Firmware Version 5.0
Duplex Console IO Dependent Code (IODC) revision 1
------------------------------------------------------------------------------
(c) Copyright 1995-2000, Hewlett-Packard Company, All rights reserved
------------------------------------------------------------------------------
Processor Speed State Coprocessor State I/D Cache
--------- -------- --------------------- ----------------- -------------
0 552 MHz Active Functional 512 kB/1 MB
1 552 MHz Idle Functional 512 kB/1 MB
Central Bus Speed: 120 MHz
Available memory: 4294967296 bytes
Good memory required: 36073472 bytes
Primary boot path: FWSCSI.6.0
Alternate boot path: FWSCSI.5.0
Console path: SERIAL_1.9600.8.none
Keyboard path: USB
CPU 0
NOTICE : Processor self-tests have been disabled because FASTBOOT is
enabled. To enable self-tests, disable FASTBOOT with the FASTBOOT
command in the CONFIGURATION menu and reboot the system.
NOTICE : Memory has been initialized but not tested because FASTBOOT is
enabled. To test memory, disable FASTBOOT with the FASTBOOT
command in the CONFIGURATION menu and reboot the system.
CPU 1
NOTICE : Processor self-tests have been disabled because FASTBOOT is
enabled. To enable self-tests, disable FASTBOOT with the FASTBOOT
command in the CONFIGURATION menu and reboot the system.
Processor is booting from first available device.
To discontinue, press any key within 10 seconds.
10 seconds expired.
Proceeding...
Searching for device(s) with bootable media...
This may take several minutes.
To discontinue search, press any key (termination may not be immediate).
Attempting to boot Primary Path...
BOOTABLE DEVICE FOUND:
Path Number Device Path Device Type and Utilities
----------- ----------------- -------------------------
P0 FWSCSI.6.0 QUANTUM ATLAS10K-18LVD
IPL
Booting...
Boot IO Dependent Code (IODC) revision 0
HARD Booted.
ISL Revision A.00.43 Apr 12, 2000
ISL booting hpux
Boot
: disk(10/0/15/1.6.0.0.0.0.0;0)/stand/vmunix
10862592 + 2093056 + 1302736 start 0x1ece68
gate64: sysvec_vaddr = 0xc0002000 for 2 pages
NOTICE: nfs3_link(): File system was registered at index 3.
NOTICE: autofs_link(): File system was registered at index 6.
NOTICE: cachefs_link(): File system was registered at index 7.
System Console is on the Built-In Serial Interface
Logical volume 64, 0x3 configured as ROOT
Logical volume 64, 0x2 configured as SWAP
Logical volume 64, 0x2 configured as DUMP
Swap device table: (start & size given in 512-byte blocks)
entry 0 - major is 64, minor is 0x2; start = 0, size = 4194304
Starting the STREAMS daemons-phase 1
Checking root file system.
file system is clean - log replay is not required
Root check done.
Create STCP device files
Starting the STREAMS daemons-phase 2
$Revision: vmunix: vw: -proj selectors: CUPI80_BL2000_1108 -c 'Vw for CUPI80_BL2000_1108 build' -- cupi80_bl2000_1108 'CUPI80_BL2000_1108' Wed Nov 8 19:24:56 PST 2000 $
Memory Information:
physical page size = 4096 bytes, logical page size = 4096 bytes
Physical: 4194304 Kbytes, lockable: 3229044 Kbytes, available: 3709560 Kbytes
/sbin/ioinitrc:
/sbin/krs_sysinit:
/sbin/bcheckrc:
Checking for LVM volume groups and Activating (if any exist)
Volume group "/dev/vg00" has been successfully changed.
vxfs fsck: sanity check: root file system OK (mounted read/write)
Checking hfs file systems
/sbin/fsclean: /dev/vg00/lvol1 (mounted) ok
HFS file systems are OK, not running fsck
Checking vxfs file systems
/dev/vg00/lvol3 :
vxfs fsck: sanity check: root file system OK (mounted read/write)
Cleaning /etc/ptmp...
