rendered paste body Booting 'OpenWrt'
root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
kernel /boot/openwrt-x86-2.6-vmlinuz blkmtd_device=/dev/hda2 blkmtd_sync=1 roo
t=/dev/mtdblock0 init=/etc/preinit noinitrd console=ttyS0,115200n8
[Linux-bzImage, setup=0x1200, size=0xd63a4]
boot
Linux version 2.6.12.5 (nthill@debian) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #2 Mon Oct 31 22:05
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
128MB LOWMEM available.
DMI not present.
Allocating PCI resources starting at 08000000 (gap: 08000000:f7f00000)
Built 1 zonelists
Kernel command line: blkmtd_device=/dev/hda2 blkmtd_sync=1 root=/dev/mtdblock0 init=/etc/preinit 8
Initializing CPU#0
PID hash table entries: 1024 (order: 10, 16384 bytes)
scx200hr: timer not yet accessible; will probe later.
Detected 266.655 MHz processor.
Using tsc for high-res timesource
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 127288k/131072k available (1113k kernel code, 3328k reserved, 526k data, 104k init, 0k hi)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Mount-cache hash table entries: 512
CPU: NSC Unknown stepping 01
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0
PCI: Using configuration type 1
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
scx200: NatSemi SCx200 Driver
scx200: GPIO base 0x6100
scx200: Configuration Block base 0x6000
switching to scx200 high-resolution timer (255961 cpt)
Squashfs 2.2 (released 2005/07/03) (C) 2002-2005 Phillip Lougher
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Real Time Clock Driver v1.12
Non-volatile memory driver v1.2
Serial: 8250/16550 driver $Revision: 1.90 $ 6 ports, IRQ sharing disabled
ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
Booting 'OpenWrt'
root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
kernel /boot/openwrt-x86-2.6-vmlinuz blkmtd_device=/dev/hda2 blkmtd_sync=1 roo
t=/dev/mtdblock0 init=/etc/preinit noinitrd console=ttyS0,115200n8
[Linux-bzImage, setup=0x1200, size=0xd63a4]
boot
Linux version 2.6.12.5 (nthill@debian) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #2 Mon Oct 31 22:00
:23 CET 2005
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
128MB LOWMEM available.
DMI not present.
Allocating PCI resources starting at 08000000 (gap: 08000000:f7f00000)
Built 1 zonelists
Kernel command line: blkmtd_device=/dev/hda2 blkmtd_sync=1 root=/dev/mtdblock0 init=/etc/preinit n
oinitrd console=ttyS0,115200n8
Initializing CPU#0
PID hash table entries: 1024 (order: 10, 16384 bytes)
scx200hr: timer not yet accessible; will probe later.
Detected 266.663 MHz processor.
Using tsc for high-res timesource
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 127288k/131072k available (1113k kernel code, 3328k reserved, 526k data, 104k init, 0k hig
hmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Mount-cache hash table entries: 512
CPU: NSC Unknown stepping 01
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0
PCI: Using configuration type 1
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
scx200: NatSemi SCx200 Driver
scx200: GPIO base 0x6100
scx200: Configuration Block base 0x6000
switching to scx200 high-resolution timer (255961 cpt)
Squashfs 2.2 (released 2005/07/03) (C) 2002-2005 Phillip Lougher
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Real Time Clock Driver v1.12
Non-volatile memory driver v1.2
Serial: 8250/16550 driver $Revision: 1.90 $ 6 ports, IRQ sharing disabled
ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
io scheduler noop registered
io scheduler anticipatory registered
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SC1200: IDE controller at PCI slot 0000:00:12.2
SC1200: chipset revision 1
SC1200: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:pio, hdd:pio
hda: PQI ATA Rev6.0, CFA DISK drive
SC1200: set xfer mode failure
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 256000 sectors (131 MB) w/0KiB Cache, CHS=1000/16/16
hda: cache flushes not supported
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3
blkmtd: version $Revision: 1.24 $
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3
blkmtd: mtd0: [/dev/hda2] erase_size = 128KiB
NET: Registered protocol family 2
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP established hash table entries: 8192 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
ip_conntrack version 2.1 (1024 buckets, 8192 max) - 256 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,0)