rendered paste bodyroot@OpenWrt:/dev# lsmod
Module Size Used by Tainted: P
proc_gpio 1488 0
usb_storage 67024 0
sd_mod 12400 0
scsi_mod 67040 2 usb_storage,sd_mod
ehci_hcd 28240 0
ath_ahb 77968 0
wlan_xauth 480 0
wlan_wep 4512 0
wlan_tkip 10720 2
wlan_ccmp 6304 0
wlan_acl 2496 0
ath_rate_sample 8640 1 ath_ahb
ath_hal 176736 3 ath_ahb,ath_rate_sample
wlan_scan_sta 9600 0
wlan_scan_ap 3040 1
wlan 148832 10 ath_ahb,wlan_xauth,wlan_wep,wlan_tkip,wlan_ccmp,wlan_acl,ath_rate_sample,wlan_scan_sta,wlanp
ip_conntrack_tftp 1648 0
ip_nat_irc 896 0
ip_conntrack_irc 2800 1 ip_nat_irc
ip_nat_ftp 1632 0
ip_conntrack_ftp 3824 1 ip_nat_ftp
ipt_TTL 896 0
ipt_ttl 736 0
ipt_TOS 800 0
ipt_time 1536 0
ipt_tos 544 0
xt_MARK 960 16
xt_mark 640 16
xt_mac 736 0
xt_length 704 5
ipt_ECN 1472 0
ipt_ecn 1024 0
xt_CLASSIFY 640 0
imq 2160 0
ipt_IMQ 672 0
ipt_layer7 9776 2
ipt_ipp2p 6784 1
xt_NOTRACK 832 0
iptable_raw 608 0
xt_portscan 1984 0
xt_DELUDE 3392 0
xt_string 896 0
ipt_recent 4960 0
xt_pkttype 704 0
ipt_owner 800 0
ipt_LOG 4736 0
xt_connbytes 1408 0
xt_helper 832 0
xt_CONNMARK 992 2
xt_connmark 704 0
tun 6432 0
ppp_async 9504 0
ppp_generic 23904 1 ppp_async
slhc 4608 1 ppp_generic
crc_ccitt 1024 1 ppp_async
vfat 8608 0
fat 43408 1 vfat
usbcore 103136 3 usb_storage,ehci_hcd
nls_base 4576 2 vfat,fat
root@OpenWrt:/dev# dmesg
Linux version 2.6.19.2 (albert@albert-laptop) (gcc version 4.1.2) #1 Fri May 25 11:38:32 CEST 2007
CPU revision is: 00019064
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
On node 0 totalpages: 8192
DMA zone: 64 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 8128 pages, LIFO batch:0
Normal zone: 0 pages used for memmap
Built 1 zonelists. Total pages: 8128
Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 init=/etc/preinit
Primary instruction cache 16kB, physically tagged, 4-way, linesize 16 bytes.
Primary data cache 16kB, 4-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 128 (order: 7, 512 bytes)
Using 92.000 MHz high precision timer.
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 29716k/32768k available (1989k kernel code, 3052k reserved, 298k data, 112k init, 0k highmem)
Calibrating delay loop... 183.50 BogoMIPS (lpj=917504)
Mount-cache hash table entries: 512
Checking for 'wait' instruction... available.
NET: Registered protocol family 16
Radio config found at offset 0xf8(0x1f8)
AR531x PCI init... done
PCI: device 0000:00:01.0 has unknown header type 60, ignoring.
PCI: device 0000:00:02.0 has unknown header type 60, ignoring.
PCI: fixing up device 0,3,0
PCI: Failed to allocate mem resource #1:4000000@84000000 for 0000:00:03.0
NET: Registered protocol family 2
IP route cache hash table entries: 256 (order: -2, 1024 bytes)
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 1024 bind 512)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xb1100003 (irq = 37) is a 16550A
PHY ID: 0000:0000
eth0: Dropping NETIF_F_SG since no checksum feature.
eth0: Atheros AR231x: 00:30:ab:28:38:98, irq 4
Initialising Marvell switch... done.
