rendered paste body
Sun Cobalt - Smaller, Bluer, Better, and Free
Firmware version 2.10.3-ext3
Current date: May 04 09:03:43 UTC 2004
ROM build info: Thu Mar 11 08:51:36 MST 2004 .
System serial number: invalid csum!
System type: 3000 series system, Version 1 board
Silicon serial number: 24000007661c3d01
Monitor: 153536 bytes
Memory: 256 MB
CPU: 1 processor(s) detected
CPU 0: AuthenticAMD 447MHz (4.5 x 100MHz host bus) [BSP]
Initializing flash: done
Flash Bank 0: AMD AM29F080B 1024KB (01:d5)
Flash Bank 1: not installed.
Mounting ROM fs: done
Initializing PCI: done
Initializing ethernet: 2 controller(s) found
Initializing IDE: found ALI M5229 at 00:78
scanning ide0: master
scanning ide1:
IDE: stabilizing spinup: 100%
Checking Memory: done
Press spacebar to enter ROM mode
First stage kernel (Linux): Decompressing - done
Second stage kernel: Decompressing - done
Linux version 2.6.16-gentoo-r9 (root@localhost) (gcc version 3.4.6 (Gentoo 3.4.6-r1, ssp-3.4.5-1.0, pie-8.7.9)) #1 PREEMPT Tue
Sep 26 05:54:39 Local time zone must be set--see
BIOS-provided physical RAM map:
BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
BIOS-e801: 0000000000100000 - 0000000010000000 (usable)
256MB LOWMEM available.
DMI not present or invalid.
Allocating PCI resources starting at 20000000 (gap: 10000000:f0000000)
Built 1 zonelists
Kernel command line: console=ttyS0,115200 ip=off
Initializing CPU#0
PID hash table entries: 2048 (order: 11, 32768 bytes)
Detected 448.238 MHz processor.
Using tsc for high-res timesource
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 256632k/262144k available (1851k kernel code, 5036k reserved, 440k data, 128k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 897.58 BogoMIPS (lpj=1795177)
Mount-cache hash table entries: 512
CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
CPU: L2 Cache: 128K (32 bytes/line)
CPU: AMD-K6(tm)-III Processor stepping 04
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: Using configuration type 1
Linux Plug and Play Support v0.97 (c) Adam Belay
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Probing PCI hardware
PCI quirk: region 0c80-0c9f claimed by ali7101 SMB
PCI: Bridge: 0000:00:01.0
IO window: disabled.
MEM window: disabled.
PREFETCH window: disabled.
io scheduler noop registered
io scheduler deadline registered (default)
Activating ISA DMA hang workarounds.
Real Time Clock Driver v1.12ac
Non-volatile memory driver v1.2
alim7101_wdt: Steve Hill <steve@navaho.co.uk>.
alim7101_wdt: WDT driver for ALi M7101 initialised. timeout=30 sec (nowayout=0)
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
PNP: No PS/2 controller found. Probing ports directly.
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
mice: PS/2 mouse device common for all mice
e100: Intel(R) PRO/100 Network Driver, 3.5.10-k2-NAPI
e100: Copyright(c) 1999-2005 Intel Corporation
e100: Modified by <jeff@404ster.com> to ignore bad EEPROM checksums
e100: 0000:00:10.0: e100_eeprom_load: EEPROM corrupted, ignoring and moving on
e100: 0000:00:10.0: e100_eeprom_load: Caclulated Checksum: 678B
e100: 0000:00:10.0: e100_eeprom_load: EEPROM Checksum: 0
e100: eth0: e100_probe: addr 0xf7ffc000, irq 11, MAC addr 00:10:E0:02:4F:40
e100: 0000:00:12.0: e100_eeprom_load: EEPROM corrupted, ignoring and moving on
e100: 0000:00:12.0: e100_eeprom_load: Caclulated Checksum: 668B
e100: 0000:00:12.0: e100_eeprom_load: EEPROM Checksum: 0
e100: eth1: e100_probe: addr 0xf7fbf000, irq 10, MAC addr 00:10:E0:02:4F:41
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller at PCI slot 0000:00:0f.0
ALI15X3: chipset revision 193
ALI15X3: 100% native mode on irq 14
ide0: BM-DMA at 0xfdd0-0xfdd7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xfdd8-0xfddf, BIOS settings: hdc:DMA, hdd:DMA
hda: WDC WD3200JB-00KFA0, ATA DISK drive
ide0 at 0xfdf8-0xfdff,0xfdf6 on irq 14
hda: max request size: 128KiB
hda: cannot use LBA48 DMA - PIO mode will be used for accessing sectors > 268435456
hda: 625142448 sectors (320072 MB) w/8192KiB Cache, CHS=38913/255/63, (U)DMA
hda: cache flushes supported
hda: hda1 hda2 hda3 hda4
sym0: <875> rev 0x4 at pci 0000:00:0e.0 irq 12
sym0: No NVRAM, ID 7, Fast-20, SE, parity checking
sym0: SCSI BUS has been reset.
