rendered paste bodylg@babar:~$ sudo picocom -b 38400 /dev/ttyUSB0
picocom v1.4
port is : /dev/ttyUSB0
flowcontrol : none
baudrate is : 38400
parity is : none
databits are : 8
escape is : C-a
noinit is : no
noreset is : no
nolock is : no
send_cmd is : ascii_xfr -s -v -l10
receive_cmd is : rz -vv
Terminal ready
Minimal POST completed... Success.
Last reset cause: Hardware reset (Power-on reset)
PSPBoot1.2 rev: 1.2.0.4
(c) Copyright 2002-2004 Texas Instruments, Inc. All Rights Reserved.
Press ESC for monitor... 1
(psbl)
Booting...
Launching kernel decompressor.
Starting LZMA Uncompression Algorithm.
Copyright (C) 2003 Texas Instruments Incorporated; Copyright (C) 1999-2003 Igor Pavlov.
Compressed file is LZMA format.
Kernel decompressor was successful ... launching kernel.
LINUX started...
Config serial console: ttyS0,38400
CPU revision is: 00018448
Primary instruction cache 16kb, linesize 16 bytes (4 ways)
Primary data cache 16kb, linesize 16 bytes (4 ways)
Number of TLB entries 16.
Linux version 2.4.17_mvl21-malta-mips_fp_le (root@mandrake.nctu.edu.tw) (gcc version 2.95.3 20010315 (release/MontaVista)) #49 Thu Sep 9 18:13:08 EDT 2004
Determined physical RAM map:
memory: 14000000 @ 00000000 (reserved)
memory: 00020000 @ 14000000 (ROM data)
memory: 00fe0000 @ 14020000 (usable)
On node 0 totalpages: 4096
zone(0): 4096 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line:
calculating r4koff... 000b71b0(750000)
CPU frequency 150.00 MHz
Calibrating delay loop... 149.91 BogoMIPS
Freeing Adam2 reserved memory [0x14001000,0x0001f000]
Memory: 14420k/16384k available (1454k kernel code, 1964k reserved, 99k data, 56k init)
Dentry-cache hash table entries: 2048 (order: 2, 16384 bytes)
Inode-cache hash table entries: 1024 (order: 1, 8192 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer-cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 4096 (order: 2, 16384 bytes)
Checking for 'wait' instruction... unavailable.
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Disabling the Out Of Memory Killer
devfs: v1.7 (20011216) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
pty: 32 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with no serial options enabled
ttyS00 at 0xa8610e00 (irq = 15) is a 16550A
ttyS01 at 0xa8610f00 (irq = 16) is a 16550A
Enter led_init from led_wrapper.c
block: 64 slots per queue, batch=16
Using the MAC with internal PHY
Cpmac driver is allocating buffer memory at init time.
Default Asymmetric MTU for eth0 1500
PPP generic driver version 2.4.1
avalanche flash device: 0x400000 at 0x10000000.
Amd/Fujitsu Extended Query Table v1.1 at 0x0040
number of CFI chips: 1
Looking for mtd device :mtd0:
Found a mtd0 image (0xa0000), with size (0x360000).
Creating 1 MTD partitions on "Physically mapped flash:0":
0x000a0000-0x00400000 : "mtd0"
Looking for mtd device :mtd1:
Found a mtd1 image (0x20000), with size (0x80000).
Creating 1 MTD partitions on "Physically mapped flash:0":
0x00020000-0x000a0000 : "mtd1"
Looking for mtd device :mtd2:
Found a mtd2 image (0x0), with size (0x10000).
Creating 1 MTD partitions on "Physically mapped flash:0":
0x00000000-0x00010000 : "mtd2"
Looking for mtd device :mtd3:
Found a mtd3 image (0x10000), with size (0x10000).
Creating 1 MTD partitions on "Physically mapped flash:0":
0x00010000-0x00020000 : "mtd3"
Looking for mtd device :mtd4:
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 1024 bind 1024)
Linux IP multicast router 0.06 plus PIM-SM
ip_conntrack version 2.0 (128 buckets, 1024 max) - 364 bytes per conntrack
ip_tables: (c)2000 Netfilter core team
netfilter PSD loaded - (c) astaro AG
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
Initializing the WAN Bridge.
Please set the MAC Address for the WAN Bridge.
Set the Environment variable 'wan_br_mac'.
MAC Address should be in the following format: xx.xx.xx.xx.xx.xx
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 56k freed
serial console detected. Disabling virtual terminals.
console=/dev/tts/0
init started: BusyBox v0.61.pre (2004.10.19-18:15+0000) multi-call binary
Starting pid 9, console /dev/tts/0: '/etc/init.d/rcS'
Algorithmics/MIPS FPU Emulator v1.5
Reading Standard Configuration File /etc/led.conf
Configured 17 states
Using /lib/modules/2.4.17_mvl21-malta-mips_fp_le/kernel/drivers/net/avalanche_usb/avalanche_usb.o
USB: Entering USB_init_module.
USB Driver built for RNDIS protocol only.
Ignoring bootloader environment configuration.
VID = 0x13b1
PID = 0xf
No Serial Number String present.
Manufacturer = Texas Instruments
Product description = Linksys RNDIS Network Adapter
USB: Entering USB_Init.
USB: Leaving USB_Init.
Default Asymmetric MTU for usb0 1500
USB: Leaving USB_init_module.
Using /lib/modules/2.4.17_mvl21-malta-mips_fp_le/kernel/drivers/atm/tiatm.o
registered device TI Avalanche SAR
Texas Instruments ATM driver: version:[4.02.11.00]
Waiting for enter to start '/usr/bin/cmcli' (pid 33, terminal /dev/tts/0)
Please press Enter to activate this console. Sep 8 12:00:07 cm_monitor: Monitor Starting
SIOCGIFFLAGS: No such device
SIOCGIFFLAGS: No such device
SIOCGIFFLAGS: No such device
Sep 8 12:00:08 cfgmgr(pppoa-107): Valid Configuration Tree
Doing BRCTL ...
addbr br0
Doing BRCTL ...
addbr br1
Sep 8 12:00:08 cfgmgr(snmpcm): snmpd starts (1)
Sep 8 12:00:08 cfgmgr(fdb): Firewall NAT service started
Default Asymmetric MTU for br0 1500
Default Asymmetric MTU for br1 1500
Sep 8 12:00:08 cfgmgr(lanbridge0): Bridge Created: br0
Sep 8 12:00:08 cfgmgr(lanbridge0): /dev/led file could not be opened
Doing BRCTL ...
setfilter br0 0
Doing BRCTL ...
addif br0 eth0
Doing BRCTL ...
addif br0 usb0
Sep 8 12:00:09 cfgmgr(lanbridge1): Bridge Created: br1
device eth0 entered promiscuous mode
br0: port 1(eth0) entering learning state
Doing BRCTL ...
setfilter br1 0
Doing BRCTL ...
stp br0 off
device usb0 entered promiscuous mode
Sep 8 12:00:09 cfgmgr(lanbridge0): Bridge Interface Added: eth0
Doing BRCTL ...
setfilter br0 0
Sep 8 12:00:10 cfgmgr(lanbridge0): Bridge Interface Added: usb0
br0: port 2(usb0) entering learning state
Doing BRCTL ...
setfilter br0 0
Doing BRCTL ...
stp br1 off
br0: port 1(eth0) entering forwarding state
br0: topology change detected, propagating
br0: port 2(usb0) entering forwarding state
br0: topology change detected, propagating
Sep 8 12:00:17 cfgmgr(sar): DSL Carrier is down
Starting pid 33, console /dev/tts/0: '/usr/bin/cmcli'
DSL Modem CLI
Copyright (c) 2004 Texas Instruments, Inc.
cli>