rendered paste bodytitle=Xen2
root (hd0,0)
kernel /xen.gz dom0_mem=98M
module /vmlinuz-2.6.16.49-xen2 root=/dev/sdb3 doscsi
xen0-1 linux-2.6.16.33-xen # fdisk /dev/sdb
The number of cylinders for this disk is set to 4376.
There is nothing wrong with that, but this is larger than 1024,
and could in certain setups cause problems with:
1) software that runs at boot time (e.g., old versions of LILO)
2) booting and partitioning software from other OSs
(e.g., DOS FDISK, OS/2 FDISK)
Command (m for help): p
Disk /dev/sdb: 35.9 GB, 35999711232 bytes
255 heads, 63 sectors/track, 4376 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sdb1 1 13 104391 83 Linux
/dev/sdb2 14 274 2096482+ 82 Linux swap / Solaris
/dev/sdb3 275 4376 32949315 83 Linux
Command (m for help):
Fusion MPT SAS Host driver 3.04.02
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 16 (level, low) -> IRQ 16
mptbase: Initiating ioc0 bringup
scsi 1:0:0:0: CD-ROM MATSHITA UJDA770 DVD/CDRW 1.20 PQ: 0 ANSI: 0
sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.20
sr 1:0:0:0: Attached scsi CD-ROM sr0
sr 1:0:0:0: Attached scsi generic sg0 type 5
usb-storage: device scan complete
scsi 0:0:0:0: Direct-Access TEAC FD-05PUB 3200 PQ: 0 ANSI: 0 CCS
sd 0:0:0:0: Attached scsi removable disk sda
sd 0:0:0:0: Attached scsi generic sg1 type 0
usb-storage: device scan complete
ioc0: SAS1064E: Capabilities={Initiator}
PCI: Setting latency timer of device 0000:02:00.0 to 64
scsi6 : ioc0: LSISAS1064E, FwRev=000a0f00h, Ports=1, MaxQ=511, IRQ=16
scsi 6:0:0:0: Direct-Access IBM-ESXS ST936701SS B51D PQ: 0 ANSI: 5
scsi 6:0:0:0: Attached scsi generic sg2 type 0
scsi 6:0:1:0: Direct-Access IBM-ESXS ST936701SS B51D PQ: 0 ANSI: 5
scsi 6:0:1:0: Attached scsi generic sg3 type 0
scsi 6:1:0:0: Direct-Access LSILOGIC Logical Volume 3000 PQ: 0 ANSI: 2