rendered paste bodyvoyage:~# dmesg
Linux version 2.6.15-486-voyage (2.0-10) (root@punknix-uml) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #1 PREEMPT Mon Mar 27 07:45:05 GMT 2006
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)
128MB LOWMEM available.
On node 0 totalpages: 32768
DMA zone: 4096 pages, LIFO batch:0
DMA32 zone: 0 pages, LIFO batch:0
Normal zone: 28672 pages, LIFO batch:7
HighMem zone: 0 pages, LIFO batch:0
DMI not present.
Allocating PCI resources starting at 10000000 (gap: 08000000:f7f00000)
Built 1 zonelists
Kernel command line: auto BOOT_IMAGE=Linux ro root=301 console=ttyS0,9600n8
No local APIC present or hardware disabled
mapped APIC to ffffd000 (01101000)
Initializing CPU#0
PID hash table entries: 1024 (order: 10, 16384 bytes)
Detected 266.665 MHz processor.
Using tsc for high-res timesource
Console: colour dummy device 80x25
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 126696k/131072k available (1606k kernel code, 3956k reserved, 598k data, 140k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 534.51 BogoMIPS (lpj=1069036)
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 00808131 01818131 00000000 00000000 00000000 00000000 00000000
CPU: After vendor identify, caps: 00808131 01818131 00000000 00000000 00000000 00000000 00000000
CPU: After all inits, caps: 00808131 00818131 00000000 00000001 00000000 00000000 00000000
CPU: NSC Unknown stepping 01
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=0
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
i8042.c: Can't read CTR while initializing i8042.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Probing IDE interface ide0...
hda: Hitachi XX.V.3.4.0.0, CFA DISK drive
Probing IDE interface ide1...
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 1000944 sectors (512 MB) w/1KiB Cache, CHS=993/16/63
hda: cache flushes not supported
hda: hda1 hda2
mice: PS/2 mouse device common for all mice
padlock: VIA PadLock not detected.
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 3, 32768 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
NET: Registered protocol family 15
Using IPI Shortcut mode
hda: hda1 hda2
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 140k freed
EXT3 FS on hda1, internal journal
natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 27, 2002
originally by Donald Becker <becker@scyld.com>
http://www.scyld.com/network/natsemi.html
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
natsemi eth0: NatSemi DP8381[56] at 0xa0000000 (0000:00:06.0), 00:00:24:c3:88:a4, IRQ 10, port TP.
natsemi eth1: NatSemi DP8381[56] at 0xa0001000 (0000:00:07.0), 00:00:24:c3:88:a5, IRQ 10, port TP.
natsemi eth2: NatSemi DP8381[56] at 0xa0002000 (0000:00:08.0), 00:00:24:c3:88:a6, IRQ 10, port TP.
ieee80211_crypt: registered algorithm 'NULL'
hostap_pci: 0.4.4-kernel (Jouni Malinen <jkmaline@cc.hut.fi>)
SC1x00 Watchdog driver by Inprimis Technolgies.
wd1100.c: a few hacks by erich.titl@think.ch
: probe failed
device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel@redhat.com
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
scx200: NatSemi SCx200 Driver
scx200: GPIO base 0x6100
scx200: Configuration Block base 0x6000
SC1200: IDE controller at PCI slot 0000:00:12.2
SC1200: chipset revision 1
SC1200: not 100% native mode: will probe irqs later
SC1200: port 0x01f0 already claimed by ide0
ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:pio, hdd:pio
Probing IDE interface ide1...
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ohci_hcd 0000:00:13.0: OHCI Host Controller
ohci_hcd 0000:00:13.0: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:13.0: irq 5, io mem 0xa0004000
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
eth0: DSPCFG accepted after 0 usec.
eth0: link up.
eth0: Setting full-duplex based on negotiated link capability.
WANPIPE(tm) Hardware Support Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc
WANPIPE(tm) Interface Support Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc
WANPIPE(tm) PPP/Cisco HDLC Protocol Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc
WANPIPE(tm) Multi-Protocol WAN Driver Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc
wanpipe: Probing for WANPIPE hardware.
wanpipe: AFT-A101u T1/E1 card found (HDLC rev.22), cpu(s) 1, bus #0, slot #10, irq #11
wanpipe: Allocating maximum 1 devices: wanpipe1 - wanpipe1.
WANPIPE: TDM Codecs Initialized
WANPIPE(tm) Socket API Module Beta10-2.3.4 (c) 1994-2006 Sangoma Technologies Inc
NET: Registered protocol family 25
WANPIPE(tm) L.I.P Network Layer Beta10-2.3.4 (c) 1995-2004 Sangoma Technologies Inc.
WanpipeLIP: Protocols: FR PPP CHDLC LIP_ATM
WANPIPE(tm) WANEC Layer Beta10-2.3.4 (c) 1995-2006 Sangoma Technologies Inc.
wanec_create_dev: Registering Wanpipe ECDEV Device!
wanpipe1: Starting WAN Setup
Processing WAN device wanpipe1...
wanpipe1: Locating: A101/2 card, CPU A, PciSlot=Auto, PciBus=Auto
wanpipe1: Found: A101/2 card, CPU A, PciSlot=10, PciBus=0
wanpipe1: AFT PCI memory at 0xA0003000
wanpipe1: IRQ 11 allocated to the AFT PCI card
wanpipe1: Starting AFT Hardware Init.
wanpipe1: Enabling front end link monitor
wanpipe1: Hardware Adapter Type 0x41 Scurity 0x00
wanpipe1: Security 1 Line UnCh
wanpipe1: Configuring PMC COMET T1 Front End (Port 1)!
wanpipe1: All channels enabled
wanpipe1: Configuring Device :wanpipe1 FrmVr=22
wanpipe1: Global MTU = 1500
eth0: no IPv6 routers present
wanpipe1: Global MRU = 1500
wanpipe1: RBS Signal = Off
wanpipe1: T1 connected!
wanpipe1: FE Ref Clock = Osc
wanpipe1: TDMV Span = 1 : Enabled
wanpipe1: Configuring Interface: w1g1
wanpipe1: UsedBy :TDM_VOICE_API
wp_tdmapi_reg_globals: Registering Wanpipe TDM Device!
wanpipe1: MRU :184
wanpipe1: MTU :184
wanpipe1: HDLC Eng :Off (Transparent)
wanpipe1: Slot Sync :Enabled
wanpipe1: Timeslot Map :0xFF7FFFFF
wanpipe1: Idle Flag :0x00
wanpipe1: Idle Buf Len :184
wanpipe1: Data Mux :On
wanpipe1: DMA MRU :512
wanpipe1: RX DMA Per Ch :10
wanpipe1: Net Gateway :No
wanpipe1: Configuring Interface: w1g1
wanpipe1: UsedBy :TDM_VOICE_DCHAN_API
wanpipe1: MRU :1500
wanpipe1: MTU :1500
wanpipe1: Enabling T1 Interrupts
wanpipe1: HDLC Eng :On
wanpipe1: Timeslot Map :0x00800000
wanpipe1: DMA MRU :2048
wanpipe1: RX DMA Per Ch :10
wanpipe1: Net Gateway :No
w1g1: Interface resynching!
ADDRCONF(NETDEV_CHANGE): w1g1: link becomes ready