watchdog: link down
xenbr0: port 2(peth0) entering disabled state
e100: peth0: e100_watchdog: link up, 100Mbps, full-duplex
xenbr0: port 2(peth0) entering learning state
xenbr0: topology change detected, propagating
xenbr0: port 2(peth0) entering forwarding state
Warning: Processor Platform Limit event detected, but not handled.
Consider compiling CPUfreq support into your kernel.