Mine

2610-FRI-klu#show run int se 0/0
Building configuration...

Current configuration : 117 bytes
!
interface Serial0/0
 description 2MBit_TA
 bandwidth 1984
 ip address 10.254.0.33 255.255.255.248
 fair-queue
end

2610-FRI-klu#ping 10.254.0.33

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.254.0.33, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
2610-FRI-klu#show int se 0/0
Serial0/0 is up, line protocol is up
  Hardware is PowerQUICC Serial
  Description: 2MBit_TA
  Internet address is 10.254.0.33/29
  MTU 1500 bytes, BW 1984 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation HDLC, loopback not set
  Keepalive set (10 sec)
  Last input 00:00:00, output 00:00:01, output hang never
  Last clearing of "show interface" counters 00:12:45
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations  0/1/256 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
     Available Bandwidth 1488 kilobits/sec
  5 minute input rate 0 bits/sec, 1 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     970 packets input, 57218 bytes, 0 no buffer
     Received 475 broadcasts, 0 runts, 0 giants, 0 throttles
     1 input errors, 0 CRC, 1 frame, 0 overrun, 0 ignored, 0 abort
     458 packets output, 36096 bytes, 0 underruns
     0 output errors, 0 collisions, 2 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up