rendered paste bodyLinux version 2.6.20-gentoo-r8 (root@myhost) (gcc version 4.1.1 (Gentoo 4.1.1-r3)) #1 Wed May 9 10:18:44 Local time zone must be set--see zic manua
BIOS-provided physical RAM map:
sanitize start
sanitize end
copy_e820_map() start: 0000000000000000 size: 00000000000a0000 end: 00000000000a0000 type: 1
copy_e820_map() type is E820_RAM
copy_e820_map() start: 00000000000f0000 size: 0000000000010000 end: 0000000000100000 type: 2
copy_e820_map() start: 0000000000100000 size: 000000001fdf0000 end: 000000001fef0000 type: 1
copy_e820_map() type is E820_RAM
copy_e820_map() start: 000000001fef0000 size: 0000000000003000 end: 000000001fef3000 type: 4
copy_e820_map() start: 000000001fef3000 size: 000000000000d000 end: 000000001ff00000 type: 3
copy_e820_map() start: 00000000ffb00000 size: 0000000000500000 end: 0000000100000000 type: 2
BIOS-e820: 0000000000000000 - 00000000000a0000 (usable)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000001fef0000 (usable)
BIOS-e820: 000000001fef0000 - 000000001fef3000 (ACPI NVS)
BIOS-e820: 000000001fef3000 - 000000001ff00000 (ACPI data)
BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved)
510MB LOWMEM available.
Entering add_active_range(0, 0, 130800) 0 entries of 256 used
Zone PFN ranges:
DMA 0 -> 4096
Normal 4096 -> 130800
early_node_map[1] active PFN ranges
0: 0 -> 130800
On node 0 totalpages: 130800
DMA zone: 32 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 4064 pages, LIFO batch:0
Normal zone: 989 pages used for memmap
Normal zone: 125715 pages, LIFO batch:31
DMI 2.2 present.
Allocating PCI resources starting at 20000000 (gap: 1ff00000:dfc00000)
Detected 1002.347 MHz processor.
Built 1 zonelists. Total pages: 129779
Kernel command line: ip=dhcp root=/dev/nfs nfsroot=192.168.0.6:/!/circle/nest/helix
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Initializing CPU#0
PID hash table entries: 2048 (order: 11, 8192 bytes)
Console: colour VGA+ 80x25
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 514628k/523200k available (2253k kernel code, 8024k reserved, 773k data, 180k init, 0k highmem)
virtual kernel memory layout:
fixmap : 0xffffd000 - 0xfffff000 ( 8 kB)
vmalloc : 0xe0800000 - 0xffffb000 ( 503 MB)
lowmem : 0xc0000000 - 0xdfef0000 ( 510 MB)
.init : 0xc03f8000 - 0xc0425000 ( 180 kB)
.data : 0xc0333722 - 0xc03f4ec4 ( 773 kB)
.text : 0xc0100000 - 0xc0333722 (2253 kB)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 2005.57 BogoMIPS (lpj=10027882)
Security Framework v1.0.0 initialized
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 0387f9ff 00000000 00000000 00000000 00000000 00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
CPU serial number disabled.
CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 0a
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfb370, last bus=1
PCI: Using configuration type 1
Setting up standard PCI resources
SCSI subsystem initialized
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Boot video device is 0000:00:02.0
PCI quirk: region 4000-407f claimed by ICH4 ACPI/GPIO/TCO
PCI quirk: region 4080-40bf claimed by ICH4 GPIO
PCI: Firmware left 0000:01:03.0 e100 interrupts enabled, disabling
PCI: Firmware left 0000:01:05.0 e100 interrupts enabled, disabling
PCI: Transparent bridge - 0000:00:1e.0
PCI: Using IRQ router PIIX/ICH [8086/2440] at 0000:00:1f.0
PCI: setting IRQ 11 as level-triggered
PCI: Found IRQ 11 for device 0000:00:1f.3
PCI: Sharing IRQ 11 with 0000:01:02.0
PCI: Ignore bogus resource 6 [0:0] of 0000:00:02.0
PCI: Bridge: 0000:00:1e.0
IO window: 9000-afff
MEM window: d4000000-d5ffffff
PREFETCH window: 20000000-202fffff
PCI: Setting latency timer of device 0000:00:1e.0 to 64
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 16384 bytes)
TCP established hash table entries: 16384 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 16384 bind 8192)
TCP reno registered
IA-32 Microcode Update Driver: v1.14a <tigran@aivazian.fsnet.co.uk>
Total HugeTLB memory allocated, 0
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Real Time Clock Driver v1.12ac
intel_rng: FWH not detected
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
floppy0: no floppy controllers found
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
nbd: registered device at major 43
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
PCI: setting IRQ 12 as level-triggered
PCI: Found IRQ 12 for device 0000:01:03.0
eth0: OEM i82557/i82558 10/100 Ethernet, 00:50:8D:1C:3C:18, IRQ 12.
Board assembly 727095-004, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x04f4518b).
PCI: setting IRQ 10 as level-triggered
PCI: Found IRQ 10 for device 0000:01:05.0
eth1: OEM i82557/i82558 10/100 Ethernet, 00:50:8D:1C:3C:19, IRQ 10.
Board assembly 727095-004, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x04f4518b).
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH2: IDE controller at PCI slot 0000:00:1f.1
ICH2: chipset revision 5
ICH2: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide0...
hda: IC35L180AVV207-1, ATA DISK drive
hda: hw_config=600b
hda: hw_config=600b
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
HPT372: IDE controller at PCI slot 0000:01:02.0
PCI: Found IRQ 11 for device 0000:01:02.0
PCI: Sharing IRQ 11 with 0000:00:1f.3
HPT372: chipset revision 5
HPT372: 100% native mode on irq 11
HPT37X: using 33MHz PCI clock
ide2: BM-DMA at 0xa000-0xa007, BIOS settings: hde:DMA, hdf:pio
ide3: BM-DMA at 0xa008-0xa00f, BIOS settings: hdg:pio, hdh:pio
Probing IDE interface ide2...
hde: IC35L180AVV207-1, ATA DISK drive
hde: hw_config=600b
hde: hw_config=600b
ide2 at 0x9000-0x9007,0x9402 on irq 11
Probing IDE interface ide3...
Probing IDE interface ide1...
Probing IDE interface ide3...
serio: i8042 KBD port at 0x60,0x64 irq 1
mice: PS/2 mouse device common for all mice
input: AT Translated Set 2 keyboard as /class/input/input0
i2c /dev entries driver
i810_smbus 0000:00:02.0: i810/i815 i2c device found.
md: linear personality registered for level -1
md: raid0 personality registered for level 0
md: raid1 personality registered for level 1
raid6: int32x1 300 MB/s
raid6: int32x2 342 MB/s
raid6: int32x4 280 MB/s
raid6: int32x8 259 MB/s
raid6: mmxx1 942 MB/s
raid6: mmxx2 1142 MB/s
raid6: sse1x1 788 MB/s
raid6: sse1x2 1120 MB/s
raid6: using algorithm sse1x2 (1120 MB/s)
md: raid6 personality registered for level 6
md: raid5 personality registered for level 5
md: raid4 personality registered for level 4
raid5: automatically using best checksumming function: pIII_sse
pIII_sse : 2034.400 MB/sec
raid5: using function: pIII_sse (2034.400 MB/sec)
device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
Time: tsc clocksource has been installed.
Sending DHCP requests ., OK
IP-Config: Got DHCP answer from 192.168.0.6, my address is 192.168.0.3
IP-Config: Complete:
device=eth0, addr=192.168.0.3, mask=255.255.255.0, gw=192.168.0.1,
host=192.168.0.3, domain=mydomain.org, nis-domain=(none),
bootserver=192.168.0.6, rootserver=192.168.0.6, rootpath=/!/circle/nest/helix
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
Looking up port of RPC 100003/2 on 192.168.0.6
Looking up port of RPC 100005/1 on 192.168.0.6
VFS: Mounted root (nfs filesystem) readonly.
Freeing unused kernel memory: 180k freed
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: Detected an Intel i815 Chipset.
agpgart: AGP aperture is 64M @ 0xd0000000
helix ~ # fdisk /dev/hda
Unable to open /dev/hda
helix ~ # fdisk /dev/hde
Unable to open /dev/hde