rendered paste bodymdione@luxury:~$ sudo smartctl -a /dev/hdb
smartctl version 5.32 Copyright (C) 2002-4 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Device Model: WDC WD600AB-00BVA0
Serial Number: WD-WMA7E1062591
Firmware Version: 21.01H21
Device is: In smartctl database [for details use: -P show]
ATA Version is: 5
ATA Standard is: Exact ATA specification draft version not indicated
Local Time is: Tue Feb 21 21:06:01 2006 ART
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x84) Offline data collection activity
was suspended by an interrupting command from host.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: (3168) seconds.
Offline data collection
capabilities: (0x3b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
No Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 56) minutes.
Conveyance self-test routine
recommended polling time: ( 5) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 195 174 051 Pre-fail Always - 164
3 Spin_Up_Time 0x0007 121 109 021 Pre-fail Always - 3041
4 Start_Stop_Count 0x0032 100 100 040 Old_age Always - 450
5 Reallocated_Sector_Ct 0x0032 199 199 112 Old_age Always - 2
7 Seek_Error_Rate 0x000b 200 200 051 Pre-fail Always - 0
9 Power_On_Hours 0x0032 054 054 000 Old_age Always - 33959
10 Spin_Retry_Count 0x0013 100 100 051 Pre-fail Always - 0
11 Calibration_Retry_Count 0x0013 100 100 051 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 447
196 Reallocated_Event_Count 0x0032 198 198 000 Old_age Always - 2
197 Current_Pending_Sector 0x0012 200 199 000 Old_age Always - 2
198 Offline_Uncorrectable 0x0012 200 199 000 Old_age Always - 0
199 UDMA_CRC_Error_Count 0x000a 200 253 000 Old_age Always - 109
200 Multi_Zone_Error_Rate 0x0009 181 126 051 Pre-fail Offline - 232
SMART Error Log Version: 1
ATA Error Count: 59 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 59 occurred at disk power-on lifetime: 118 hours (4 days + 22 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 02 07 06 00 e0 Error: UNC 2 sectors at LBA = 0x00000607 = 1543
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 02 06 06 00 e0 00 00:53:31.150 READ DMA
c8 00 04 04 06 00 e0 00 00:53:25.850 READ DMA
c8 00 06 02 06 00 e0 00 00:53:20.750 READ DMA
c8 00 08 00 06 00 e0 00 00:53:15.500 READ DMA
c8 00 80 80 07 00 e0 00 00:53:15.450 READ DMA
Error 58 occurred at disk power-on lifetime: 118 hours (4 days + 22 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 04 05 06 00 e0 Error: UNC 4 sectors at LBA = 0x00000605 = 1541
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 04 04 06 00 e0 00 00:53:25.850 READ DMA
c8 00 06 02 06 00 e0 00 00:53:20.750 READ DMA
c8 00 08 00 06 00 e0 00 00:53:15.500 READ DMA
c8 00 80 80 07 00 e0 00 00:53:15.450 READ DMA
c8 00 80 00 07 00 e0 00 00:53:15.450 READ DMA
Error 57 occurred at disk power-on lifetime: 118 hours (4 days + 22 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 06 05 06 00 e0 Error: UNC 6 sectors at LBA = 0x00000605 = 1541
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 06 02 06 00 e0 00 00:53:20.750 READ DMA
c8 00 08 00 06 00 e0 00 00:53:15.500 READ DMA
c8 00 80 80 07 00 e0 00 00:53:15.450 READ DMA
c8 00 80 00 07 00 e0 00 00:53:15.450 READ DMA
c8 00 02 06 06 00 e0 00 00:53:07.300 READ DMA
Error 56 occurred at disk power-on lifetime: 118 hours (4 days + 22 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 05 06 00 e0 Error: UNC 8 sectors at LBA = 0x00000605 = 1541
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 00 06 00 e0 00 00:53:15.500 READ DMA
c8 00 80 80 07 00 e0 00 00:53:15.450 READ DMA
c8 00 80 00 07 00 e0 00 00:53:15.450 READ DMA
c8 00 02 06 06 00 e0 00 00:53:07.300 READ DMA
c8 00 04 04 06 00 e0 00 00:53:02.050 READ DMA
Error 55 occurred at disk power-on lifetime: 118 hours (4 days + 22 hours)
When the command that caused the error occurred, the device was doing SMART Offline or Self-test.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 02 07 06 00 e0 Error: UNC 2 sectors at LBA = 0x00000607 = 1543
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 02 06 06 00 e0 00 00:53:07.300 READ DMA
c8 00 04 04 06 00 e0 00 00:53:02.050 READ DMA
c8 00 06 02 06 00 e0 00 00:52:56.800 READ DMA
c8 00 08 00 06 00 e0 00 00:52:51.550 READ DMA
c8 00 80 80 06 00 e0 00 00:52:51.550 READ DMA
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Conveyance offline Completed without error 00% 119 -
Device does not support Selective Self Tests/Logging