rendered paste body=> run testkernel
2041319 bytes read
## Booting image at 00300000 ...
Image Name: Linux-2.6.21-rc1-git1
Created: 2007-02-26 3:09:06 UTC
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 2041255 Bytes = 1.9 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Linux version 2.6.21-rc1-git1 (repvik@apollo) (gcc version 3.4.6) #1 Mon Feb 26 04:09:03 CET 2007
Motorola SPS Sandpoint Test Platform
Port by MontaVista Software, Inc. (source@mvista.com)
Zone PFN ranges:
DMA 0 -> 16384
Normal 16384 -> 16384
early_node_map[1] active PFN ranges
0: 0 -> 16384
Built 1 zonelists. Total pages: 16256
Kernel command line: console=ttyS0,115200n8 root=/dev/ram
OpenPIC Version 1.2 (1 CPUs and 10 IRQ sources) at fdf40000
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 60732k available (2776k kernel code, 1268k data, 128k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: Probing PCI hardware
PCI: Cannot allocate resource region 1 of device 0000:00:00.0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
NTFS driver 2.1.28 [Flags: R/W].
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 25) is a 16550A
serial8250 serial8250.0: unable to register port at index 0 (IO0 MEMfdf04500 IRQ25): -28
RAMDISK driver initialized: 16 RAM disks of 40960K size 1024 blocksize
loop: loaded (max 8 devices)
Intel(R) PRO/1000 Network Driver - version 7.3.20-k2
Copyright (c) 1999-2006 Intel Corporation.
r8169 Gigabit Ethernet driver 2.2LK-NAPI loaded
eth0: RTL8169sc/8110sc at 0xc5000e00, 00:08:9b:8a:6a:3b, IRQ 18
physmap platform flash device: 01000000 at ff000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash.0: CFI does not contain boot bank location. Assuming top.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
RedBoot partition parsing not available
Using physmap partition information
Creating 7 MTD partitions on "physmap-flash.0":
0x00f00000-0x00f40000 : "U-Boot"
0x00000000-0x00200000 : "Kernel"
0x00200000-0x00b00000 : "RootFS1"
0x00b00000-0x00e00000 : "RootFS2"
0x00e00000-0x00f00000 : "Vendor"
0x00f40000-0x00f60000 : "U-Boot Config"
0x00f60000-0x01000000 : "NAS Config"
ehci_hcd 0000:00:0e.2: EHCI Host Controller
ehci_hcd 0000:00:0e.2: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0e.2: request interrupt 17 failed
ehci_hcd 0000:00:0e.2: USB bus 1 deregistered
ehci_hcd 0000:00:0e.2: init 0000:00:0e.2 fail, -16
ehci_hcd: probe of 0000:00:0e.2 failed with error -16
ohci_hcd 0000:00:0e.0: OHCI Host Controller
ohci_hcd 0000:00:0e.0: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:0e.0: request interrupt 17 failed
ohci_hcd 0000:00:0e.0: USB bus 1 deregistered
ohci_hcd 0000:00:0e.0: init 0000:00:0e.0 fail, -16
ohci_hcd: probe of 0000:00:0e.0 failed with error -16
ohci_hcd 0000:00:0e.1: OHCI Host Controller
ohci_hcd 0000:00:0e.1: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:0e.1: request interrupt 17 failed
ohci_hcd 0000:00:0e.1: USB bus 1 deregistered
ohci_hcd 0000:00:0e.1: init 0000:00:0e.1 fail, -16
ohci_hcd: probe of 0000:00:0e.1 failed with error -16
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
i8042.c: i8042 controller self test timeout.
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
NET: Registered protocol family 4
NET: Registered protocol family 5
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
No filesystem could mount root, tried: ext3 ext2 msdos vfat iso9660 ntfs romfs
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(1,0)
Rebooting in 180 seconds..