rendered paste bodymezoko@mars ~ $ cat hdstuff
smartctl version 5.26 Copyright (C) 2002-3 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Device Model: HITACHI_DK23FA-60
Serial Number: 3C1632
Firmware Version: 00M4A0A0
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 5
ATA Standard is: ATA/ATAPI-5 T13 1321D revision 3
Local Time is: Sat Dec 30 18:49:25 2006 GMT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity was
never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: (2580) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 44) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000d 100 100 050 Pre-fail Offline - 0
2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline - 0
3 Spin_Up_Time 0x0007 100 100 050 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 099 099 000 Old_age Always - 1614
5 Reallocated_Sector_Ct 0x0033 001 001 010 Pre-fail Always FAILING_NOW 2808
7 Seek_Error_Rate 0x000f 100 100 050 Pre-fail Always - 677
8 Seek_Time_Performance 0x0005 100 100 050 Pre-fail Offline - 0
9 Power_On_Hours 0x0032 091 091 000 Old_age Always - 272367
10 Spin_Retry_Count 0x0013 100 100 050 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 099 099 000 Old_age Always - 1335
191 G-Sense_Error_Rate 0x000a 100 093 000 Old_age Always - 86015
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 29
193 Load_Cycle_Count 0x0032 084 084 000 Old_age Always - 1650794266745
194 Temperature_Celsius 0x0022 100 062 000 Old_age Always - 39 (Lifetime Min/Max 59/12)
195 Hardware_ECC_Recovered 0x001a 100 001 000 Old_age Always - 199414
196 Reallocated_Event_Count 0x0032 001 001 000 Old_age Always - 2808
197 Current_Pending_Sector 0x0032 085 082 000 Old_age Always - 15
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0013 100 100 050 Pre-fail Always - 0
201 Soft_Read_Error_Rate 0x0012 001 001 000 Old_age Always - 2078
223 Load_Retry_Count 0x0012 100 100 000 Old_age Always - 0
230 Head_Amplitude 0x0032 096 096 000 Old_age Always - 141367
250 Read_Error_Retry_Rate 0x000a 070 001 000 Old_age Always - 65956
SMART Error Log Version: 1
ATA Error Count: 25138 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Timestamp = decimal seconds since the previous disk power-on.
Note: timestamp "wraps" after 2^32 msec = 49.710 days.
Error 25138 occurred at disk power-on lifetime: 4539 hours
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 00 4b 8f e0 Error: UNC
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 08 ff 4a 8f e0 00 1855.590 READ DMA
ca 00 08 6f 86 5d e0 00 1855.570 WRITE DMA
ca 00 08 87 90 c5 e0 00 1855.560 WRITE DMA
ca 00 18 67 90 c5 e0 00 1855.540 WRITE DMA
ca 00 08 97 90 af e0 00 1855.520 WRITE DMA
Error 25137 occurred at disk power-on lifetime: 4539 hours
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 00 4b 8f e0 Error: UNC
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 08 ff 4a 8f e0 00 1853.310 READ DMA
c8 00 08 ff 4a 8f e0 00 1850.390 READ DMA
c8 00 98 47 49 8f e0 00 1850.340 READ DMA
c8 00 10 ef ef 89 e0 00 1850.330 READ DMA
c8 00 70 77 ef 89 e0 00 1850.280 READ DMA
Error 25136 occurred at disk power-on lifetime: 4539 hours
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 00 4b 8f e0 Error: UNC
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 08 ff 4a 8f e0 00 1850.390 READ DMA
c8 00 98 47 49 8f e0 00 1850.340 READ DMA
c8 00 10 ef ef 89 e0 00 1850.330 READ DMA
c8 00 70 77 ef 89 e0 00 1850.280 READ DMA
ca 00 08 f7 97 00 e0 00 1850.120 WRITE DMA
Error 25135 occurred at disk power-on lifetime: 4538 hours
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 2d 5a 58 81 e0 Error: UNC
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 30 57 58 81 e0 00 1111.820 READ DMA
c8 00 40 0f 58 81 e0 00 1111.520 READ DMA
c8 00 00 87 58 81 e0 00 1110.910 READ DMA
c8 00 a0 6f cd 83 e0 00 1110.460 READ DMA
c8 00 40 27 cd 83 e0 00 1110.430 READ DMA
Error 25134 occurred at disk power-on lifetime: 4538 hours
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 06 59 40 ad e0 Error: UNC
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
-- -- -- -- -- -- -- -- --------- --------------------
c8 00 08 57 40 ad e0 00 1017.210 READ DMA
c8 00 08 77 86 95 e0 00 1017.200 READ DMA
c8 00 08 37 de 8e e0 00 1017.190 READ DMA
c8 00 08 e7 e1 8c e0 00 1017.180 READ DMA
c8 00 08 ef e0 8c e0 00 1017.180 READ DMA
SMART Self-test log structure revision number 1
No self-tests have been logged. [Use the smartctl -t option to run these.]