rendered paste body Booting 'OpenWrt'
root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
kernel /boot/vmlinuz block2mtd.block2mtd=/dev/sda2,131072,rootfs root=/dev/mtd
block0 rootfstype=jffs2 rootwait console=ttyS0,38400n8 noinitrd reboot=bios
[Linux-bzImage, setup=0x3a00, size=0xdbec0]
boot
Linux version 2.6.38.5 (alex@motard) (gcc version 4.6.0 (GCC) ) #1 Tue May 3 17:19:26 EEST 2011
BIOS-provided physical RAM map:
BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
BIOS-e801: 0000000000100000 - 0000000008000000 (usable)
Notice: NX (Execute Disable) protection missing in CPU!
DMI not present or invalid.
last_pfn = 0x8000 max_arch_pfn = 0x100000
init_memory_mapping: 0000000000000000-0000000008000000
128MB LOWMEM available.
mapped low ram: 0 - 08000000
low ram: 0 - 08000000
Zone PFN ranges:
DMA 0x00000010 -> 0x00001000
Normal 0x00001000 -> 0x00008000
Movable zone start PFN for each node
early_node_map[2] active PFN ranges
0: 0x00000010 -> 0x0000009f
0: 0x00000100 -> 0x00008000
Using APIC driver default
No local APIC present or hardware disabled
APIC: disable apic facility
APIC: switched to apic NOOP
Allocating PCI resources starting at 8000000 (gap: 8000000:f8000000)
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32399
Kernel command line: block2mtd.block2mtd=/dev/sda2,131072,rootfs root=/dev/mtdblock0 rootfstype=jffs2 rootwait console=ttyS0,38400n8 noinitrd reboot=bios
PID hash table entries: 512 (order: -1, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Initializing CPU#0
Memory: 127184k/131072k available (1383k kernel code, 3436k reserved, 474k data, 180k init, 0k highmem)
virtual kernel memory layout:
fixmap : 0xfffa3000 - 0xfffff000 ( 368 kB)
vmalloc : 0xc8800000 - 0xfffa1000 ( 887 MB)
lowmem : 0xc0000000 - 0xc8000000 ( 128 MB)
.init : 0xc11d1000 - 0xc11fe000 ( 180 kB)
.data : 0xc1159c16 - 0xc11d04f0 ( 474 kB)
.text : 0xc1000000 - 0xc1159c16 (1383 kB)
Checking if this processor honours the WP bit even in supervisor mode...Ok.
NR_IRQS:288
console [ttyS0] enabled
Fast TSC calibration using PIT
Detected 266.647 MHz processor.
Calibrating delay loop (skipped), value calculated using timer frequency.. 533.29 BogoMIPS (lpj=2666470)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: NSC Unknown stepping 01
Performance Events:
devtmpfs: initialized
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfc3ad, last bus=0
PCI: Using configuration type 1 for base access
bio: create slab <bio-0> at 0
SCSI subsystem initialized
PCI: Probing PCI hardware
Switching to clocksource pit
pci 0000:00:0e.0: BAR 6: assigned [mem 0x08000000-0x0800ffff pref]
pci 0000:00:12.5: BAR 1: assigned [mem 0x08010000-0x0801003f]
pci 0000:00:12.5: BAR 1: set to [mem 0x08010000-0x0801003f] (PCI address [0x8010000-0x801003f])
pci 0000:00:12.5: BAR 2: assigned [mem 0x08010040-0x0801007f]
pci 0000:00:12.5: BAR 2: set to [mem 0x08010040-0x0801007f] (PCI address [0x8010040-0x801007f])
pci 0000:00:12.5: BAR 3: assigned [mem 0x08010080-0x080100bf]
pci 0000:00:12.5: BAR 3: set to [mem 0x08010080-0x080100bf] (PCI address [0x8010080-0x80100bf])
pci 0000:00:12.5: BAR 4: assigned [mem 0x080100c0-0x080100ff]
pci 0000:00:12.5: BAR 4: set to [mem 0x080100c0-0x080100ff] (PCI address [0x80100c0-0x80100ff])
pci 0000:00:12.5: BAR 5: assigned [mem 0x08010100-0x0801013f]
pci 0000:00:12.5: BAR 5: set to [mem 0x08010100-0x0801013f] (PCI address [0x8010100-0x801013f])
