rendered paste bodyU-Boot 1.1.4 (Mar 3 2008 - 16:51:36)
U-Boot code: 00000000 -> 0001A410 BSS: -> 0001F354
IRQ Stack: 00e6ff7c
FIQ Stack: 00e6ef7c
RAM Configuration:
Bank #0: 00000000 32 MB
Flash Manufacturer: Unknown(0x1c)
Flash: 0 kB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
PLL clock at 250MHz
CPU clock at 250MHz
AHB clock at 125MHz
APB clock at 62MHz
Hit any key to stop autoboot: 3
kernel:30060000-301e0000
0
Star Equuleus # setenv serverip 192.168.1.254; setenv ipaddr 192.168.1.1
Star Equuleus # tftp 0x1000000 openwrt-cns21xx-ns-k330-zImage-initramfs; go 0x1000000
Check Link Status .....Up
Waiting 3 seconds ..
TFTP from server 192.168.1.254; our IP address is 192.168.1.1
Filename 'openwrt-cns21xx-ns-k330-zImage-initramfs'.
Load address: 0x1000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################
done
Bytes transferred = 1832544 (1bf660 hex)
## Starting application at 0x01000000 ...
Uncompressing Linux... done, booting the kernel.
Linux version 2.6.37-rc7 (juhosg@idared) (gcc version 4.3.5 (GCC) ) #1 Wed Dec 29 11:05:24 CET 2010
CPU: FA526 [66015261] revision 1 (ARMv4), cr=0000397f
CPU: VIVT data cache, VIVT instruction cache
Machine: NS-K330 NAS
Ignoring unrecognised tag 0x00000000
Memory policy: ECC disabled, Data cache writeback
pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768
pcpu-alloc: [0] 0
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: console=ttyS0,38400 rootfstype=squashfs,jffs2 noinitrd
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 27232k/27232k available, 5536k reserved, 0K highmem
Virtual kernel memory layout:
vector : 0xffff0000 - 0xffff1000 ( 4 kB)
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
DMA : 0xffc00000 - 0xffe00000 ( 2 MB)
vmalloc : 0xc2800000 - 0xd0000000 ( 216 MB)
lowmem : 0xc0000000 - 0xc2000000 ( 32 MB)
modules : 0xbf000000 - 0xc0000000 ( 16 MB)
.init : 0xc0008000 - 0xc02c9000 (2820 kB)
.text : 0xc02c9000 - 0xc04f8000 (2236 kB)
.data : 0xc04f8000 - 0xc05090a0 ( 69 kB)
NR_IRQS:96
Calibrating delay loop... 191.69 BogoMIPS (lpj=958464)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
msgmni has been set to 53
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x78000000 (irq = 9) is a 16550A
console [ttyS0] enabled
m25p80 spi0.0: found en25p32, expected m25p80
m25p80 spi0.0: en25p32 (4096 Kbytes)
Creating 5 MTD partitions on "spi0.0":
0x000000000000-0x000000040000 : "boot"
0x000000040000-0x000000060000 : "config"
0x000000060000-0x000000160000 : "kernel"
0x000000160000-0x0000003f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
split_squashfs: no squashfs found in "spi0.0"
0x000000060000-0x0000003f0000 : "firmware"
cns21xx-spi cns21xx-spi: iomem at 71000000
net eth0: Internal PHY
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Freeing init memory: 2820K
input: gpio-keys as /devices/platform/gpio-keys/input/input0
Button Hotplug driver version 0.4.1
- preinit -
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
- preinit ip deconfig -
- init -
Please press Enter to activate this console. device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering forwarding state
br-lan: port 1(eth0) entering forwarding state
net eth0: link up (100Mbps/Full duplex)
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
cns21xx-ehci cns21xx-ehci: cns21xx-ehci
cns21xx-ehci cns21xx-ehci: new USB bus registered, assigned bus number 1
cns21xx-ehci cns21xx-ehci: irq 24, io mem 0xcc000000
cns21xx-ehci cns21xx-ehci: USB 2.0 started, EHCI 1.00
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
nf_conntrack version 0.5.0 (469 buckets, 1876 max)
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
cns21xx-ohci cns21xx-ohci: cns21xx-ohci
cns21xx-ohci cns21xx-ohci: new USB bus registered, assigned bus number 2
cns21xx-ohci cns21xx-ohci: irq 23, io mem 0xc4000000
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usb 2-1: new full speed USB device using cns21xx-ohci and address 2
usb 2-1: not running at top speed; connect to a high speed hub
scsi0 : usb-storage 2-1:1.0
scsi 0:0:0:0: Direct-Access Kingston DataTraveler 2.0 1.00 PQ: 0 ANSI: 2
sd 0:0:0:0: [sda] 7856128 512-byte logical blocks: (4.02 GB/3.74 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Assuming drive cache: write through
sda: sda1
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] Attached SCSI removable disk
BusyBox v1.17.3 (2010-12-27 13:46:44 CET) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
KAMIKAZE (bleeding edge, r24843) ------------------
* 10 oz Vodka Shake well with ice and strain
* 10 oz Triple sec mixture into 10 shot glasses.
* 10 oz lime juice Salute!
---------------------------------------------------
root@OpenWrt:/#