Untitled

exec
Using base address 0x06000000 and length 0x0013e7b0
Uncompressing Linux...................................................................................... done, booting the.
Linux version 2.6.19-rc3 (tom@tom-server) (gcc version 3.4.4) #2 PREEMPT Tue Oct 31 07:19:04 EST 2006
CPU: XScale-IXP42x Family [690541c1] revision 1 (ARMv5TE), cr=000039ff
Machine: Intel IXDP425 Development Platform
Memory policy: ECC disabled, Data cache writeback
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists.  Total pages: 32512
Kernel command line:  noirqdebug console=ttyS0,115200n8 root=/dev/mtdblock3 rootfstype=jffs2 rtc-ds1672.probe=0,0x68 mem=120
IRQ lockup detection disabled
PID hash table entries: 512 (order: 9, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 128MB = 128MB total
Memory: 127116KB available (2192K code, 413K data, 92K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
IXP4xx: Using 16MiB expansion bus window size
PCI: IXP4xx is host
PCI: IXP4xx Using direct access for memory space
PCI: bus0: Fast back to back transfers disabled
dmabounce: registered device 0000:00:05.0 on pci bus
dmabounce: registered device 0000:00:05.1 on pci bus
dmabounce: registered device 0000:00:05.2 on pci bus
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 4096 bind 2048)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
HDLC line discipline: version $Revision: 4.8 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xc8000000 (irq = 15) is a XScale
serial8250.0: ttyS1 at MMIO 0xc8001000 (irq = 13) is a XScale
RAMDISK driver initialized: 4 RAM disks of 10240K size 1024 blocksize
IXP4XX Q Manager 0.2.0 initialized.
IXP4XX NPE driver Version 0.2.0 initialized
ixp4xx_mac driver 0.2.1: eth0 on NPE-B with PHY[0] initialized
ixp4xx_mac driver 0.2.1: eth1 on NPE-C with PHY[1] initialized
IXP4XX-Flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x0031
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
Searching for RedBoot partition table in IXP4XX-Flash.0 at offset 0xfe0000
6 RedBoot partitions found on MTD device IXP4XX-Flash.0
Creating 6 MTD partitions on "IXP4XX-Flash.0":
0x00000000-0x00080000 : "RedBoot"
npe: searching for firmware...
npe: found at 0x12104, unknown/NPE-A func: 03, rev: 5.8, size: 1074729484, id: 5003c508
npe: found at 0x3fd1c, IXP465/NPE-A func: 81, rev: 2.0, size: 12848, id: 10810200
npe: found at 0x42f4c, IXP425/NPE-B func: 01, rev: 2.0, size: 12848, id: 01010200
npe: firmware loaded to NPE-B, func: 01, rev: 2.0, status: 92c00000
npe: found at 0x4617c, IXP425/NPE-C func: 01, rev: 2.0, size: 12848, id: 02010200
npe: firmware loaded to NPE-C, func: 01, rev: 2.0, status: 80800000
0x00080000-0x00200000 : "zimage-sid"
0x00200000-0x00400000 : "gps-jffs2"
0x00780000-0x00980000 : "be-jffs2"
0x00fe0000-0x00fff000 : "FIS directory"
mtd: partition "FIS directory" doesn't end on an erase block -- force read-only
0x00fff000-0x01000000 : "RedBoot config"
mtd: partition "RedBoot config" doesn't start on an erase block boundary -- force read-only
PCI: enabling device 0000:00:05.2 (0140 -> 0142)
ehci_hcd 0000:00:05.2: Found HC with no IRQ.  Check BIOS/PCI 0000:00:05.2 setup!
ehci_hcd 0000:00:05.2: init 0000:00:05.2 fail, -19
PCI: enabling device 0000:00:05.0 (0140 -> 0142)
ohci_hcd 0000:00:05.0: Found HC with no IRQ.  Check BIOS/PCI 0000:00:05.0 setup!
ohci_hcd 0000:00:05.0: init 0000:00:05.0 fail, -19
PCI: enabling device 0000:00:05.1 (0140 -> 0142)
ohci_hcd 0000:00:05.1: Found HC with no IRQ.  Check BIOS/PCI 0000:00:05.1 setup!
ohci_hcd 0000:00:05.1: init 0000:00:05.1 fail, -19
USB Universal Host Controller Interface driver v3.0
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
i2c /dev entries driver
ds1672 0-0068: chip found, driver version 0.3
ds1672 0-0068: rtc intf: sysfs
ds1672 0-0068: rtc intf: proc
ds1672 0-0068: rtc intf: dev (254:0)
ds1672 0-0068: rtc core: registered ds1672 as rtc0
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
ds1672 0-0068: setting the system clock to 2006-10-31 14:04:59 (1162303499)
Time: OSTS clocksource has been installed.
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 92K
init started:  BusyBox v1.2.1 (2006.10.31-01:55+0000) multi-call binary
Starting pid 141, console /dev/ttyS0: '/bin/ash'


BusyBox v1.2.1 (2006.10.31-01:55+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.