usb 1-1: New USB device found, idVendor=090c, idProduct=1000
usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-1: Product: USB Flash Disk
usb 1-1: Manufacturer: General
usb 1-1: SerialNumber: 7011010000293265
scsi 2:0:0:0: Direct-Access General USB Flash Disk 1100 PQ: 0 ANSI: 0 CCS
sd 2:0:0:0: [sda] 3932160 512-byte hardware sectors (2013 MB)
sd 2:0:0:0: [sda] Write Protect is off
sd 2:0:0:0: [sda] Assuming drive cache: write through
sd 2:0:0:0: [sda] 3932160 512-byte hardware sectors (2013 MB)
sd 2:0:0:0: [sda] Write Protect is off
sd 2:0:0:0: [sda] Assuming drive cache: write through
sda:<7>usb-storage: queuecommand called
usb 1-1: reset high speed USB device using fsl-ehci and address 4
usb 1-1: USB disconnect, address 4
sd 2:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK
end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
sd 2:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK
end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
ldm_validate_partition_table(): Disk read failed.
sd 2:0:0:0: [sda] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK
end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
unable to read partition table
sd 2:0:0:0: [sda] Attached SCSI removable disk
sd 2:0:0:0: Attached scsi generic sg0 type 0
usb 1-1: new high speed USB device using fsl-ehci and address 5
usb 1-1: configuration #1 chosen from 1 choice
scsi3 : SCSI emulation for USB Mass Storage devices
usb 1-1: New USB device found, idVendor=090c, idProduct=1000
usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-1: Product: USB Flash Disk
usb 1-1: Manufacturer: General
usb 1-1: SerialNumber: 7011010000293265
usb 1-1: USB disconnect, address 5