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
platform rtc_cmos: registered platform RTC device (no PNP device found)
scx200: NatSemi SCx200 Driver
scx200: GPIO base 0xf400
scx200: Configuration Block base 0x9000
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
msgmni has been set to 248
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a NS16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a NS16550A
Non-volatile memory driver v1.3
scsi0 : sc1200
scsi1 : sc1200
ata1: PATA max UDMA/33 cmd 0x1f0 ctl 0x3f6 bmdma 0xfc00 irq 14
ata2: PATA max UDMA/33 cmd 0x170 ctl 0x376 bmdma 0xfc08 irq 15
ata1.00: CFA: HYPERSTONE FLASH DISK, 30/06/03, max PIO2
ata1.00: 253952 sectors, multi 0: LBA
ata1.00: configured for PIO2
scsi 0:0:0:0: Direct-Access ATA HYPERSTONE FLASH 30/0 PQ: 0 ANSI: 5
sd 0:0:0:0: [sda] 253952 512-byte logical blocks: (130 MB/124 MiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
sda: sda1 sda2
sd 0:0:0:0: [sda] Attached SCSI removable disk
Creating 1 MTD partitions on "rootfs":
0x000000000000-0x000003020000 : "rootfs"
split_squashfs: no squashfs found in "rootfs"
block2mtd: mtd0: [rootfs] erase_size = 128KiB [131072]
natsemi dp8381x driver, version 2.1, Sept 11, 2006
originally by Donald Becker <becker@scyld.com>
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
natsemi eth0: NatSemi DP8381[56] at 0x80000000 (0000:00:0e.0), 00:0d:b9:01:3c:28, IRQ 10, port TP.
rtc_cmos rtc_cmos: rtc core: registered rtc_cmos as rtc0
rtc0: alarms up to one day, 114 bytes nvram
geodewdt: No timers were available
sc520_wdt: WDT driver for SC520 initialised. timeout=30 sec (nowayout=0)
sc1200wdt: build 20020303
sc1200wdt: io parameter must be specified
scx200_wdt: timer margin 60 seconds
cpuidle: using governor ladder
cpuidle: using governor menu
enabling scx200 high-res timer (1 MHz +0 ppm)
Switching to clocksource scx200_hrt
cs5535-clockevt: Could not allocate MFPGT timer
Switched to NOHz mode on CPU #0
TCP westwood registered
NET: Registered protocol family 17
Using IPI Shortcut mode
rtc_cmos rtc_cmos: setting system clock to 2000-01-01 00:00:13 UTC (946684813)
Switching to clocksource tsc
jffs2_scan_eraseblock(): End of filesystem marker found at 0x140000
jffs2_build_filesystem(): unlocking the mtd device... done.
jffs2_build_filesystem(): erasing all blocks after the end marker... done.
JFFS2 notice: (1) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.
VFS: Mounted root (jffs2 filesystem) readonly on device 31:0.
devtmpfs: mounted
Freeing unused kernel memory: 180k freed
- preinit -
Press the [f] key and hit [enter] to enter failsafe mode
Clocksource tsc unstable (delta = -58328929411 ns)
Switching to clocksource scx200_hrt
- regular preinit -
- init -
Please press Enter to activate this console. eth0: DSPCFG accepted after 0 usec.
eth0: link up.
eth0: Setting full-duplex based on negotiated link capability.
sc520_wdt: Watchdog timer is now enabled.
sc520_wdt: Watchdog timer is now enabled.
BusyBox v1.18.4 (2011-05-03 16:57:16 EEST) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
ATTITUDE ADJUSTMENT (bleeding edge, r26806) ----------
* 1/4 oz Vodka Pour all ingredents into mixing
* 1/4 oz Gin tin with ice, strain into glass.
* 1/4 oz Amaretto
* 1/4 oz Triple sec
* 1/4 oz Peach schnapps
* 1/4 oz Sour mix
* 1 splash Cranberry juice
-----------------------------------------------------
root@OpenWrt:/#