(c)Copyright 1983-2000 Hewlett-Packard Co., All Rights Reserved.
(c)Copyright 1979, 1980, 1983, 1985-1993 The Regents of the Univ. of California
(c)Copyright 1980, 1984, 1986 Novell, Inc.
(c)Copyright 1986-1992 Sun Microsystems, Inc.
(c)Copyright 1985, 1986, 1988 Massachusetts Institute of Technology
(c)Copyright 1989-1993 The Open Software Foundation, Inc.
(c)Copyright 1986 Digital Equipment Corp.
(c)Copyright 1990 Motorola, Inc.
(c)Copyright 1990, 1991, 1992 Cornell University
(c)Copyright 1989-1991 The University of Maryland
(c)Copyright 1988 Carnegie Mellon University
(c)Copyright 1991-2000 Mentat Inc.
(c)Copyright 1996 Morning Star Technologies, Inc.
(c)Copyright 1996 Progressive Systems, Inc.
(c)Copyright 1991-2000 Isogon Corporation, All Rights Reserved.
RESTRICTED RIGHTS LEGEND
Use, duplication, or disclosure by the U.S. Government is subject to
restrictions as set forth in sub-paragraph (c)(1)(ii) of the Rights in
Technical Data and Computer Software clause in DFARS 252.227-7013.
Hewlett-Packard Company
3000 Hanover Street
Palo Alto, CA 94304 U.S.A.
Rights for non-DOD U.S. Government Departments and Agencies are as set
forth in FAR 52.227-19(c)(1,2).
/sbin/auto_parms: DHCP access is disabled (see /etc/auto_parms.log)
.*s1^i
HP-UX Start-up in progress
__________________________
Configure system crash dumps ........................................ OK
VxVM device node check .............................................. OK
VxVM general startup ................................................ OK
VxVM reconfiguration recovery ....................................... OK
Mount file systems .................................................. OK
Update kernel and loadable modules .................................. N/A
Initialize loadable modules ......................................... OK
Setting hostname .................................................... OK
Start Kernel Logging facility ....................................... N/A
Set privilege group ................................................. N/A
Display date ........................................................ N/A
Copy processor logs to /var/tombstones .............................. OK
Save system crash dump if needed .................................... N/A
Enable auxiliary swap space ......................................... OK
Start syncer daemon ................................................. OK
Configure Loopback interfaces (lo0) ................................. OK
VxVM volume recovery start .......................................... OK
Configuring all unconfigured software filesets ...................... OK
Recover editor crash files .......................................... OK
Clean UUCP .......................................................... OK
List and/or clear temporary files ................................... OK
Clean up old log files .............................................. OK
Start system message logging daemon ................................. OK
Start pty allocator daemon .......................................... OK
Configuring OLA/R interface ......................................... N/A
Start network tracing and logging daemon ............................ OK
Configure HP igelan Gigabit Ethernet interfaces ..................... OK
Configure HP iether Gigabit Ethernet interfaces ..................... OK
Configure HP Gigabit Ethernet interfaces ............................ OK
Configure HP Ethernet interfaces .................................... OK
Create PCI FDDI device files. ....................................... OK
Configure HP 100BASE-T interfaces ................................... OK
Configure VLAN interfaces ........................................... OK
Configure LAN interfaces ............................................ OK
Start name server daemon ............................................ N/A
Starting HP-UX Secure Shell ......................................... OK
Start NFS core subsystem ............................................ OK
Start NIS+ server subsystem ......................................... OK
Start NIS+ client subsystem ......................................... OK
Start NIS server subsystem .......................................... OK
Start ldap client daemon ............................................ N/A
Start NIS/LDAP server subsystem ..................................... N/A
Start NIS client subsystem .......................................... OK
Start NFS client subsystem .......................................... OK
Start the Trusted Mode with NIS+ subsystem .......................... N/A
Configure pseudo devices for MAC/LLA access ......................... OK
Start multicast routing daemon ...................................... N/A
Start Internet services daemon ...................................... OK
Start dynamic routing daemon ........................................ N/A
Start router discover protocol daemon ............................... N/A
Configuring PPP Interface ........................................... OK
Start RARP protocol daemon .......................................... N/A
Start remote system status daemon ................................... N/A
Configuring man pages for Internet Services ......................... OK
Starting mail daemon ................................................ OK
Starting outbound connection daemons for DDFA software .............. N/A
Start SNMP Master Network Management daemon ......................... OK
Start OSPF MIB Network Management subAgent .......................... N/A
Start SNMP HP-UNIX Network Management subAgent ...................... OK
Start SNMP MIB-2 Network Management subAgent ........................ OK
Start SNMP Trap Dest Network Management subAgent .................... OK
Start DCE daemons ................................................... N/A
Start SNMP PCI FDDI Network Management subAgent ..................... OK
Start RPC daemon if needed .......................................... OK
Start CIM cimserver subsystem ....................................... OK
Start Isogon License Server Daemon .................................. N/A
Initialize Instant Capacity ......................................... N/A
Starting ISEE hpservices mad daemon. ................................ N/A
Start Runner ........................................................ OK
Start remote boot daemon ............................................ N/A
Starting X Font Server at TCP port 7000 ............................. N/A
Start vt daemon ..................................................... OK
Starting kks daemon ................................................. OK
Starting HP EGConvert daemon ........................................ OK
Starting VJE-r daemon ............................................... OK
Starting UDC server ................................................. N/A
Start time synchronization .......................................... N/A
Start accounting .................................................... N/A
Install/Load XF86 DLKM Helper Modules ............................... OK
Starting the password/group assist subsystem ........................ OK
Starting HP Disk Array Manager daemons. ............................. OK
Starting disk array monitor daemons. ................................ OK
Start print spooler ................................................. N/A
Starting HP Distributed Print Service ............................... OK
Start clock daemon .................................................. OK
Start diagnostic subsystem .......................................... OK
Start auditing subsystem ............................................ N/A
Start audio server daemon ........................................... OK
Start Distributed Single Logical Screen daemon ...................... N/A
Start USB hub daemon ................................................ OK
SAM System administration configuration ............................. OK
Starting ObAM Application Server .................................... N/A
Initialize Software Distributor agent daemon ........................ OK
Starting the gWLM Agent ............................................. N/A
Configure HP RAID SA interfaces ..................................... N/A
Copy processor logs to /var/tombstones .............................. OK
Starting Event Monitoring Service ................................... OK
Start EMS SNMP subagent ............................................. OK
Configure HP Fibre Channel Mass Storage interfaces .................. OK
Configure HP Internal RAID interfaces ............................... N/A
Configuring Ultra320 SCSI Mass Storage interfaces ................... N/A
Starting the RST EMS listener ....................................... N/A
Configure HP Fibre Channel Tachyon TL/TS Mass Storage interfaces .... OK
Configuring HP Fibre Channel FCD Mass Storage interfaces ............ OK
VVR - Starting Communication Daemon ................................. N/A
VVR - Starting VRAS daemon .......................................... N/A
VVR - Starting VxRSync daemon ....................................... N/A
Starting VERITAS Enterprise Administrator Service (vxsvc) ........... OK
Start NFS server subsystem .......................................... OK
Start X print server(s) ............................................. N/A
Starting HP-UX Apache-based Web Server .............................. N/A
Starting HP-UX Tomcat-based Servlet Engine .......................... N/A
Starting HP-UX Webmin-based Admin ................................... N/A
Starting the HPUX Webproxy subsystem ................................ N/A
Starting HP-UX XML Web Server Tools ................................. OK
Starting the System Management HomePage server ...................... OK
Start CDE login server .............................................. N/A
Starting PRNGD (Pseudo Random Number Generator Daemon) .............. OK
The system is ready.
GenericSysName [HP Release B.11.11] (see /etc/issue)
Console Login: