[root@lnx3 boot]# dmesg | egrep -i 'sata|hd|ide'
BIOS-provided physical RAM map:
ACPI: IRQ0 used by override.
ACPI: IRQ2 used by override.
ACPI: IRQ9 used by override.
CPU: After generic identify, caps: bfebfbff 20000000 00000000 00000000
CPU: After vendor identify, caps: bfebfbff 20000000 00000000 00000000
PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.2
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Probing IDE interface ide0...
hda: ST380817AS, ATA DISK drive
Probing IDE interface ide1...
Probing IDE interface ide2...
Probing IDE interface ide3...
Probing IDE interface ide4...
Probing IDE interface ide5...
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 1024KiB
hda: 156301488 sectors (80026 MB) w/8192KiB Cache, CHS=16383/255/63
hda: cache flushes supported
hda: hda1 hda2
ide-floppy driver 0.99.newide
ata: 0x1f0 IDE port busy
ata1: SATA max UDMA/133 cmd 0x170 ctl 0x376 bmdma 0xF008 irq 15
ata1: SATA port has no device.
eth0: Identified 8139 chip type 'RTL-8100B/8139D'
EXT3 FS on hda1, internal journal
[root@lnx3 boot]# lspci -v | egrep -i 'ide|sata|hd'
00:1f.2 IDE interface: Intel Corporation 82801EB (ICH5) SATA Controller (rev 02) (prog-if 8a [Master SecP PriP])
[root@lnx3 boot]#