rendered paste bodyRouterBOOT booter 2.18
RouterBoard 333
CPU frequency: 333 MHz
Memory size: 64 MB
Press any key within 2 seconds to enter setup..
trying bootp protocol.... OK
Got IP address: 192.168.1.181
resolved mac address 00:1E:90:B8:67:6C
Gateway: 192.168.1.75
transfer started ................ transfer ok, time=0.69s
setting up elf image... OK
jumping to kernel code
Memory <- <0x0 0x4000000> (64MB)
CPU clock-frequency <- 0x13de3650 (333MHz)
CPU timebase-frequency <- 0x1fc9f08 (33MHz)
zImage starting: loaded at 0x00490000 (sp: 0x0069efb0)
Allocating 0x445638 bytes for kernel ...
gunzipping (0x00000000 <- 0x0049d000:0x0069d40d)...done 0x42d220 bytes
Linux/PowerPC load: console=ttyS0,115200 board=mpc8323 boot=1
Finalizing device tree... flat tree at 0x6ab300
Using MikroTik RouterBOARD 333/600 series machine description
Linux version 2.6.39-rc6 (alex@motard) (gcc version 4.6.0 (GCC) ) #3 Fri May 6 12:45:35 EEST 2011
bootconsole [udbg0] enabled
Found FSL PCI host bridge at 0x00000000e0008500. Firmware bus number: 0->0
PCI host bridge /pci@e0008500 (primary) ranges:
MEM 0x0000000080000000..0x000000009fffffff -> 0x0000000080000000
IO 0x00000000d0000000..0x00000000d3ffffff -> 0x0000000000000000
Zone PFN ranges:
DMA 0x00000000 -> 0x00004000
Normal empty
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00004000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: console=ttyS0,115200 board=mpc8323 boot=1
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 60492k/65536k available (4144k kernel code, 5044k reserved, 136k data, 93k bss, 1644k init)
Kernel virtual memory layout:
* 0xfffdf000..0xfffff000 : fixmap
* 0xfcef8000..0xfe000000 : early ioremap
* 0xc5000000..0xfcef8000 : vmalloc & ioremap
NR_IRQS:512 nr_irqs:512 16
IPIC (128 IRQ sources) at c5000700
clocksource: timebase mult[78004ea] shift[22] registered
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
devtmpfs: initialized
NET: Registered protocol family 16
PCI: Probing PCI hardware
bio: create slab <bio-0> at 0
SCSI subsystem initialized
Freescale Elo / Elo Plus DMA driver
Switching to clocksource timebase
Switched to NOHz mode on CPU #0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
fsl-elo-dma e00082a8.dma: #0 (fsl,elo-dma-channel), irq 71
fsl-elo-dma e00082a8.dma: #1 (fsl,elo-dma-channel), irq 71
fsl-elo-dma e00082a8.dma: #2 (fsl,elo-dma-channel), irq 71
fsl-elo-dma e00082a8.dma: #3 (fsl,elo-dma-channel), irq 71
WDT driver for MPC8xxx initialized. mode:reset timeout=65535 (-65536 seconds)
JFFS2 version 2.2 (NAND) (ZLIB) (RTIME) (c) 2001-2006 Red Hat, Inc.
msgmni has been set to 118
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xe0004500 (irq = 16) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Freescale QUICC Engine UART device driver
Generic RTC Driver v1.07
rbppc_nand_probe: MikroTik RouterBOARD 333/600 series NAND driver, version 0.0.2
NAND device: Manufacturer ID: 0xad, Chip ID: 0x76 (Hynix NAND 64MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 2 MTD partitions on "NAND 64MiB 3,3V 8-bit":
0x000000000000-0x000000400000 : "kernel"
0x000000400000-0x000004000000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
split_squashfs: no squashfs found in "NAND 64MiB 3,3V 8-bit"
fsl_spi e0100500.spi: at 0xc508c500 (irq = 18), CPU mode
fsl_spi e01004c0.spi: at 0xc50904c0 (irq = 19), CPU mode
Fixed MDIO Bus: probed
Error: Driver 'mdio-gpio' is already registered, aborting...
ucc_geth: QE UCC Gigabit Ethernet Controller
ucc_geth: UCC3 at 0xe0102200 (irq = 34)
ucc_geth: UCC4 at 0xe0103200 (irq = 35)
ucc_geth: UCC2 at 0xe0103000 (irq = 17)
Freescale PowerQUICC MII Bus: probed
TCP cubic registered
NET: Registered protocol family 17
Freeing unused kernel memory: 1644k init
- preinit -
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
- init -
Please press Enter to activate this console.
BusyBox v1.18.4 (2011-05-05 16:09:01 EEST) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
ATTITUDE ADJUSTMENT (bleeding edge, r26827) ----------
* 1/4 oz Vodka Pour all ingredents into mixing
* 1/4 oz Gin tin with ice, strain into glass.
* 1/4 oz Amaretto
* 1/4 oz Triple sec
* 1/4 oz Peach schnapps
* 1/4 oz Sour mix
* 1 splash Cranberry juice
-----------------------------------------------------
root@OpenWrt:/#