Linux version 2.6.19.2 (florian@dorelei) (gcc version 4.1.2) #4 Fri May 11 16:24:44 CEST 2007
ADM5120 revision 8, running at 175MHz
Boot loader is: CFE
Booted from : NOR flash
Board is : Compex WP54G-WRT
GETENV: envname is memsize
GETENV: returning 0x001000000
CPU revision is: 0001800b
ADM5120 board setup
Determined physical RAM map:
memory: 00d47000 @ 002b9000 (usable)
Initrd not found or empty - disabling initrd
Built 1 zonelists. Total pages: 4064
Kernel command line: console=ttyS0,115200 rootfs=jffs2,squashfs init=/etc/preinit
Primary instruction cache 8kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
start_kernel(): bug: interrupts were enabled early
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 13448k/13596k available (2217k kernel code, 148k reserved, 334k data, 124k init, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction... available.
NET: Registered protocol family 16
adm5120: system has PCI BIOS
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 128 (order: -3, 512 bytes)
TCP established hash table entries: 512 (order: -1, 2048 bytes)
TCP bind hash table entries: 256 (order: -2, 1024 bytes)
TCP: Hash tables configured (established 512 bind 256)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2006 Red Hat, Inc.
yaffs May 11 2007 13:47:20 Installing.
io scheduler noop registered
io scheduler deadline registered (default)
Registered led device: adm5120:led
ttyS0 at I/O 0x12600000 (irq = 1) is a ADM5120
ttyS1 at I/O 0x12800000 (irq = 2) is a ADM5120
eth0: ADM5120 switch port0
eth1: ADM5120 switch port1
adm5120 : flash init : 0x1fc00000 0x00400000
adm5120 physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Flash device: 0x400000 at 0x1fc00000
adm5120 : using CFE flash mapping
bootloader size: 327680
Creating 4 MTD partitions on "adm5120 physically mapped flash":
0x00000000-0x00050000 : "cfe"
0x00050000-0x003f0000 : "linux"
0x00117800-0x003f0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x00220000-0x003f0000 : "rootfs_data"
0x003f0000-0x00400000 : "nvram"
block2mtd: version $Revision: 1.30 $
RB1xx nand
No NAND device found!!!
No NAND device found!!!
No NAND device found!!!
No NAND device found!!!
RB1xxx nand device not found
ip_conntrack version 2.4 (106 buckets, 848 max) - 240 bytes per conntrack
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 124k freed
Warning: unable to open an initial console.
Algorithmics/MIPS FPU Emulator v1.5
Node at 0x0001ffe8 with length 0x0000002c would run over the end of the erase block
Perhaps the file system was created with the wrong erase size?
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0001ffec: 0x002c instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0001fff0: 0x565f instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0001fff4: 0x00e4 instead
Node at 0x0003fd2c with length 0x0000064d would run over the end of the erase block
Perhaps the file system was created with the wrong erase size?
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd30: 0x064d instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd34: 0xc825 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd38: 0x0155 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd3c: 0x0020 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd40: 0x81ed instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd48: 0xfe2f instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd4c: 0x3b4b instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd50: 0x3b4b instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd54: 0x3b4b instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0003fd58: 0xe000 instead
Further such events for this erase block will not be printed
Node at 0x0005faa4 with length 0x00000822 would run over the end of the erase block
Perhaps the file system was created with the wrong erase size?
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005faa8: 0x0822 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005faac: 0x027a instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fab0: 0x0158 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fab4: 0x0004 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fab8: 0x81ed instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fac0: 0xd62f instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fac4: 0x3b80 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fac8: 0x3b80 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005facc: 0x3b80 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0005fad0: 0x3000 instead
Further such events for this erase block will not be printed
Node at 0x0007f8cc with length 0x000008f7 would run over the end of the erase block
Perhaps the file system was created with the wrong erase size?
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8d0: 0x08f7 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8d4: 0x4bd1 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8d8: 0x015f instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8dc: 0x001b instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8e0: 0x81ed instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8e8: 0xe397 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8ec: 0x3be4 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8f0: 0x3be4 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8f4: 0x3be4 instead
jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0007f8f8: 0xa000 instead
Further such events for this erase block will not be printed
JFFS2 notice: (1720) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xre.
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
init started: BusyBox v1.4.2 (2007-05-11 13:42:08 CEST) multi-call binary
Please press Enter to activate this console.
BusyBox v1.4.2 (2007-05-11 13:42:08 CEST) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
KAMIKAZE (bleeding edge, r7179) -------------------
* 10 oz Vodka Shake well with ice and strain
* 10 oz Triple sec mixture into 10 shot glasses.
* 10 oz lime juice Salute!
---------------------------------------------------
root@OpenWrt:/# PPP generic driver version 2.4.2
wlan: 0.8.4.2 (0.9.2.1)
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413, REGOPS_FUNC)
ath_rate_sample: 1.2 (0.9.2.1)
wlan: mac acl policy registered
ath_pci: 0.9.4.5 (0.9.2.1)
ath_pci: switching rfkill capability off
wifi0: 11a rates: 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
wifi0: mac 10.4 phy 6.1 radio 6.3