rendered paste bodyUniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 0000:00:0f.1
PCI: VIA IRQ fixup for 0000:00:0f.1, from 255 to 4
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:pio, hdb:pio
Probing IDE interface ide0...
Probing IDE interface ide0...
Probing IDE interface ide1...
libata version 2.00 loaded.
sata_via 0000:00:0f.0: version 2.0
sata_via 0000:00:0f.0: routed to hard irq line 11
ata1: SATA max UDMA/133 cmd 0xF800 ctl 0xF402 bmdma 0xE800 irq 20
ata2: SATA max UDMA/133 cmd 0xF000 ctl 0xEC02 bmdma 0xE808 irq 20
scsi0 : sata_via
ata1: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
ata1.00: ATA-7, max UDMA/133, 312581808 sectors: LBA48 NCQ (depth 0/32)
ata1.00: ata1: dev 0 multi count 16
ata1.00: configured for UDMA/133
scsi1 : sata_via
ata2: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
ata2.00: ATA-7, max UDMA/133, 312581808 sectors: LBA48 NCQ (depth 0/32)
ata2.00: ata2: dev 0 multi count 16
ata2.00: configured for UDMA/133
Vendor: ATA Model: ST3160812AS Rev: 3.AA
Type: Direct-Access ANSI SCSI revision: 05
Vendor: ATA Model: ST3160812AS Rev: 3.AA
Type: Direct-Access ANSI SCSI revision: 05
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
SCSI device sda: 312581808 512-byte hdwr sectors (160042 MB)
sda: Write Protect is off
sda: Mode Sense: 00 3a 00 00
SCSI device sda: drive cache: write back
sda: sda1 sda2 sda3 sda4
sd 0:0:0:0: Attached scsi disk sda
SCSI device sdb: 312581808 512-byte hdwr sectors (160042 MB)
sdb: Write Protect is off
sdb: Mode Sense: 00 3a 00 00
SCSI device sdb: drive cache: write back
SCSI device sdb: 312581808 512-byte hdwr sectors (160042 MB)
sdb: Write Protect is off
sdb: Mode Sense: 00 3a 00 00
SCSI device sdb: drive cache: write back
sdb: sdb1 sdb2
sd 1:0:0:0: Attached scsi disk sdb
sd 0:0:0:0: Attached scsi generic sg0 type 0
sd 1:0:0:0: Attached scsi generic sg1 type 0
PNP: No PS/2 controller found. Probing ports directly.
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
hwmon-vid: Unknown VRM version of your x86 CPU
md: raid0 personality registered for level 0
md: raid1 personality registered for level 1
md: multipath personality registered for level -4
md: faulty personality registered for level -5
md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: bitmap version 4.39
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised: dm-devel@redhat.com
EDAC MC: Ver: 2.0.1 Oct 15 2006
EDAC DEBUG: edac_sysfs_memctrl_setup()
EDAC DEBUG: Registered '.../edac/mc' kobject
EDAC DEBUG: edac_sysfs_pci_setup()
EDAC DEBUG: Registered '.../edac/pci' kobject
padlock: No VIA PadLock drivers have been loaded.
padlock: Using VIA PadLock ACE for AES algorithm.
padlock: Fallback for 'sha1' is driver 'sha1-generic' (prio=0)
padlock: Fallback for 'sha256' is driver 'sha256-generic' (prio=0)
padlock: Using VIA PadLock ACE for SHA1/SHA256 algorithms.
TCP bic registered
Initializing IPsec netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Using IPI Shortcut mode
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
md: Autodetecting RAID arrays.
Time: tsc clocksource has been installed.
md: autorun ...
md: considering sdb1 ...
md: adding sdb1 ...
md: adding sda4 ...
md: created md0
md: bind<sda4>
md: bind<sdb1>
md: running: <sdb1><sda4>
md0: setting max_sectors to 128, segment boundary to 32767
raid0: looking at sdb1
raid0: comparing sdb1(128536000) with sdb1(128536000)
raid0: END
raid0: ==> UNIQUE
raid0: 1 zones
raid0: looking at sda4
raid0: comparing sda4(128536000) with sdb1(128536000)
raid0: EQUAL
raid0: FINAL 1 zones
raid0: done.
raid0 : md_size is 257072000 blocks.
raid0 : conf->hash_spacing is 257072000 blocks.
raid0 : nb_zone is 1.
raid0 : Allocating 4 bytes for hash.
md: ... autorun DONE.
RAMDISK: Compressed image found at block 0
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 204k freed
EXT2-fs warning: checktime reached, running e2fsck is recommended
input: AT Translated Set 2 keyboard as /class/input/input0
Velocity is AUTO mode
input: AT Translated Set 2 keyboard as /class/input/input1
eth0: Link autonegation speed 100M bps full duplex
w83697hf/hg WDT: WDT driver for W83697HF/HG initializing
w83697hf/hg WDT: Looking for watchdog at address 0x4e
w83697hf/hg WDT: watchdog found at address 0x4e
w83697hf/hg WDT: initialized. timeout=60 sec (nowayout=0)
ReiserFS: sda3: warning: sh-2021: reiserfs_fill_super: can not find reiserfs on sda3
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda3, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
ReiserFS: sda1: warning: sh-2021: reiserfs_fill_super: can not find reiserfs on sda1
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda1, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
ReiserFS: sdb2: warning: sh-2021: reiserfs_fill_super: can not find reiserfs on sdb2
kjournald starting. Commit interval 5 seconds
EXT3 FS on sdb2, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
ReiserFS: md0: warning: sh-2021: reiserfs_fill_super: can not find reiserfs on md0
kjournald starting. Commit interval 5 seconds
EXT3 FS on md0, internal journal
EXT3-fs: mounted filesystem with ordered data mode.