rendered paste bodyCFE version 1.2.5 for WP54G (32bit,SP,LE,MIPS)
Build Date: Wed Aug 16 09:09:30 SGT 2006 (ttyaw@linux01)
Initializing Arena.
Initializing PCI. [normal]
PCI bus 0 slot 0/0: ADMtek ADM5120 Host Bridge (host bridge)
Initializing Devices.
CPU type 0x1800B: 175MHz
Total memory: 0x1000000 bytes (16MB)
Total memory used by CFE: 0x80F83000 - 0x80FFFAE0 (510688)
Initialized Data: 0x80FBA824 - 0x80FBCA50 (8748)
BSS Area: 0x80FBCA50 - 0x80FBDAE0 (4240)
Local Heap: 0x80FBDAE0 - 0x80FFDAE0 (262144)
Stack Area: 0x80FFDAE0 - 0x80FFFAE0 (8192)
Text (code) segment: 0x80F83000 - 0x80FBA115 (225557)
Boot area (physical): 0x00F42000 - 0x00F82000
Relocation Factor: I:E1383000 - D:E1383000
Press Ctrl-C to cancel automatic startup
CFE> ifconfig eth0 -addr=192.168.168.10
Device eth0: hwaddr 02-10-18-58-36-10, ipaddr 192.168.168.10, mask not set
gateway not set, nameserver not set
*** command status = 0
CFE> flash -noheader 192.168.168.2:openwrt-adm5120-2.6-squashfs-wp54g-wrt.trx flash1.
trx
Reading 192.168.168.2:openwrt-adm5120-2.6-squashfs-wp54g-wrt.trx: Done. 1581056 bytes
read
** DO NOT TURN OFF YOUR MACHINE UNTIL THE FLASH UPDATE COMPLETES!! **
Programming...done. 1581056 bytes written
*** command status = 0
CFE> reset
CFE version 1.2.5 for WP54G (32bit,SP,LE,MIPS)
Build Date: Wed Aug 16 09:09:30 SGT 2006 (ttyaw@linux01)
Initializing Arena.
Initializing PCI. [normal]
PCI bus 0 slot 0/0: ADMtek ADM5120 Host Bridge (host bridge)
Initializing Devices.
CPU type 0x1800B: 175MHz
Total memory: 0x1000000 bytes (16MB)
Total memory used by CFE: 0x80F83000 - 0x80FFFAE0 (510688)
Initialized Data: 0x80FBA824 - 0x80FBCA50 (8748)
BSS Area: 0x80FBCA50 - 0x80FBDAE0 (4240)
Local Heap: 0x80FBDAE0 - 0x80FFDAE0 (262144)
Stack Area: 0x80FFDAE0 - 0x80FFFAE0 (8192)
Text (code) segment: 0x80F83000 - 0x80FBA115 (225557)
Boot area (physical): 0x00F42000 - 0x00F82000
Relocation Factor: I:E1383000 - D:E1383000
Press Ctrl-C to cancel automatic startup
Loader:raw Filesys:raw Dev:flash1.trx File:0x1c Options:(null)
Loading: .. 3931 bytes read
Entry at 0x80001000
Starting program at 0x80001000
decompress kernel ... ok
Linux version 2.6.19.2 (juhosg@idared) (gcc version 3.4.6 (OpenWrt-2.0)) #1 Sun Mar 2
5 08:44:35 CEST 2007
adm5120: boot loader is CFE
GETENV: envname is memsize
GETENV: returning 0x001000000
CPU revision is: 0001800b
ADM5120 board setup
Determined physical RAM map:
memory: 00d5c000 @ 002a4000 (usable)
Initrd not found or empty - disabling initrd
Built 1 zonelists. Total pages: 4064
Kernel command line: console=ttyS0,115200 rootfstype=squashfs,jffs2 init=/etc/preinit
Primary instruction cache 8kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
CPU clock: 175MHz
start_kernel(): bug: interrupts were enabled early
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 13532k/13680k available (2171k kernel code, 148k reserved, 300k data, 120k in
it, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction... available.
NET: Registered protocol family 16
System has PCI BIOS (ADM5120 BGA)
NET: Registered protocol family 2
IP route cache hash table entries: 128 (order: -3, 512 bytes)
TCP established hash table entries: 512 (order: -1, 2048 bytes)
TCP bind hash table entries: 256 (order: -2, 1024 bytes)
TCP: Hash tables configured (established 512 bind 256)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(946684800.132:1): initialized
squashfs: version 3.0 (2006/03/15) Phillip Lougher
JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler cfq registered (default)
ADM5120 LED & GPIO driver
ttyS0 at I/O 0x12600000 (irq = 1) is a ADM5120
ttyS1 at I/O 0x12800000 (irq = 2) is a ADM5120
PPP generic driver version 2.4.2
NET: Registered protocol family 24
eth0: ADM5120 switch port0
eth1: ADM5120 switch port1
adm5120 : flash init : 0x1fc00000 0x00400000
adm5120 physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
Flash device: 0x400000 at 0x1fc00000
bootloader size: 327680
adm5120 physically mapped flash: Filesystem type: squashfs, size=0xc36b2
Updating TRX offsets and length:
old trx = [0x0000001c, 0x00000960, 0x000be800], len=0x00182000 crc32=0x0700aebc
new trx = [0x0000001c, 0x00000960, 0x000be800], len=0x00190000 crc32=0xfe2d95ee
Done
Creating 5 MTD partitions on "adm5120 physically mapped flash":
0x00000000-0x00050000 : "cfe"
0x00050000-0x003f0000 : "linux"
0x0010e800-0x001e0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x003f0000-0x00400000 : "nvram"
0x001e0000-0x003f0000 : "OpenWrt"
IPv4 over IPv4 tunneling driver
ip_conntrack version 2.4 (106 buckets, 848 max) - 196 bytes per conntrack
TCP cubic registered
Initializing XFRM netlink socket
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 15
Bridge firewalling registered
Ebtables v2.0 registered
ebt_ulog: not logging via ulog since somebody else already registered for PF_BRIDGE
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Cannot open root device "<NULL>" or unknown-block(31,2)
Please append a correct "root=" boot option
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,2)