rendered paste bodysmartctl 5.42 2011-10-20 r3458 [x86_64-linux-3.0.0-16-generic] (local build)
Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.12
Device Model: ST31000524AS
Serial Number: 6VPG4P29
LU WWN Device Id: 5 000c50 03e6c8aa1
Firmware Version: JC4B
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Fri Mar 23 23:20:41 2012 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 609) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 173) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 102 099 006 Pre-fail Always - 95019053
3 Spin_Up_Time 0x0003 100 100 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 64
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 073 060 030 Pre-fail Always - 22383974
9 Power_On_Hours 0x0032 097 097 000 Old_age Always - 3214
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 65
183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 080 080 000 Old_age Always - 20
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 17180131332
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 063 052 045 Old_age Always - 37 (Min/Max 29/40)
194 Temperature_Celsius 0x0022 037 048 000 Old_age Always - 37 (0 16 0 0 0)
195 Hardware_ECC_Recovered 0x001a 035 026 000 Old_age Always - 95019053
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 268435456003343
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 340216966
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 1794132039
SMART Error Log Version: 1
ATA Error Count: 20 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 20 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 01 ff ff ff 4f 00 00:11:56.923 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:56.905 SET FEATURES [Enable write cache]
00 00 00 00 00 00 00 ff 00:11:56.789 NOP [Abort queued commands]
60 00 01 ff ff ff 4f 00 00:11:54.034 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:54.019 SET FEATURES [Enable write cache]
Error 19 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 01 ff ff ff 4f 00 00:11:54.034 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:54.019 SET FEATURES [Enable write cache]
00 00 00 00 00 00 00 ff 00:11:53.908 NOP [Abort queued commands]
60 00 01 ff ff ff 4f 00 00:11:51.165 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:51.164 SET FEATURES [Enable write cache]
Error 18 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 01 ff ff ff 4f 00 00:11:51.165 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:51.164 SET FEATURES [Enable write cache]
00 00 00 00 00 00 00 ff 00:11:51.052 NOP [Abort queued commands]
60 00 01 ff ff ff 4f 00 00:11:48.309 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:48.309 SET FEATURES [Enable write cache]
Error 17 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 01 ff ff ff 4f 00 00:11:48.309 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:48.309 SET FEATURES [Enable write cache]
00 00 00 00 00 00 00 ff 00:11:48.197 NOP [Abort queued commands]
60 00 01 ff ff ff 4f 00 00:11:45.459 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:45.438 SET FEATURES [Enable write cache]
Error 16 occurred at disk power-on lifetime: 3208 hours (133 days + 16 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 01 ff ff ff 4f 00 00:11:45.459 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:45.438 SET FEATURES [Enable write cache]
00 00 00 00 00 00 00 ff 00:11:45.324 NOP [Abort queued commands]
60 00 01 ff ff ff 4f 00 00:11:42.556 READ FPDMA QUEUED
ef 02 00 00 00 00 00 00 00:11:42.536 SET FEATURES [Enable write cache]
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 3211 -
# 2 Extended offline Completed without error 00% 3211 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.