# Linux#!/bin/sh## XS26 Linux /etc/init.d/xs26 tunnel script# Enables you to easilly start/stop your tunnel## By Tako B. 'ArcAngel' van Gaalen / arcangel@xs26.netPATH=/bin:/usr/bin:/sbin:/usr/sbinTUNLIF="xs26-0" # interface used for the tunnel - default should be okcase "$1" in start) echo -n "Starting ipv6 tunnel: xs26" # Modify following values # MYIPv4="217.132.41.148" # My IPv4 address XSIPv4="153.19.188.4" # XS26 PoP MYIPv6="3ffe:80ee:375b::/48" # Choose any IPv6 address from the range # you've got from XS26 # you've got from XS26 # Additional IP addresses # Don't forget to uncomment below for each extra IP address ## IP0="3ffe:80ee:375b::/48" IP1="3ffe:80ee:375b::1/48" IP2="3ffe:80ee:375b::2/48" IP3="3ffe:80ee:375b::3/48" IP4="3ffe:80ee:375b::4/48" # Do NOT modify this! # iptunnel add $TUNLIF mode sit local $MYIPv4 remote $XSIPv4 ttl 64 ifconfig $TUNLIF up route -A inet6 add 2000::/3 dev $TUNLIF ifconfig $TUNLIF add $MYIPv6 # Add here your additional IP addresses ## ifconfig $TUNLIF add $IP0 ifconfig $TUNLIF add $IP1 ifconfig $TUNLIF add $IP2 ifconfig $TUNLIF add $IP3 ifconfig $TUNLIF add $IP4 echo "." ;; stop) echo -n "Stopping ipv6 tunnel: xs26" ifconfig $TUNLIF down iptunnel del $TUNLIF echo "." ;; force-reload|restart) $0 stop $0 start ;; *) echo "Usage: /etc/init.d/xs26 {start|stop|restart|force-reload}" exit 1esacexit 0