Freeing unused kernel memory: 104k freed
^[[10;1Rinsmod: diag.ko: no module by that name found
Could not open mtd device: rootfs
init started: BusyBox v1.01 (2005.11.01-16:50+0000) multi-call binary
Please press Enter to activate this console. natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 22
originally by Donald Becker <becker@scyld.com>
http://www.scyld.com/network/natsemi.html
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
natsemi eth0: NatSemi DP8381[56] at 0xa0000000 (0000:00:06.0), 00:00:24:c4:f2:28, IRQ 10, port TP.
natsemi eth1: NatSemi DP8381[56] at 0xa0001000 (0000:00:07.0), 00:00:24:c4:f2:29, IRQ 10, port TP.
natsemi eth2: NatSemi DP8381[56] at 0xa0002000 (0000:00:08.0), 00:00:24:c4:f2:2a, IRQ 10, port TP.
wlan: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
ath_hal: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
ath_rate_onoe: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
ath_pci: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
wlan_acl: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
wlan_ccmp: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
wlan_tkip: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
wlan_wep: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
wlan_xauth: version magic '2.6.12.5 GEODEGX1 gcc-3.3' should be '2.6.12.5 GEODEGX1 gcc-3.4'
device eth0 entered promiscuous mode
eth1: DSPCFG accepted after 0 usec.
eth1: link up.
eth1: Setting full-duplex based on negotiated link capability.
eth1: Promiscuous mode enabled.
device eth1 entered promiscuous mode
eth2: DSPCFG accepted after 0 usec.
eth2: Promiscuous mode enabled.
device eth2 entered promiscuous mode
br0: port 1(eth1) entering learning state
br0: topology change detected, propagating