cmdlinepart partition parsing not available
Searching for RedBoot partition table in spiflash at offset 0x7d0000
Searching for RedBoot partition table in spiflash at offset 0x7e0000
9 RedBoot partitions found on MTD device spiflash
Creating 9 MTD partitions on "spiflash":
0x00000000-0x00030000 : "RedBoot"
0x00030000-0x00040000 : "loader"
0x00040000-0x00660000 : "image"
0x000efa0f-0x00650000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x00290000-0x00650000 : "rootfs_data"
0x00650000-0x00660000 : "config"
0x00660000-0x00710000 : "image2"
0x007e0000-0x007ef000 : "FIS directory"
0x007ef000-0x007f0000 : "RedBoot config"
0x007f0000-0x00800000 : "board_config"
ip_conntrack version 2.4 (256 buckets, 2048 max) - 240 bytes per conntrack
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Time: MIPS clocksource has been installed.
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 112k freed
Warning: unable to open an initial console.
Algorithmics/MIPS FPU Emulator v1.5
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PPP generic driver version 2.4.2
eth0.0: dev_set_promiscuity(master, 1)
device eth0 entered promiscuous mode
device eth0.0 entered promiscuous mode
eth0.1: add 01:00:5e:00:00:01 mcast address to master interface
tun: Universal TUN/TAP device driver, 1.6
tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
xt_CHAOS: Could not find "TARPIT" target
br-lan: port 1(eth0.0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0.0) entering forwarding state
IPP2P v0.8.1_rc1 loading
IMQ starting with 2 devices...
IMQ driver loaded successfully.
Hooking IMQ before NAT on PREROUTING.
Hooking IMQ after NAT on POSTROUTING.
ipt_time loading
wlan: 0.8.4.2 (0.9.2.1)
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.17.1 (AR5212, AR5312, RF5112, RF2316, RF2317, TX_DESC_SWAP)
ath_rate_sample: 1.2 (0.9.2.1)
wlan: mac acl policy registered
ath_ahb: 0.9.4.5 (0.9.2.1)
ath_pci: switching rfkill capability off
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
wifi0: mac 11.0 phy 4.8 radio 7.0
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons
wifi0: Atheros 2315 WiSoC: mem=0xb0000000, irq=3
PCI: Enabling device 0000:00:00.1 (0000 -> 0002)
ehci_hcd 0000:00:00.1: EHCI Host Controller
ehci_hcd 0000:00:00.1: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:00.1: irq 5, io mem 0x80c21000
ehci_hcd 0000:00:00.1: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
SCSI subsystem initialized
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
gpio_proc: module loaded and /proc/gpio/ created
device ath1 entered promiscuous mode
br-lan: port 2(ath1) entering learning state
br-lan: topology change detected, propagating
br-lan: port 2(ath1) entering forwarding state
br-lan: port 2(ath1) entering disabled state
device ath1 left promiscuous mode
br-lan: port 2(ath1) entering disabled state
device ath1 entered promiscuous mode
br-lan: port 2(ath1) entering learning state
br-lan: topology change detected, propagating
br-lan: port 2(ath1) entering forwarding state
usb 1-1: new high speed USB device using ehci_hcd and address 2
usb 1-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
scsi 0:0:0:0: Direct-Access HTC42604 0G9AT00 PQ: 0 ANSI: 0
SCSI device sda: 78140160 512-byte hdwr sectors (40008 MB)
sda: Write Protect is off
sda: Mode Sense: 33 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 78140160 512-byte hdwr sectors (40008 MB)
sda: Write Protect is off
sda: Mode Sense: 33 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 0:0:0:0: Attached scsi disk sda
usb-storage: device scan complete
usb 1-1: USB disconnect, address 2
usb 1-1: new high speed USB device using ehci_hcd and address 3
usb 1-1: configuration #1 chosen from 1 choice
scsi1 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
scsi 1:0:0:0: Direct-Access Kingston DataTraveler 2.0 PMAP PQ: 0 ANSI: 0 CCS
SCSI device sda: 1953792 512-byte hdwr sectors (1000 MB)
sda: Write Protect is off
sda: Mode Sense: 23 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 1953792 512-byte hdwr sectors (1000 MB)
sda: Write Protect is off
sda: Mode Sense: 23 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 1:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete