Sun Cobalt - Smaller, Bluer, Better
Firmware version 2.10.1
ROM kernel 2.4.19C5 (XFS + ext3)
Current date: Apr 28 18:15:16 UTC 2004
ROM build info: Tue Mar 11 13:05:33 MST 2003 rom.cobalt.sun.com
System serial number: invalid csum!
System type: 3000 series system, Version 1 board
Silicon serial number: 24000007661c3d01
Monitor: 154752 bytes
Memory: 256 MB
CPU: 1 processor(s) detected
CPU 0: AuthenticAMD 448MHz (4.5 x 100MHz host bus) [BSP]
Initializing flash: done
Flash Bank 0: AMD AM29F080B 1024KB (01:d5)
Flash Bank 1: not installed.
Mounting ROM fs: done
Initializing PCI: done
Initializing ethernet: 2 controller(s) found
Initializing IDE: found ALI M5229 at 00:78
scanning ide0:
scanning ide1: Checking Memory: done
Press spacebar to enter ROM mode
Cobalt:Main Menu> bfn
First stage kernel (Linux): Decompressing - done
Linux version 2.4.19C5_ROM (root@purpleguy) (gcc version 2.96 20000731 (Red Hat Linux 7.2 2.96-108.7.2)) #1 Fri Feb3
BIOS-provided physical RAM map:
BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
BIOS-e801: 0000000000100000 - 0000000010000000 (usable)
0MB HIGHMEM available.
256MB LOWMEM available.
On node 0 totalpages: 65536
zone(0): 4096 pages.
zone(1): 61440 pages.
zone(2): 0 pages.
Kernel command line: console=ttyS0,115200 ip=on root=/dev/nfs nfsroot=/nfsroot-x86,rsize=8192
Initializing CPU#0
Detected 448.219 MHz processor.
Calibrating delay loop... 894.56 BogoMIPS
Memory: 254056k/262144k available (1453k kernel code, 5652k reserved, 245k data, 100k init, 0k highmem)
Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
Enabling new style K6 write allocation for 256 Mb
CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
CPU: L2 Cache: 128K (32 bytes/line)
CPU: AMD-K6(tm)-III Processor stepping 04
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: AMD K6
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 1: assuming transparent
Unknown bridge resource 2: assuming transparent
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
SGI XFS snapshot 2.4.19-2002-08-03_04:15_UTC with no debug enabled
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
Non-volatile memory driver v1.2
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller on PCI bus 00 dev 78
ALI15X3: chipset revision 193
ALI15X3: 100% native mode on irq 14
ide0: BM-DMA at 0xfdd0-0xfdd7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xfdd8-0xfddf, BIOS settings: hdc:DMA, hdd:DMA
loop: loaded (max 8 devices)
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.24 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
eth0: Invalid EEPROM checksum 0x532f, check settings before activating this device!
eth0: PCI device 8086:1209, 00:10:E0:02:4F:40, IRQ 11.
Receiver lock-up bug exists -- enabling work-around.
Board assembly 000000-000, Physical connectors present:
Primary interface chip None PHY #0.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0xdbd8681d).
Receiver lock-up workaround activated.
eth1: Invalid EEPROM checksum 0x542f, check settings before activating this device!
eth1: PCI device 8086:1209, 00:10:E0:02:4F:41, IRQ 10.
Receiver lock-up bug exists -- enabling work-around.
Board assembly 000000-000, Physical connectors present:
Primary interface chip None PHY #0.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0xdbd8681d).