scsi0 : sym-2.2.2
st: Version 20050830, fixed bufsize 32768, s/g segs 256
usbmon: debugfs is not available
ohci_hcd 0000:00:02.0: OHCI Host Controller
ohci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:02.0: irq 6, io mem 0xf7fff000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 16384 bytes)
TCP established hash table entries: 16384 (order: 4, 65536 bytes)
TCP bind hash table entries: 16384 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 16384 bind 16384)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
Cobalt system type is Pacifica
Cobalt Networks LED driver 1.0 (modified by jeff@404ster.com)
Cobalt Networks LCD driver 4.0 (modified by jeff@404ster.com)
Cobalt Networks Serial Number driver 1.6 (modified by jeff@404ster.com)
Cobalt Networks Watchdog Timer driver 1.0 (modified by jeff@404ster.com)
Cobalt Networks Sensor driver 1.0 (modified by jeff@404ster.com)
Cobalt Networks RAM Info driver 1.0 (modified by jeff@404ster.com)
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 128k freed
kjournald starting. Commit interval 5 seconds
INIT: version 2.86 booting
Gentoo Linux; http://www.gentoo.org/
Copyright 1999-2005 Gentoo Foundation; Distributed under the GPLv2
* Mounting proc at /proc ... [ ok ]
* Mounting sysfs at /sys ... [ ok ]
* Mounting /dev for udev ... [ ok ]
* Populating /dev with saved device nodes ... [ ok ]
* Setting up proper hotplug agent ... [ ok ]
* Using netlink for hotplug events... [ ok ]
* Starting udevd ... [ ok ]
* Populating /dev with existing devices through uevents ... [ ok ]
* Letting udev process events ... [ ok ]
* Finalizing udev configuration ... [ ok ]
* Mounting devpts at /dev/pts ... [ ok ]
* Activating (possible) swap ...Adding 996020k swap on /dev/hda2. Priority:-1 extents:1 across:996020k [ ok ]
* Checking root filesystem .../dev/hda1: clean, 236265/3129344 files, 664040/6249277 blocks [ ok ]
* Remounting root filesystem read/write ... [ ok ]
* Setting hostname to localhost ... [ ok ]
* Calculating module dependencies ... [ ok ]
* Checking all filesystems ... [ ok ]
* Mounting local filesystems ... [ ok ]
* Activating (possibly) more swap ... [ ok ]
* Setting system clock using the hardware clock [UTC] ... [ ok ]
* Configuring kernel parameters ... [ ok ]
* Updating environment ... [ ok ]
* Cleaning /var/lock, /var/run ... [ ok ]
* Cleaning /tmp directory ... [ ok ]
* Caching service dependencies ... [ ok ]
* Caching service dependencies ... [ ok ]
* Caching service dependencies ... [ ok ]
* Starting lo
* Bringing up lo ... [ ok ]
* Initializing random number generator ... [ ok ]
INIT: Entering runlevel: 3
* Caching service dependencies ... [ ok ]
* Mounting network filesystems ... [ ok ]
* Starting local ... [ ok ]
This is localhost.(none) (Linux i586 2.6.16-gentoo-r9) 09:06:22
localhost login: