Unnamed

#!/bin/sh
#============================================================================
# /etc/xen/vif-route
#
# Script for configuring a vif in routed mode.
# The hotplugging system will call this script if it is specified either in
# the device configuration given to Xend, or the default Xend configuration
# in /etc/xen/xend-config.sxp.  If the script is specified in neither of those
# places, then vif-bridge is the default.
#
# Usage:
# vif-route (add|remove|online|offline)
#
# Environment vars:
# vif         vif interface name (required).
# XENBUS_PATH path to this device's details in the XenStore (required).
#
# Read from the store:
# ip      list of IP networks for the vif, space-separated (default given in
#         this script).
#============================================================================

dir=$(dirname "$0")
. "$dir/vif-common.sh"

main_ip=$(dom0_ip)

case "$command" in
    online)
        ifconfig ${vif} ${main_ip} netmask 255.255.255.255 up
        echo 1 >/proc/sys/net/ipv4/conf/${vif}/proxy_arp
        ipcmd='add'
        cmdprefix=''
        ;;
    offline)
        do_without_error ifdown ${vif}
        ipcmd='del'
        cmdprefix='do_without_error'
        ;;
esac

if [ "${ip}" ] ; then
    # If we've been given a list of IP addresses, then add routes from dom0 to
    # the guest using those addresses.
    for addr in ${ip} ; do
      ${cmdprefix} ip route ${ipcmd} ${addr} dev ${vif} src ${main_ip}
    done 
fi

handle_iptable

log debug "Successful vif-route $command for $vif."
if [ "$command" = "online" ]
then
  success
fi



##########CUTHERE##CUTHERE##CUTHERE##############


#!/bin/sh
#============================================================================
# Default Xen network start/stop script.
# Xend calls a network script when it starts.
# The script name to use is defined in /etc/xen/xend-config.sxp
# in the network-script field.
#
# Usage:
#
# network-route (start|stop|status) {VAR=VAL}*
#
# Vars:
#
# netdev     The gateway interface (default eth0).
# antispoof  Whether to use iptables to prevent spoofing (default yes).
#
#============================================================================

dir=$(dirname "$0")
. "$dir/xen-script-common.sh"

evalVariables "$@"

netdev=${netdev:-eth${vifnum}}

echo 1 >/proc/sys/net/ipv4/ip_forward
echo 1 >/proc/sys/net/ipv4/conf/${netdev}/proxy_arp