Receiver lock-up workaround activated.
md: linear personality registered as nr 1
md: raid0 personality registered as nr 2
md: raid1 personality registered as nr 3
md: raid5 personality registered as nr 4
raid5: measuring checksumming speed
8regs : 617.600 MB/sec
32regs : 352.400 MB/sec
pII_mmx : 836.000 MB/sec
p5_mmx : 820.800 MB/sec
raid5: using function: pII_mmx (836.000 MB/sec)
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
Sending DHCP and RARP requests ., OK
IP-Config: Got DHCP answer from 10.0.0.60, my address is 10.0.0.85
IP-Config: Complete:
device=eth0, addr=10.0.0.85, mask=255.255.255.0, gw=10.0.0.1,
host=cobalt, domain=, nis-domain=(none),
bootserver=10.0.0.60, rootserver=10.0.0.60, rootpath=/nfsroot-x86
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
Looking up port of RPC 100003/2 on 10.0.0.60
Looking up port of RPC 100005/1 on 10.0.0.60
VFS: Mounted root (nfs filesystem).
Freeing unused kernel memory: 100k freed
INIT: version 2.86 booting
Gentoo Linux; http://www.gentoo.org/
Copyright 1999-2005 Gentoo Foundation; Distributed under the GPLv2
* Mounting proc at /proc ... [ ok ]
* Activating (possible) swap ... [ ok ]
* Remounting root filesystem read/write ... [ ok ]
* Skipping /etc/mtab initialization (ro root?)
* Setting hostname to localhost ... [ ok ]
* Checking all filesystems ... [ ok ]
* Mounting local filesystems ...mount: wrong fs type, bad option, bad superblock on shm,
missing codepage or other error
In some cases useful info is found in syslog - try
dmesg | tail or so
* Some local filesystem failed to mount
[ !! ]
* Activating (possibly) more swap ... [ ok ]
* Setting system clock using the hardware clock [UTC] ... [ ok ]
* Configuring kernel parameters ... [ ok ]
* Skipping /var and /tmp initialization (ro root?)
* Caching service dependencies ... [ ok ]
* Caching service dependencies ... [ ok ]
* Skipping /var/run/utmp initialization (ro root?)
* Caching service dependencies ... [ ok ]
Couldnt get a file descriptor referring to the console
* Loading key mappings ...Couldnt get a file descriptor referring to the console
* Error loading key mappings
[ !! ]
Couldnt get a file descriptor referring to the console
Couldnt get a file descriptor referring to the console
* Setting terminal encoding to UTF-8 .../etc/init.d/keymaps: line 73: /dev/tty1: No such device
/etc/init.d/keymaps: line 73: /dev/tty2: No such device
/etc/init.d/keymaps: line 73: /dev/tty3: No such device
/etc/init.d/keymaps: line 73: /dev/tty4: No such device
/etc/init.d/keymaps: line 73: /dev/tty5: No such device
/etc/init.d/keymaps: line 73: /dev/tty6: No such device
/etc/init.d/keymaps: line 73: /dev/tty7: No such device
/etc/init.d/keymaps: line 73: /dev/tty8: No such device
/etc/init.d/keymaps: line 73: /dev/tty9: No such device
/etc/init.d/keymaps: line 73: /dev/tty10: No such device
/etc/init.d/keymaps: line 73: /dev/tty11: No such device
[ ok ]
* Setting user font ...Couldnt open //dev/tty1
Couldnt open //dev/tty2
Couldnt open //dev/tty3
Couldnt open //dev/tty4
Couldnt open //dev/tty5
Couldnt open //dev/tty6
Couldnt open //dev/tty7
Couldnt open //dev/tty8
Couldnt open //dev/tty9
Couldnt open //dev/tty10
Couldnt open //dev/tty11
* Failed to set user font
[ !! ]
* Starting lo
* Bringing up lo ... [ ok ]
* Initializing random number generator ... [ ok ]
INIT: Entering runlevel: 3
* Caching service dependencies ... [ ok ]
* Mounting network filesystems ... [ ok ]
* Starting local ... [ ok ]
INIT: Id "c1" respawning too fast: disabled for 5 minutes
INIT: Id "c2" respawning too fast: disabled for 5 minutes
INIT: Id "c3" respawning too fast: disabled for 5 minutes
INIT: Id "c4" respawning too fast: disabled for 5 minutes
INIT: Id
INIT: Id "c6" respawning too fast: disabled for 5 minutes
INIT: no more processes left in this runlevel