Section "InputDevice"
# Identifier and driver
Identifier "Mouse1"
Driver "mouse"
# The mouse protocol and device. The device is normally set to /dev/mouse,
# which is usually a symbolic link to the real device.
Option "Protocol" "Imps/2"
Option "Device" "/dev/input/mice"
# On platforms where PnP mouse detection is supported the following
# protocol setting can be used when using a newer PnP mouse:
# Option "Protocol" "Auto"
# When using mouse connected to a PS/2 port (aka "MousePort"), set the
# the protocol as follows. On some platforms some other settings may
# be available.
# Option "Protocol" "PS/2"
# When using XQUEUE (only for SVR3 and SVR4, but not Solaris), use
# the following instead of any of the lines above. The Device line
# is not required in this case.
# Option "Protocol" "Xqueue"
# Baudrate and SampleRate are only for some older Logitech mice. In
# almost every case these lines should be omitted.
# Option "BaudRate" "9600"
# Option "SampleRate" "150"
# Emulate3Buttons is an option for 2-button mice
# Emulate3Timeout is the timeout in milliseconds (default is 50ms)
# Option "Emulate3Buttons"
# Option "Emulate3Timeout" "50"
# ChordMiddle is an option for some 3-button Logitech mice, or any
# 3-button mouse where the middle button generates left+right button
# events.
# Option "ChordMiddle"
EndSection